Question about 1992 Ford Crown Victoria

1 Answer

1998 grown victoria started running rough after gasing up i went from mid grade to regular then the car runs rough and shaky idle will the c/o2 sensor cause this? sure could use some help

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 50 Answers

Computers in Cars now a days adjust the air/fuel mixture on their own for different types of gas used. I would put a bottle of dry gas in the tank. Use an isopropyl alcohol base, not methenol. It removes moisture, methenol doesn't. You can put in a fuel system cleaner too at the same time. You might also need to change the fuel filter. If the check engine light isn't on, the O2 sensor is ok. But if you don't get it running right the sensor might carbon up and eventually the cat. converter could load up and plug.

Posted on May 14, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rough Idling on stand still?


Most Likely you have a vacuum leak. (hole or broken Hose). For a 2011 it is probably to early for the Valve cover gaskets to be leaking, but that is a possible cause. The older the car the more likely this is the case. Can also be caused by using less than premium fuel. Don't skimp and use mid grade and definitely NOT regular. Also could be the idle control valve.

Jun 01, 2015 | 2011 BMW 3 Series 328i

1 Answer

Ranger problems


run fault codes and check for O2 sensor problem and MAP/MAF sensor problems. If it is misfiring then codes for injectors and plugs may also appear

Jul 18, 2014 | 2002 Ford Ranger Regular Cab

1 Answer

Car will start and idle but when put into drive will shut off


Try checking the EGR valve. Usually at the back of the block near the fire wall. My tubing was hard, brittle and clogged. It caused mine to run extremely rough. After some new tubing and a little cleaning it ran great. A bad O2 sensor can also cause these type of symptoms.

Sep 22, 2013 | 2003 Ford Crown Victoria

2 Answers

1998 Dodge Intrepid 2.7 -- After running for 30 minutes, the car starts and runs rough. Driving up to temperature it runs fine. After sitting for 15 minutes or so, when starting it runs rough and will...


it sure sounds like you have an EGR problem. This valve controls the flow of unburned exhaust gases and re-routes them too the intake to be re-burned. This valve is usually open at highway or cruise speeds. Not usually open at idle. If this EGR valve is open at idle, you get a rough running for sure just like a mis fire and will smooth out as your speed increases. I would get that checked out and if faulty, replace. Please keep in mind that this part is quite expensive new, but it is electrically controlled. good luck!

Aug 25, 2010 | 1998 Dodge Intrepid

1 Answer

98 chev 3.1L runs rough and dies at idle


Check the DIS module or injectors. Check to make sure you have a spark on each cylinder. One cylinder could be misfiring

Mar 05, 2010 | 1998 Chevrolet Lumina

1 Answer

1998 WINDSTAR CSERVICE ENGINE SOON LIGHT IS ON


it's not likely a bad o2 sensor would cause it to run rough, but the catylitic converter, which is what the o2 sensor reads the flow of, would cause the car to idle and run rough.If you take it to an auto parts store to have a diagnostic test ran on it( most major parts stores will do this for free), thecodes it gets would help pin point it alot better.

Jan 20, 2010 | 1998 Ford Windstar

1 Answer

Runs Rough no catalatic converter


Well, i know that a took out a bad caat once and the truck ran terrible. So I went and put a new one in and it ran great. The O2 sensors can't read the exhaust gases correctly with out it. It was a Dodge with a 5.2L

Apr 19, 2009 | 1994 Jeep Grand Cherokee

1 Answer

1994 Cougar XR7 Engine idling rough and running rough at low and


Not saying this for sure, but I had the same problem, and i have a 1994 xr7 V6 3.8 L , and all u need to do is set the idle down manually because your computer could have seen that the injector was stuck open, and tried to turn up idle to keep up with the amount of fuel being pumped, worth a shot :P

Feb 18, 2009 | 1994 Mercury Cougar

2 Answers

My 2000 crown vics engine runs rough in park at mid throttle,and drives like i am on a bumpy road at mid throttle,replaced shocks, tires, balancing,alignment. please help


I suggest you look at or have the engine looked at, for air intake obstructions, engine mount problems, or possiblt drive shaft/u-joint problems. Those are my best guesses for your problem description. Good luck!

Sep 14, 2008 | 2005 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...