Question about 2002 Nissan Sentra

1 Answer

1996 lights and everything work when I turn it over but nothing

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,341 Answers

Get a test meter and test if you get any voltage reading at the starter motor's wiring connection.If when trying to start the ignition you do get a reading then you have a problem with the starter.If you dont get any voltage reading then you have a problem with wiring, fuse or relay somewhere. Hope this helps.

Posted on May 14, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Need to locate ebcm for a 1996 tahoe

The ebcm has nothing to do with the brake lights , the ebcm - electronic brake control module is for the ABS - anti-lock brake system !
Voltage is available at all times through the STOP/HAZ fuse to the torque converter clutch (TCC)/stoplamp switch. With the depression of the brake pedal, the contacts in the TCC/stoplamp switch close. Voltage is available from the stoplamp relay on pickups, or the TCC/stoplamp switch on all of the other vehicles, through the turn/hazard switch to the left stoplamp, the right stoplamp, and the stoplamp lights. If a turn signal is in operation, the stoplamp on that side flashes as a turn signal. The other stoplamp serves as a stop lamp.

May 13, 2015 | 1996 Chevrolet Tahoe

1 Answer

I have a 1996 Ford Taurus GL when I open the car door all the lights and everything come on and work just like they're supposed to when I put my key in the ignition and turn it ignition a little bit the...

Most cars do this including the head lights , so the starter and ignition have less drain while starting. not sure if your model does this, If every thing is ok after starting nothing to worry about. If it wont start clean the battery terminals and check charging rate and battery.

Oct 20, 2014 | Cars & Trucks

1 Answer

Turn signals dont work

Switch in the column is likely the problem. Unless you are very familiar with inflatable restraint systems leave it to a professional.

Oct 25, 2013 | 1996 Chevrolet Blazer

1 Answer

Nissan sentra gxe wont turn on

sounds like they disconnected something else on your vehicle. invest in alarm system..

Dec 16, 2012 | 1996 Nissan Sentra

1 Answer

Wont start

starter cog is spinning and not engaging in flywheel , take out starter check for burr on cog .

Mar 22, 2012 | 1996 Jeep Grand Cherokee

1 Answer

1996 Jeep Cherokee Classic, I-6, Automatic Runs great, normally starts great. Occasionally go to start the car and it is totally dead - no dome light, no door buzzer, nothing happens when I turn the key....

first off clean the battery terminals, then follow the ground wire to the body and engine ensure they have good connections. sometimes the wire on the back of the engine that goes to the body breaks. good luck

Jan 15, 2011 | 1996 Jeep Cherokee Sport

1 Answer

Started up this morning fine went and did not start at all later.

remove and, clean your battery cable clamps then retighten and, test.
If your battery is too discharged "jump" it using jumper cables and, another car.

Apr 25, 2010 | 1996 Chrysler Cirrus

1 Answer

1996 F150 will not start. Turn key and nothing

if you hear clicking at the starter solenoid,then hit the starter with a hammer a few times,if it turns over a little,then either replace the brushes in the starter which is about $20.00 or buy a new rebuilt starter for about $90.00

Feb 01, 2010 | 1996 Ford F150 Regular Cab

2 Answers

I have lost brake lights. the turns, rev, and running lights still ok! new brake light switch ans still nothing.... is there a brake light relay on this truck?

is it the rear break lights? it may be the switch attached to the break pedals, - have seen it happen here in europe a couple of times.... you can always try checking with a multimeter if the switch is operating correctly

Sep 02, 2009 | 1996 Oldsmobile Bravada

2 Answers

Electrical issues

check your alternator belt if its good check your battery with a volt ohm meter engine off it should read 12.1-6 volts start car should read 13.3 nothing lower than this if higher 14.and above alternator is bad if lower than 13. altnator is not charging the battery.

Dec 22, 2008 | 1996 Toyota Camry

Not finding what you are looking for?
2002 Nissan Sentra Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides