Question about 1993 Toyota Previa

2 Answers

How do i bleed a cooling system on a estima lucida 1995 2.2 diesel??..I'm unsure if its a bleed problem or lack of flow..Maybe the water pump is knackered..

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

Just slacken off the clip on the highest water pipe to allow steam to escape, topping up the expansion tank as you go.obviously when the engine is hot....

Posted on May 13, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

My car wont start after it ran out of diesel how do I pump the diesel threw

Posted on Jan 31, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Dan how do I bleed 2004 Kia coolant car temp is good but sometime at idle heater starts to blow cool hit throttle gets great heat


I agree with your logic. Attached vid addresses bleeding. Sounds like at low rpms, not enough flow to transfer the heat. So bubble or maybe a partially obstructed core. There are a couple of vids on clearing a core... GOod luck, let us know if you figure it out.

Jan 11, 2015 | 2004 Kia Sorento

1 Answer

How to bleed injector pump on isuzu nkr pick up


These are self bleeding so if diesel is getting to the pump it won't need bleeding. If you still feel the need to bleed the system then loosen one injector pipe turn the engine until you see diesel coming tighten again it should fire up. If you have a good flow of diesel coming from the filter to the pump and diesel at the injector pipe then your pump pressure may be low. To check remove any injector reconnect the pipe to it with the injector end where you can see it. Turn the engine with the starter a few times the diesel should be making a mist. Wear eye protection for this test

May 28, 2014 | 1995 Isuzu Trooper

1 Answer

I got an 1995 Ford f250 7.3l and i just did a head gasket change and after all that i got 7 codes po113 p1212 p0470 p1211 p0344 p0603 p0198. ill be drivin it for about five minutes then it will start...


Hi

Im not 100% here but will give you something to look into. Does the car have a EGR valve?

Secondly check the air mass sensor this could cause multiple codes and make the car splutter.

Is it a diesel? or petrol? if diesel it may have air in the fuel system or a faulty pump. when you done the head did you change the fuel filter, and bleed the system though? only if diesel!, and check the injectors are not leaking, poor water on to each and see if any air bubbles come up. again only if diesel.

Please get back to me if your unsure of anything
Regards
Dan

Feb 11, 2010 | 1995 Ford F250

1 Answer

I would to know the cylinderhead torque for a 3c 2.2 diesel


1st 48ft-lbf

2nd turn 90 degrees

3rd turn 90 degrees

Sep 09, 2009 | 1994 Toyota Previa

1 Answer

Estima lucida 94 auto diesel needs jump leads every time


put a 12 volt test meter on the battery with the engine off and get the reading.
then start the engine and retest the volts it should go up a volt ot two.
if the test readings are the same then the alternator is bad.
thank you
jm

Jul 29, 2009 | 1994 Toyota Previa

2 Answers

How do i do an oil change on my toyota lucida estima


I believe you can find some guidelines in the following free download, good luck!:)

Contains:


Air Conditioner
Brakes, Wheels & Tyres
Cam belt
Central Locking Stuff & Alarms
Cooling System
Cylinder Head
Electrical System & I.C.E
Engine
Exterior Lighting
Fuel & Emissions System
Suspension & Steering
Transmission Systems

Also contains:

Estima Guide
Estima Owners Handbook

Download (~50MB): http://www.mediafire.com/?yx9wiypm6t2

Jul 25, 2009 | 1996 Toyota Previa

1 Answer

The problem is the water is linking ender the water pump's bolt


Maybe you can find some guidelines in the following free download, good luck!:)

Contains:


Air Conditioner
Brakes, Wheels & Tyres
Cam belt
Central Locking Stuff & Alarms
Cooling System
Cylinder Head
Electrical System & I.C.E
Engine
Exterior Lighting
Fuel & Emissions System
Suspension & Steering
Transmission Systems

Also contains:

Estima Guide
Estima Owners Handbook

Download (~50MB): http://www.mediafire.com/?yx9wiypm6t2

May 20, 2009 | 2009 Toyota Venza

2 Answers

Engine oil capacity


it's a 4 liter oil

May 14, 2009 | 1995 Toyota Previa

2 Answers

Lucida estima


a lucida estima is a seven seater toyota passenger vechile

Aug 22, 2008 | 1994 Toyota Previa

3 Answers

Lucida estima


Electric. All fuel injected vehicle must have an electric pump.

Jun 10, 2008 | 1993 Toyota Previa

Not finding what you are looking for?
1993 Toyota Previa Logo

1,086 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...