Question about 1998 Volkswagen Beetle

1 Answer

1998 beetle stalls after warming up i let it cool

1998 beetle stalls after warming up i let it cool for a couple of hours and it starts again

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 271 Answers

I.ll give you advice.Because I don.t know the type of your engine please change Hall sensor/crankshaft position sensor/ and ignition amplifier.Everything will be O.K. If I know the engine type I.ll cancel one of above mentionated items.

Posted on May 15, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My son has a 1994 ford taurus we replaced the distributer cap and wired and it still stalls when driving and sometimes won't start back for sometimes a couple hours. What could be the problem?


check that the coil is the correct voltage in use start/ run 12 volts or start 12 volt run 7.5 volts ( a 7.5 volt running on 12 volts= faulty ignition resistance wire == all the time will fail from over heat condition)
next feel the coil when it stops --it should be warm but not hot to the touch
next test/ replace the ignition control module
These items will loose capacity to operate if they get too hot from component failure but in cooling down will again work until they get hot again

Jan 23, 2016 | Ford Cars & Trucks

1 Answer

1998 vw beetle 2.0 standard code p0322 chk engine speed sensor it chks good changed plugs and it stalled again


Resecure loose wire or connectors - If battery charge is low, recharge or replaced battery - Replaced crank position sensor - Replaced starter motor

Dec 16, 2013 | 1998 Volkswagen Beetle

1 Answer

1998 cherokee stall when driving and gets warm ,And wont start till it cools off ?


does your temp gage seem off does it go like up to the h because if it does you could try unpluging your upper coolent sensor because that could cause that because it is telling you computer to run in closed loop when it should be running in open loop

Aug 07, 2012 | 1998 Jeep Cherokee

2 Answers

Does not start. then will start a couple of hours


put a block heater on it and plug it in at night that way it keeps your motor warm and should keep every thang running smoothly

Sep 01, 2009 | 1998 Honda Accord

1 Answer

My 1999 VW new beetle stalls when it warms up. This has happened 5 times now. There is a temperature light that goes out when engine is warm. If I let the car sit for half hour or so it will start again....


The thermostat on your volkswagon helps the engine keep operating at a predetermined temperature for best fuel economy and engine performance. However, the thermostat mechanism wears down after months of use and subsequently fails. If stuck in the closed position, the thermostat will not allow coolant to circulate, causing the engine to heat up dangerously; if stuck in the open position, the engine will never reach proper operating temperature, causing fuel consumption and poor engine performance. In either case, the thermostat must be replaced. Its fairly cheap

Aug 28, 2009 | 1999 Volkswagen Beetle

1 Answer

When it gets warm it stalls


Check Crank Sensor and Cam Sensor .. Sometimes Oil Cover Cranksensor will Stop Cranksensor from Readig .. Do you have an Oil Leak??

Jan 07, 2009 | 1998 Jeep Cherokee

1 Answer

98 ford windstar stalling when warm


have your catalytic converter checked sounds like its clogged. good luck to ya

Nov 17, 2008 | 1998 Ford Windstar

3 Answers

1978 VW Super Beetle Fuel Injection trouble


check your mass air flow sensor , it take over fuel pump control after the engine starts

Jun 13, 2008 | 1998 Volkswagen Beetle

Not finding what you are looking for?
1998 Volkswagen Beetle Logo

Related Topics:

438 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76848 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8589 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...