Question about 2006 Honda Accord
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Perform a valve clearance inspection and adjust if necessary. Tight or sticking valves will cause a misfire or rough running concern. Note: Perform valve adjustment when the engine is stone cold. 4cyl: INT 0.26mm EXH: 0.30mm (V6 engine are hydraulic and no adjust necessary.) Also check for a sticking or stuck open EGR valve. For diagnostic purposes only: Remove the EGR valve. Place a business card over the EGR passage and bolt the EGR valve back on. This plugs the EGR ports and if the misfire goes away the EGR valve is partially stuck open and is defective.
Check for low fuel pressure. Check for low compression. Check cam timing. Check for a weak ignition coil. Also don't over look the possibility of worn or broken engine mounts which cause excessive engine movement and engine vibration. -hope this helps
Posted on Mar 05, 2010
SOURCE: Honda Accord Map Light bulb
the cover is removed straight down, slowly working it with a thin tool or butter knife. WD40 to front and rear edge (there's nothing medial or lateral). The cover has 2 Y clips on each side, one about half way, and one that clips straight off of the hinge post. There are no "tabs". It will eventually unclip straight down. Then can replace with a DE3175 LED bulb (V-LEDs.com)
Posted on Oct 29, 2009
SOURCE: cabin air filter, location
It's located on the engine compartment firewall, passenger-side. Open
the hood, stand by the right front wheel and you'll see the fasteners
to remove forward of the wipers. Fasteners are removed by pushing the
center in, then pulling them out. To replace. pull the center out,
replace it, then push it flush to lock.
Good luck and hope this helps.
Posted on Dec 14, 2009
the cabin filter is behind glove box, open glove box an release it so it opens farther to get to filter ( should be release clips at sides of glove box)
Posted on Apr 26, 2010
Open the glove box. Remove the damper from the glove box then let the glove box hang down.
Remove the dust and pollen filter assembly from the evaporator case.
Remove the filter from the housing, and replace the filter.
Here is a picture to help you.
There you are. Thank you for using FixYa .
Posted on Apr 30, 2010
Tips for a great answer:
Nov 30, 2014 | 1998 Honda Accord
Nov 01, 2011 | 1990 Honda Accord
Mar 19, 2011 | 2002 Honda Accord
Feb 19, 2011 | 2007 Honda Accord Sedan
May 26, 2010 | 1995 Honda Accord
Apr 30, 2010 | 2005 Honda Accord
Jan 16, 2010 | 2006 Honda Accord
Dec 21, 2008 | 1992 Honda Accord
Nov 26, 2008 | 2006 Honda Accord
501 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: