Question about 1999 Ford Expedition

1 Answer

While driving it misses, and rides a little shaky,but it does't do it all the time,what could this problem be?

Posted by on

Ad

1 Answer

Bad COP-Ignition Coil

Posted on May 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Codep0305


It could be mechanical or fuel related.
Do you know for a fact that cylinder has normal compression and no head gasket leak ?

Feb 15, 2014 | Pontiac Grand Am Cars & Trucks

1 Answer

I have a van mazda mpv 98, rpm going over 3000 and the van its only 45/ mph take to long to change gears


So if it is to hard to change gears it might be you have transmission problems . And to support that it also might be a shaky ride

May 26, 2012 | 1998 Mazda MPV

1 Answer

I have a 97 s10 5 speed and when going up hills it gets very noisy and feels shaky? also when i accelerate the same thing happens. i also have a problem with the odometer and speedometer neither one works!...


with the noise and shaky problem the engine might be missing on one cylinder. For the speedometer check the cable if it has one or maybe a wire is unplugged or broken check by the rear of the transmission.

Nov 25, 2010 | 2000 Chevrolet S-10

1 Answer

I have a 2004 ford escape. i just started it and it semmed to be sputtering and a little shaky then the emissions light came on. what is the problem?


many times if the car was parked the last time overheated and also low on fuel the fuel can boil in the fuel rail and the lines the resultigair pockets before the fuel pump picks up mkes the car miss( no fuel or not enough to a few cyclinders or even the injectors leaked a little after it was shut off. both ways it'll miss when started back. It's possible you live in an area that shifts gas from winter to summer and back the winter gas in hot tempertures will do this. The check engine light can be reset with a scanner. Codes po420 or other mixture codes may appear. ( happens alot this time of year as the fuel switch over to winter gas is happening. as soon as your car ( tunes to the new forulation ) It might not do it again. The winter gas works well in cooler days but it does what you pointed out on hot days.

Sep 30, 2010 | 2004 Ford Focus

1 Answer

2003 gmc envoy engine light flashing, car shaky when i start it or come to a stop and little hesitant when driving - took it to advance auto machine said cylinder 3 misfire what cause this - i have never...


it should continue to drive, there is a possibility of catalytic converter damage or futher engine damage if it is an engine mechanical issue

Nov 24, 2009 | 2003 GMC Envoy

1 Answer

Rough Idle and missing at low rpms on 2003 Ford Ka


make sure you put the right plugs in the fault is most likely the coil pack follow the plug leads from the spark plugs and you will reach the coil pack about £60

Oct 28, 2009 | 2003 Ford Escort

5 Answers

Toyota vits 2005 shaking engine


Very possibly you have a bad motor mount. Is the engine missing or running smooth but shaky? If it is missing, then it may be plugs, wires, or injectors, if runs fine but shaky, then you may have a bad motor mount.

Aug 25, 2009 | 2007 Toyota Yaris

1 Answer

My car is shaky little bit when i start it


it could be the timing chain, taking it to a dealership or mechanic who can hook there computer up to it and read the fault code would be your best bet though

Dec 28, 2008 | 2003 Ford Explorer

2 Answers

Vibration in Steering Column at Idle


Engine vibration is the cause of this issue, it is the biggest complaint from many owners, changing the engine mounts will help, as mounts age the rubber gets hard and they don't absorb vibration like they should, new mounts help issue, but it will no stop it altogether. A faulty MAF will not cause vibration, just a hesitation on acceleration at times

Oct 03, 2008 | 1993 Saturn SL2

Not finding what you are looking for?
1999 Ford Expedition Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...