Question about 2000 Chevrolet Blazer

1 Answer

How do I replace blower motor on 1997 Bravada

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 17,970 Answers

GM S-Series Pick-ups and SUV's 1994-1999 Repair Guide
Blower Motor - REMOVAL & INSTALLATION

Pick-Up models

How do I replace blower motor on 1997 Bravada - cf976fa.jpg

Fig. 1: Blower motor assembly and resistor locations


  1. Disconnect the negative battery cable.
  2. If equipped, remove the Vehicle Control Module (VCM) from the engine compartment.
  3. Remove the coolant recovery reservoir.
  4. Disconnect the blower motor cooling tube.
  5. Unplug the electrical connector(s) from the blower motor, as necessary.
  6. Remove the blower motor-to-case screws, then carefully withdraw the blower motor from the case.

To install:
  1. Install the blower motor to the case and secure using the retaining screws.
  2. Engage the electrical connector(s) to the motor, as necessary.
  3. If moved on early model vehicles, reposition and secure the A/C vacuum tank.
  4. Connect the blower motor cooling tube.
  5. Install the coolant recovery reservoir, then if equipped, install the VCM.
  6. Connect the negative battery cable.

Utility Models
See Figure 6
  1. Disconnect the negative battery cable.
  2. If equipped, remove the Vehicle Control Module (VCM) from the engine compartment.
  3. Remove the coolant recovery reservoir.
  4. Disconnect the blower motor cooling tube.
  5. Unplug the electrical connector(s) from the blower motor, as necessary.
  6. Remove the blower motor-to-case screws (the lower screw is on the bottom front of the cover).
  7. Disconnect the harness from the blower motor.
  8. Use a razor or utility knife to cut through the cover on the cut line as neatly as possible because the access cover has to be reinstalled.
  9. Starting with upper half of the cover, tear the remaining part of the access cover from the remaining portion. Then remove the lower half of the cover in the same manner.
  10. Remove the blower motor assembly.

To install:
  1. Install the blower motor assembly.
  2. Connect the two halves of the access cover together using the three flange clips.
  3. Using black duct tape, place a piece of the tape along the bottom lower edge of the lower half of the lower cover only. The tape has to be the full width of the cover.
  4. Install the access cover onto the case.
  5. Install the screw and align the cut areas.
  6. Seal the cut areas using black weaterstrip adhesive. Do not use RTV to seal the assembly. The weatherstrip adhesive bead should be as straight as possible to ensure a neat and professional finish to the cover. Allow the adhesive to set at least 15 minutes until it skins over.
  7. Attach the electrical connections.
  8. Attach the cooling tube and install the coolant recovery reservoir.
  9. If removed, install the VCM.
  10. Connect the negative battery cable and refill the coolant reservoir to the proper level.
dc22246.jpg

Fig. 2: Cut the blower motor access along the dotted line shown in this illustration

Hope this help (remember rated this help) Good luck.

Posted on May 13, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: blower motor for a 1997 acura tl

Unless you are an expert do not even attempt this. This is one of the first things that they put into the car, it requires you take off the entire dash, drop down the steering column, remove multiple vents / ducts, remove the chiller, remove screws from inside the engine compartment. This is at least a 10 hr job if you are good.

Posted on Nov 11, 2008

motor1258
  • 6674 Answers

SOURCE: were is blower motor 1997 acura tl 3.2?

Check this link. May change your mind.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008be4b

Posted on Mar 06, 2009

  • 14036 Answers

SOURCE: where is the blower motor located?

look under the left side of dash on driver side.besure disable air bag when working around the steering wheel area and dash or cluster area.

Posted on Jul 10, 2009

Testimonial: "Thank you! very helpful!"

techbuster
  • 5081 Answers

SOURCE: Heater blower motor replacement -1997 Dodge Grand Caravan

Remove the cover plate on the passenger side of the heater box, 3-4 screws.
Unplug the motor assembly, remove 3-4 more screws that hold the motor in place and pull it down from its position. Get an aftermarket motor and installed it in the original housing with the original squirrel cage.
Installation is the reverse of removal.

Posted on Nov 23, 2009

  • 610 Answers

SOURCE: How do you replace a blower motor resistor on

It is located on the right rear of the engine compartment. held in by two screws.

Posted on Jun 29, 2011

Testimonial: "Very Helpful, Thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ac fan keeps going off and on. resistor has been replaced and it still does it.


Could be the blower motor or a connection in the circuit. The wiring and blower would need to be checked.
If it has automatic climate control, there is a blower motor processor and an HVAC module that would also need to be checked.

Jun 12, 2013 | 2003 Oldsmobile Bravada

1 Answer

Noisy blower fan for 1997 olds bravada


Check for anything in side the fan.

Apr 09, 2013 | 1997 Oldsmobile Bravada

1 Answer

Have a 2003 Olds Bravada, my AC fan keeps running after I turn off car and get out, why?


This can be caused by a defective blower motor speed control resistor, that is the common issue with this problem in GM cars and trucks. The blower resistor is located next to the blower motor and the connector sticks out of the air ducting, it is held in place by 2 screws.

Sep 06, 2012 | 2003 Oldsmobile Bravada

2 Answers

Location of 1997 olds bravada fan blower motor resistor


i don't know exactly where it locates, generally resistors,heavy load fuses are directly connected through the battery terminals.better check in that location.

Jan 27, 2012 | Oldsmobile Bravada Cars & Trucks

1 Answer

Blower moter not running


If its not working at all try tapping on the blower motor with the key on and the speed setting set to high. If it starts working replace the blower motor.

Here is a how to tip that might help also.

http://www.fixya.com/cars/r6571076-blower_motor_not_work

Dec 16, 2010 | 1997 Oldsmobile Bravada

3 Answers

The heating and cooling fan on my 2003 Oldsmobile Bravada only runs on low speed. What do I check?Could it be a fuse?


I have an 03 bravada and the problem with my blower was the blower motor control module.I just had it replaced and everything works perfect.I paid 115.00 for the part and took 2 minutes to put in.The control module is below the glove box behind a panel.remove the panel and look up and you will see it.It has a rurple and black wire comeing off it.

Feb 21, 2010 | 2003 Oldsmobile Bravada

1 Answer

Heater blower motor repair need to know how to repair or troubleshoot heater core works but doesnt blow heat into car


First check all your fuses. If you have power to the blower motor and it is not working then you are probably going to have pull the blower motor. This usually involves pulling a large portion of the dash. I recommend you buy a Haynes manual from autozone (approximately $20) for guidance.

Feb 11, 2010 | 1997 Oldsmobile Bravada

1 Answer

2002 Bravada blower motor sounds like wild animals fighting in glove box. Happened over night Dash board vibrates


Something probably fell down into the blower. You will have to remove the blower to get is cleared out.

Nov 02, 2009 | 2003 Oldsmobile Bravada

1 Answer

Where is the blower motor located?


look under the left side of dash on driver side.besure disable air bag when working around the steering wheel area and dash or cluster area.

Jul 10, 2009 | 1998 Oldsmobile Bravada

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

912 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...