How to reset t-belt for toyota land cruiser 2009
SOURCE: Toyota Land Cruiser check timimg Belt
Hi,
I am assuming that you have a series 80 diesel engine and that it has run for about 100,000 kms hence the warning light and the changing of the timing belt. Based on the instructions of its repair manual you need to "remove the
grommet off from the speedometer and turn off the lamp by pushing the
warning light reset switch, then replace the grommet." Alternately, you can try to reset the entire computer of the vehicle by removing the battery cables for a couple of minutes. Pls note that some car radios/head units would revert to security default (ask for a code) when power is completely removed.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
SOURCE: 1997 Toyota Land Cruiser rain water leak
i had the same problem. Flushed the sunroof drains, replaced the windsheild, and weather stripping on passenger and driver side doors. Car is still leaking. No one can figure it out.
SOURCE: wheel alingment specs for toyota land cruiser
Camber
Left−right error
1°00’ ± 45'
Caster
Left−right error
3°00’ ± 1°
Steering axis inclination 13°00’ ± 45’
Camber, caster and steering axis inclination are not adjustable.
If measurements are not within the specification, inspect the
suspension parts for damaged and/or worn out parts and replace
them as necessary.
INSPECT TOE−IN
Toe−in
(0.08 ± 0.08 in.
This is the only Land Cruiser Specs I could find, hope it helps
SOURCE: How can I find User's Manuaul of Toyota Land
- you can down load full manual for toyota land cruiser from pdftown.com website
http://pdftown.com/PDF-Toyota-Land-Cruiser-2004-Owner-Manual.html
SOURCE: Toyota Land Cruiser Prado (LC90) Owner's Manual (free download)
hi sir/mam,i have tryed to get help from allover,can i know who can.
i have Toyota land cruiser Model GF-RZJ 95W-GKPSK-D.
Engine-3RZ-FE.
Fram-no rzj95-0047087.
This vehical does not start,Digonest code 002:-Fauity RPM Signal(no RPM,NE and crankshaft position signal trnsmitied to ECU after started for 2 secondes)
1.CKP and CMP sensors short open
2.Distibutor fault.
3.start circuit open or short.
4.module fault.
i have changed distibuteor (NEW)
305 views
Usually answered in minutes!
×