Question about 1993 Oldsmobile Cutlass Supreme

1 Answer

Every time i push on the gas it starts to jolt back and forth and some times it breaks down when im stopped but it always starts right back up

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 107 Answers

Is the car skipping? if so you could have a bad spark plug or plug wire check your plugs the dirty one well be the problem good luck cj

Posted on May 14, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1986 dodge diplomat broke down. just before it did it was riding rough while jolting back and forth from time to time then just lost speed very fast as i pulled over. What could be the issue?


it could be anything , do u have gas , if so how is the pressure , you must get it cked , did your timing belt brake , there are so many things that it could be you have to get someone to look at it to find out , just by posting on here will get you no where

Feb 18, 2015 | 1986 Dodge Diplomat

1 Answer

After warms up dose not run


SOUNDS LIKE YOUR TIMING IS WAAAAAAAY OFF , AMONG OTHERTHINGS !!! YOUR TIMING BELT , MAY NEED REPLACED ! did this just happen or, did it gradually get to this ? your going to kill your engine if you keep going like this !! for now, all I can say is, start tunning your engine, replace spark plugs, plug wires, air & fuel filters, distributor cap / rotor, replace OXYGEN SENSOR, and both the CAM & CRANK sensors !!!!!!!!!!!!! you seriously need to perform all this work, just to see , where the engine is @ this point !!! its not just one thing !!!! and don't drive it until its ok. only then , will we know if or not its the timing belt ! do you understand ????/

Mar 21, 2013 | 1993 Nissan Altima

1 Answer

My 2001 Taurus Sw chugs back in forth when im stopped at a stop light..i have to hold the break and slightly tap the gas to bring rpms up so it will stop. What can cause this problem?


it could be the timing or or could be the fuel injecter need to be cleaned you can get it done at wal mart for about $30 .an it evan be a vac hose that has came lose or a hole in it .

Apr 30, 2011 | 2001 Ford Taurus

1 Answer

Car will not start


maybe the fuel pump went out,or possibly the timing chain,fuel filter

Jan 04, 2010 | 1993 Chrysler New Yorker

2 Answers

I have a 2004 Chrysler Concorde Limited with a 3.5L engine - The car shut off on me as I was driving at 60mph. I coasted to a stop, put the car in park and it started right up. This has happened several...


I had the same issue that has evolved into the car starting and idling for 2-3 seconds then stalling. After doing this five times it won't turn over at all. All the dash lights are on but no turn over. After the car sits for appoximately 15-30 minutes, it starts and runs fine for 3-4 weeks then does it again. I was told this is due to the camshaft and crank position sensors needing replaced.

Jun 23, 2009 | 2004 Chrysler Concorde

1 Answer

I just bought a 1998 jetta vw and it dont seem to idle proper at times seems like she jumps or jolts also when u drive 55 km plus it seems to jump or jolt and every now and then it seems like u can smell...


Hello,
Your particular model is susceptible to ignition lead and spark plugs breaking down, as these items are not the cheapest people tend to overlook them on full services.
Renewing leads and plugs will improve economy and performance no end.
I hope this points you in the right direction?
Paul 'W'
Onyer~EDson(:0 ){#><U.K.
Please remember to rate my assistance!

Jan 22, 2009 | 1998 Volkswagen Jetta

1 Answer

Car kicks back and forth when idling or the gas is applied


It sounds like you have some broken motor mounts under the hood and one of the main ones that break on those models is the torque strut. When my torque strut was bad in my car the car would jolt when I shifted the gears and it would shimmy when it was idling. I would get your motor mounts checked to see if thats the issue and if its not it may be a motor issue such as a misfire which can couse the motor to backfire and idle rough when its misfiring. I hope this works!!!

Jan 17, 2009 | 1995 Saturn Sl

1 Answer

2000 grand cherokee v8 struggles to start and stalls when slowing


i think your exhaust might have a leak which is heating up your oil when this happens the engine suffocates and wants to die.

Dec 02, 2008 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Oldsmobile Cutlass Supreme Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...