Question about 2004 GMC Yukon

1 Answer

04 Yukon is having trouble accelerating sometimes..

I have been having trouble with my '04 Yukon. I'll be driving and long and all the sudden it'll stop accelerating, it will only go 35mph for a couple a minutes and if I turn off the car it will reset itself and I don't have trouble. The other day this happened and went on for about 20 minutes. Had it tested and it came back as knock sensor and low fuel pressure. Could it be the knock sensor causing this trouble?

Posted by on

Ad

1 Answer

Not the knock sensor
A mechanically bound fuel pump, could though,thus low fuel pressure
A bad fuel pressure sensor ,also

Posted on May 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 GMC Yukon SLT 2WD. I am getting a clattering noise while slowing down. The slower I go the slower the clattering. When it first started, it would go away as soon as you press the...


Two possibilities come to mind with his type of noise and they both require attention NOW! To check the vehicle park on a level surface with the vehicle off and in park (you may need help). Slide under the vehicle ahead of the rear tire so you can see the connection of the driveshaft to the rear end. Then rock the vehicle back and forth with the tire and look at the u-joint connection. If the rear end yoke is moving more than the driveshaft the u-joint needs replacing. If the joint is extremely bad you can sometimes grab the driveshaft and wiggle it. If the vehicle rocks back and forth and there is little or no movement in the drive shaft and you hear clunking in the rear end there can be serious trouble in the rear end. Either condition will require some mechanical skill to fix. I hope this helps.

Feb 09, 2015 | 2003 GMC Yukon

1 Answer

My 2001 Yukon doesn't want to accelerate when driving down the road it hesitates what could this be.


Low fuel pressure maybe??? Is your check engine light on and if so have you pulled sny trouble codes....That amay help you narrow down the problem

Oct 12, 2013 | Cars & Trucks

1 Answer

1996 Jeep Cherokee 4.0 L has trouble accelerating


often times the engine needs to warm up to normal operating temperature. this varies from makes and models. if you cant wait that long, having it idle for approximately 5 - 10 minutes should at least lessen the acceleration problem, but the longer you wait the better it will be on the engine.

Jun 06, 2013 | 1996 Jeep Cherokee

1 Answer

My 1999 gmc yukon was running fine then all of sudden wont go into gear at all if you accelerate it justs revs up and wont go


It's an obvious transmission problem, If you throttle down and it Does NOT move that's the problem

Apr 19, 2013 | 1999 GMC Yukon

1 Answer

Mya 04 gmc yukon wont start again , just got fixed the mech said it was an ecm fuse? but got it back an wasnt accelerating rite an now it wont start again??


U should have ur computer scanned to ascertain actual fault, is anything showing on the warning lights, there might be a faulty sensor (air-flow), also make sure fuel pump, n injectors are clean of any dirt. The air filter element must be clean as wel. Go ahead n check these out. Good luck.

Jun 12, 2011 | 2004 GMC Yukon

1 Answer

I have a 2002 Yukon XL and all of a sudden its idling low and the battery gauge its moving every time I come to a complete stop.I put the key in the ignition, every thing came on for a quick second, and...


It sounds like your battery is going bad. When you accelerate the alternator spins faster generating more electricity. Take it to a auto parts store and they can do a free test to confirm what needs to be replaced.

Jun 10, 2011 | 2002 GMC Yukon XL

1 Answer

My 1995 yukon gt went out while i was driving, i replaced the fuel pump and im still not getting fuel to the tbiz. what do you the it mybe or what can i check while trouble shooting.


You may have a bad control module, this controls the injectors and fuel pump, also have you checked for spark,as sometimes you loose the spark also when module goes bad.

Aug 29, 2010 | 1995 GMC Yukon

1 Answer

02 yukon denali has a whining noise similar to bad wheel bearings. wheel bearings were just replaced. could it be cv's, no clunking sound though. also, sometimes the vehicle ''jerks'' when accelerating,...


the jerking and noise you are experiencing is the drive chain and bearings in the transfer case also you may want to check the end play in both front and rear pinion bearings and yokes

Jan 22, 2010 | 2002 GMC Yukon Denali

1 Answer

04 gmc yukon heater air cold passanger side.


If this happens when you are idle, and then you get hot air as you drive, most likely you have low coolant and it only cycles as you drive. Get approved dextrom gmc coolat and cap off your coolant it is most likely low.

Jan 17, 2010 | 2003 GMC Yukon XL

Not finding what you are looking for?
2004 GMC Yukon Logo

291 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...