Question about 2000 Acura TL

Open Question

How/where to replace turn signal flasher in acura 2000 3.2TL

Turn signal in Acura 2000 3.2TL works sporadically. Sometimes, it starts to flash and then stops, other times it doesn't flash at all. Hazards are flashing okay. Turn signal bulbs also function okay. All indications are that the the flasher is malfunctioning. I have bought a replacement flasher but can not figure out where to replace it. Any help you can provide will be greatly appreciated. Thanks!

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 106 Answers

SOURCE: P0505 idle control system malfunction

Take the Idle Air Control valve off the bottom of the Throttle Body and clean it. If that doesn't work you may need a new one. Please rate me if you find this helpful, thanks.

Posted on Jun 04, 2009

Ad
  • 1 Answer

SOURCE: 2000 Acura 3.2TL starting problem

i have same issue

Posted on Jul 21, 2009

  • 1779 Answers

SOURCE: 96 acura tl 3.2l is overheating+signals wont work

Start with the easy one (hopefully). You probably have to replace your turn signal flasher. It's located behind the dash, driver side of steering column in the relay block (just pull out to remove).
Your overheating problem: Are you losing coolant, or is the car just running hot? Any leaks, puddles?
Check the cooling fans to make sure they are kicking on as the engine temp rises. If not, you may have a bad switch that is not telling the fan to go on. If fan(s) are operating ok, check the thermostat. If it isn't opening properly, it could be the cause of the overheating. If you have a leak in the system, then when it gets too low, it starts to overheat. Many possibilities, So, let me know the answers to the above so I can help further if needed.

Posted on Jul 22, 2009

outdoorsman5
  • 631 Answers

SOURCE: Tail lights not working

Did you check your switch for your tail lights. You need to probe the wires from the switch to make sure you have power coming out of the switch.

Posted on Jul 30, 2009

  • 39 Answers

SOURCE: turn signal / hazard lights won't work

Both, unless you're starving to death, then buy some food instead. They're about as relatively expensive as a popsicle.

Posted on Aug 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Acura TL 2001 Turn Signals not Working ? When Flashers are on they work . Checked bulbs & Fuses & electrical everything is good . Help


Probably the switch itself, the lever you push on the steering column, is bad. Wiggle it vigorously to try and get the contacts to work.

May 15, 2015 | 2001 Acura TL

1 Answer

I have a 94 four door acura integra, flashers work but blinkers don't


if when you put your emergency flashers on and it clicks faster than normal I'd say your tailights or turn signal buls are burned out .
Also check the fuse panel ,I beleive on hondas they are on the drivers side in front of the door or under the glove box . A manual helps for these things though

Mar 12, 2015 | Acura Cars & Trucks

1 Answer

Turn signal and emergency flashers don't work even after changing relay


sometimes the problem is a bulb is burnt out so check them all ,becomes if one dont work the power suppy wont reach the others : )

Jan 17, 2013 | 2003 Acura 3.2TL

1 Answer

Turn signals & hazard lights not working fuses & relay all good what could it be? car is a vs holden comodore it is not listed below so i have picked a random car below


Check your flasher/flashers. If not there, next logical step would be the turn signal switch, assuming that all of the bulbs are good

Aug 14, 2011 | Acura CL Cars & Trucks

1 Answer

I installed a new radio in my 1998 acura cl but when i put the dash back in place my turning signals and hazards stopped working.....what's wrong and how can i fix it?.....thanks in advance for your help


This means that the plug for the hazard switch is not pushed in all the way. The turn signals will not work when the emergency flashers are disconnected.

I'm not going to pretend that I'm the smartest guy on the block and just knew this. I actually had the center console apart on my 99 3.0CL and had to drive it with everything disconnected. The first thing I noticed was that the turn signals did not work.

Nov 13, 2010 | 1998 Acura CL

1 Answer

Turn signals work sporadically. Hazard lights blink for about 20 seconds then stop. I read online about many other complaints about this. What's the problem?


the hazard flasher module is very common on these. When the turn signals don't work wiggle the flasher button. If the turn signals start working again than the flasher module is bad.

They are readily available in the aftermarket, relatively inexpensive, and easy to replace.

Sep 25, 2010 | 2003 Chevrolet Malibu

1 Answer

Turn signal / hazard lights won't work


Both, unless you're starving to death, then buy some food instead. They're about as relatively expensive as a popsicle.

Aug 06, 2009 | 1994 Acura Legend

1 Answer

96 acura tl 3.2l is overheating+signals wont work


Start with the easy one (hopefully). You probably have to replace your turn signal flasher. It's located behind the dash, driver side of steering column in the relay block (just pull out to remove).
Your overheating problem: Are you losing coolant, or is the car just running hot? Any leaks, puddles?
Check the cooling fans to make sure they are kicking on as the engine temp rises. If not, you may have a bad switch that is not telling the fan to go on. If fan(s) are operating ok, check the thermostat. If it isn't opening properly, it could be the cause of the overheating. If you have a leak in the system, then when it gets too low, it starts to overheat. Many possibilities, So, let me know the answers to the above so I can help further if needed.

Jul 22, 2009 | 1996 Acura TL Series

2 Answers

BLINKERS WON'T SHUT OFF AFTER YOU TURN A CORNER. ON MY 1997 ACURA TL THANKS


U are going to have to replace the turn signal switch, the cancellation cam is broken.

Mar 11, 2009 | 1997 Acura TL Series

Not finding what you are looking for?
2000 Acura TL Logo

Related Topics:

571 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...