Question about 1992 Dodge Dakota

1 Answer

Were is the oil pressure sensor located on a 1992 dodge dakota

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

It is located behind the breather, on the passenger side of the distributor. If you are having low oil pressure I'll give you a tip. You can change the sensor, but if that doesn't work, then the problem very likely could be that, dodge dakotas are notorious for a buildup of sludge on the screen of the oil pump, which blocks the flow of oil. If you are going to drop the oil pan to address this you may as well put a new oil pump in while you are at it. They are 30-50 dollars. If you can do it yourself, the whole operation should cost less than 100 dollars, if you take it to a garage, you better have a fat wallet.

Posted on May 30, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the oil pressure sending unit located in a '01 dodge dakota, 4.7 eng.?

go to CTC and buy a service manual for 2001 dodge Dakota 4.7 litre engine there will be 2 oil pressure sending units one that is for the gauges in the dash and the other for the oil pressure sending unit mounted on engine

Feb 12, 2015 | Dodge Cars & Trucks

1 Answer

Where the crank position sensor is located on 1991 dodge dakota

If it is like the 5.2 V8 I had, it will be on the
top of the bell housing at the back of the motor

I can look in my 1992 dakota manual if you need help

Mar 21, 2014 | 1991 Dodge Dakota

1 Answer

Pickup surges acts like its out of gas, stalls when stopping and hesistates when accelerating

2 other common problems to check into is when engine acting up where is the oil gage at? If at low, either oil sensor is shot or the oil screen on your oil pump is clogged, which the latter happens a lot to dodge otherwise easy fix is your idle control motor, cheap as well . located right in back of your carb.

Mar 04, 2014 | 1992 Dodge Dakota

1 Answer

How do you change the oil light on the dodge dakota 2005

the oil pressure sensor is located by the oil filter thay do go bad replace it and see if the light stops

if the das says in the display change oil turn key to on position press gass peddle to the floor 3 times quickly that should reset the service notice let me know if this helped

Feb 28, 2014 | 2005 Dodge Dakota

1 Answer

1992 dodge dakota wont stay running

Have you checked base fuel pressure with a gauge ?
Code 42 is a problem with the fuel pump relay or ASD relay circuit.

Jun 22, 2013 | 1992 Dodge Dakota

1 Answer

How to replace the oil pressure sensor on a 5.2 dodge dakota 93?

the oil pressure sending unit on V6 & V8 engines is located at the rear of the intake manifold near the distributor. It may have one bolt securing it or it may screw in. Hope this helps you.

Sep 04, 2011 | Dodge Dakota Cars & Trucks

1 Answer

1996 Dakota 2.5L OHV 4 cylinder Oil pressure gauge and oil light

if light is not working then first try this
* move ignition switch to on position, remove oil pressure sensor pin and touch it to engine body where it should get earthing, and same time oil light should come on, if it is not then that wire is disconnected some where in loom .

Jan 27, 2010 | Dodge Dakota Cars & Trucks

1 Answer

Where is the oil pressure switch on 92 dodge shealth 3.0

For DOHC engines, both sensors are located next to each other on the left side of the block (near the driver) and above the oil pan.

For SOHC engines, the Oil Pressure Gauge Unit is located next to the oil filter (on the right side of the block) and the Oil Pressure Switch is located on the left side of the block.

Oct 09, 2009 | 1992 Dodge Stealth

Not finding what you are looking for?
1992 Dodge Dakota Logo

673 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides