Question about 2006 BMW 7 Series

1 Answer

I keep getting on the computer screen low

I keep getting on the computer screen low pressure in tyres and after fixing i still have the same information . how do i reset ?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 146 Answers

Je-li Váš systém RDC - iniciallized automaticky po delší cest? pohybovat
a RPA systém nastavit i -Drive ( nastavení auta )

Posted on Jun 25, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have an "04" Chevy Cavalier recently started violently shaking if I drive over 40mph and I can't hardly keep it in my own lane there's also a kinda bird chirping noise any ideas what this might be?


I suggest a full front suspension and steering ball joint check including wheel bearings and cv joints
if all ok then have a wheel alignment as it sounds like a castor wobble problem

Aug 07, 2015 | Cars & Trucks

1 Answer

I have a 2001 park ave that burns too much gas.I had it tuned up and it still drink too much gas.How can this be fixed


run the fault codes and find what sensors are affecting the consumption
tune ups are not necessary and only cost money as the ECM is continually tuning the engine every second of operation
If it cannot keep the engine in tune it will set a fault code for you to fix
next you will have to have realistic expectations for the economy that you expect to get
There are many things that need checking like brake drag, tyre pressures , wide tyres, bigger tyres, your driving habits, if over drive is operational, dirty air filters , worn engine, blocked cat converter, load and speed, city or country driving ,lots of hills , faulty injectors , low fuel pressure, incorrect exhaust system
The list goes on and any one or a combination of some will give poor economy.

May 23, 2015 | 2001 Buick Park Avenue

1 Answer

Reset tyre pressure warning light mini one


i have just had my tyre on the front right changed due to puncture, and now i have a warning light - low tyre pressure which is very annoying! I went to the mechanic and he told me he needs to reset the computer system and it will go away! is this correct? i have my doubts now as he was the same mechanic who changed my tyre and may have interfered with the sensors in the car.
Please help :(

Mar 21, 2012 | 2004 Mini One

2 Answers

Tyre Pressures: The Handbook for my April 2002 reg. V70 Estate gives two tyre pressures for both the front and the rear tyres, but I am getting misleading advice about which is the correct one to use. At...


Hello, any pressure in between is fine, these are recommended pressures, i personally look at tyre wear when putting pressure, if its wearing on the outsides it means it has not enough pressure, if it wears in the middle it has too much pressure, as a general guide 32psi is used at most tyre shops, extra 100kg does not make much differance to a 2 ton vehicle, otherwise you would be changing tyre pressure every time you fill up your fuel tank!!!!

Mar 07, 2011 | 2001 Volvo V70

1 Answer

2008 beetle dash light on with a aexclamation mark


hi from uk this light is the tyre pressure monitoring system it is telling you that one or more tyres pressures are under inflation so! if you have not checked them weekly ? for your own safety you should may i suggest you check and inflate to correct pressure of all tyres inc spare ! obviously if one tyre is very low ? keep an eye on it? in case it has a slow leak/puncture ? ps the horse shoe is a low pressure tyre symbol ? best wishes from uk and merry xmas !

Dec 25, 2009 | 2008 Volkswagen Beetle

2 Answers

Im stationed overseas and my grandmother has a 2003 santa fe 6cyl. she is getting bad tire wear. could this just be a front end alignment and how much should it cost to repair


Brad

1. It's hard to say without looking at the vehicle (and test driving it) but more than likely the front end is badly out of alignment. ( If the car has been in a significant front end accident and badly repaired then this could also be a source of the problem as the alignment may not be capable of being properly set).

2. The first thing to do is take the car to a specialist suspension and steering shop and have the wheel alignment checked and adjusted to factory specs. Normally this is not expensive for a straight forward alignment but price depends on the shop. A good suspension shop will also identify if there are any wear problems with the steering or suspension that need attention

3. Older drivers sometimes frequently hit kerbs when parking their cars. This will throw out the front wheel alignment every time (and damage tyres) so it must always be avoided. Scrubbed.scuffed tyre side walls are an indication of this as well as scratched wheel rim edges.

4. Some drivers never check tyre pressures. Low tyre pressures will cause much greater tyre wear as there is more friction. (It will also make steering heavier, place undue stress on the steering components, cause the car to handle badly and result in much higher fuel consumption).
The lady needs to ensure her car has at least 32 lbs pressure in both front tyres and at least 30lbs in the rear (which carries less weight). The pressures must be set with COLD tyres. Manufacturer optimum spec tyre pressures are usually set for comfort. These can be safely exceeded by a few pounds. It is far safer (and more economical) to run slightly higher pressures than a setting that is too low. (A good tyre will run all day with 38-40 pounds pressure and 36-38 is quite safe).

5. Worn out shock absorbers will also contribute to abnormal tyre wear. 70000 miles of average driving will see out a set of shocks. (Personally I would not leave them that long as the factory shocks are generally of average quality on this type of car)..

That's the best I can do Brad without seeing the car so I hope this helps some. Hopefully a good wheel alignment will fix the problem but make sure the tyre pressures are kept up as well. If the shocks are worn out they will also need to be replaced if the car is to be roadworthy.

Cheers Sean

May 16, 2009 | 2003 Hyundai Santa Fe

2 Answers

My 2004 chevy impala low pressure tire light


remove the tyre valves and fit normal ones ,then the lights cant work and you have one less thing to worry about

Apr 11, 2009 | 2003 Chevrolet Impala

2 Answers

Recommended tyre pressures (touring) for 1987 Corolla FX


There should be a sticker on your door, or door post, or glove box, that tells recommended pressures. I'm guessing 30 to 35 psi. When in doubt, I go few psi lower than max. stamped on tire to start, then back it down 2 psi or so at a time until I get the ride, feel & handling that I like, then I watch the tread after a good drive down the highway. Dark on outside edges of tires, lighter in middle,air too low, add 2 psi at a time. Dark in center but lighter on outside edges, too much, remove 2 psi. & retry. Good ride, good handling, tread same all across, bingo, then I note it. Add few more pounds when carrying full load, back off to my notes for normal driving. Ride feels rougher than normal over bumps, lower it 2 psi. etc. etc. etc.

Dec 26, 2008 | 1987 Toyota Corolla 2 Door

2 Answers

Tire tread wear high


Hi there!

The tyres you have on there cannot transmit the power you are giving them.

Choose tyres with a softer compound, more contact area, and keep at a lower limit of pressure.

In the meantime, lower the tyre pressures to the low limit when cold, and shift any items you carry over the rear axle to improve traction.

If this is useful to you, pleas spare a moment to rate as Fixya! Thanks.

Jun 18, 2008 | 2001 Chevrolet Corvette

Not finding what you are looking for?
2006 BMW 7 Series Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...