Question about 2007 Chevrolet Tahoe

1 Answer

The blinkers are not working and the message center says my hood is open (which it is not, I have checked/slammed the hood numerous times)

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert whose answer got voted for 20 times.

  • Expert
  • 201 Answers

Then you should take it to your dealer or your mechanic because they can only reset the codes. Check your fuses too. Hope this helps!?

Please rate solution - Thanks.

Posted on May 14, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hood open warning will appear almost the entire time i am driving but the hood is not open

The hood position sensor is probably defective which sometimes happens from age or just from opening and closing the hood, especially if the hood is slammed too hard. No matter what, it's not a difficult fix. The switch is located on the passenger side (left) latch and can be replaced in about 15 minutes or so once you have the part. Here is an excellent video on replacing it:
Replacing the LR3 and Range Rover Sport Hood Latch
Parts are readily available at Atlantic British and they are a great outfit to work with. You can, of course, get the part special order from your LR dealer.


Jul 13, 2014 | 2006 Land Rover LR3

1 Answer

My speedometer quit working after i shut the hood when i checked the oil and water.

slamming the hood shut may have jarred the cruise control unit connections loose check these..

Feb 10, 2013 | Cars & Trucks

2 Answers

Transmission problems with saturn rela

Have your dealer check the sincrenisers .

Aug 27, 2012 | Saturn Cars & Trucks

2 Answers

Power window will not go down how do i troublre


1. Sit in vehicle on seat next to problematic window
2. Ignition key is on
3. Door in question is opened (in case you closed it)
4. While door is open, press and hold power window button in desired window travel, keep button pressed !!
5. SLAM door closed with one hand while other hand holds button as per #4.
6. Watch window operate as it should.
7. Repeat 3-6 if necessary, but usually the first try works!

NOW, for the naysayers that says you must replace power window motors etc, at $$$ cost because the above fix does not work, or is not long lasting fix, or less than a "professional fix".... Well then, when the window fails to operate again, apply same fix again at that time.

I have fixed my van this way numerous times (usually once a year), and to all I recommend this fix too, likewise do the same and are happy with the solution.

Jul 12, 2010 | 2005 Dodge Caravan

1 Answer

2002 Jeep Liberty flashers, blinkers, taillight and brake light are not working on the left (drivers side

was vehical in an accident? check fuses in pdc under hood this jeep has fuses for the rt side and left side in power distrabrution center.

Feb 23, 2010 | 2002 Jeep Liberty

2 Answers

Hood will not close on 1999 buick century, after wife slammed down hood, springs all look good something must be out of alignment to catch latch any help would be appreciated, thanks

i'd check the hood latch,it could have been pushed down and not locking onto the hood latch,look at the bolts on the latch see if it has moved down,if so loosen and raise it up ,test it to make sure it is still latching

Jan 02, 2010 | 1999 Buick Century

1 Answer

1997 GMC Sierra p/u. Brake light & blinker out. Taillights ok.

I have notice that this is a common problem. The socket most of the time goes bad, I don't know why but they just do. You can pick them up at any parts store for around 5.00 each. If you don't have a volt meter and ground straps to test it right, then I would try changing the sockets out. Quick and easy. Let us know how it goes.

Aug 30, 2009 | 1997 GMC Jimmy

3 Answers

My blinkers and steering functions!!!

Pullout fuse 20 and 21 and push same back in. This resets the system, this has happened to me.

Apr 27, 2009 | 2000 Volvo S80

1 Answer

2000 dodge durango blinkers wont work

try checking the Relay in the fuse box under the hood, and there is also one up under the dash, if you dont hear the relay click with you put power to it then pop it out then try a new one. a lot of times it could be the relay but you still get power to the fuse. cause the relay clicks closed and locks that way. if not that check for power at the blinker, take the bulb out turn the blinker on and see if there is a voltage change there if not then it could be a bad ground or line under the hood.

Mar 13, 2009 | 2000 Dodge Durango

Not finding what you are looking for?
2007 Chevrolet Tahoe Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides