Question about 2008 Toyota Tundra

1 Answer

Replaced map/dome/door bulbs with vleds bulbs, bent map light socket and tried to fix with screwdriver, caused spark, now none of the mentioned lights work and dash clock reset to 1:00 Blown fuse? Fuse location?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,489 Answers

Blown fuse. Do you have your owner's handbook? The fuse should be labeled. The location will be inside the car. Look under the dash on the driver's side and you may have to pull fuses to make sure they are good, but it should be only 1 fuse.

Posted on May 13, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford taurus tss 2004 map lights work but dome light wont come on


It is possible the bulb in the dome light is burnt out or there is a bad connection @ the bulb. That is at least where you start. you will need to remove the dome light cover & wiggle the bulb while the door is open, or best to have two doors open to remove the possibility of a faulty switch. If it still doesn't flicker or start to work remove the bulb & inspect it to see if the filament is broken. If you can't tell best to replace the bulb & try again.
Please advise if you need more help.

May 29, 2014 | Cars & Trucks

1 Answer

1989 chrysler new yorker dash and dome lights and fuse problems


You have a direct short. Take the bulb out of dome light, inspect the socket. Try putting fuse back in while bulb is out. If the fuse blows again, Id say it's in the wiring from the fuse box to the the switch. If the dome light fuse also covers other electrical things, such as lighter, check the socket at all points. You mentioned that other fuses were replaced as well? Which ones, and why did they blow? Sometimes it could be moisture entering your fuse box, or condensation near the computer, but is sounds more like a short. Could be as minor a a bad ground wire, or a chafed wire. While you are putting the fuse back in, it will help to keep your eyes looking around the fuse box for sparks as soon as the fuse goes in. You should also listen for that electrical snap. If this doesn't help, I'd suggest taking head panel down and follow and inspect the wires from dome down to the switch. Then from switch [ which could also be the cause ] to fuse box. look for hot spots, arcs, and bare spots. I hope this helps you out. keep me informed

Jan 05, 2013 | 1989 Chrysler New Yorker

1 Answer

94 Mercury Cougar 4.6L Int Lamps 10Amp fuse blows


replace the door jamb light button, it's probably bent therefore not pushing in when door is shut, and when door is shut it grounds out, and it wld'nt effect the dome light because it's in the circuit befor the dome if this is the case and you find it's bent or crimped try to bend it back out,

Aug 25, 2012 | 1994 Mercury Cougar

1 Answer

How to remove the whole head lamp from honda pilot


The Honda Pilot is a mid-d sport utility vehicle introduced in 2003. The 2005 modelcame in three different types: the LX, EX and EX-L. In the center of theinterior roof is a dome light, or map light. All you need is a screwdriver to complete the job. Once removed, you can add new electronics to the Pilot'sroof.

1. Turn off the dome light and the car's engine. 2. Insert a flat headscrewdriver into the edge of the map light plastic cover. 3. Pry the cover off until itpops out of place. 4. Locate the two screws on theinside of the light mount and remove them with the screwdriver. 5. Remove the plastic domelight fixture to access the connector attached to the bulb. 6. Detach the connector fromthe dome light bulb. The dome light fixture can now be removed.
Hope this is what you are searching..

Nov 09, 2010 | 2005 Honda Pilot

1 Answer

2005 chevy suburban- my back-up lights and interior dome lights do not work. All fuses appear intact? Suggestions?


you bcm (body control module is bad) to have the dealer replace it will run you about $400. a quick fix for the reverse light is to splice 2 wires into the wire for the center plug in your trailer wiring. now run a wire up to each reverse light, cut the green wire to each reverse light and **** conect them up. this is a seperate revers feed than the one from the bcm. the dome lights remove the light cover on the second set of interior lights (the one between the drivers seats). the two side bulbs are map lights the center bulb is for the dome lights. run a jumper wire from the right or leftside socket to the center socket. you dome lights will now turn on with just the use of that switch i replaced the back bulbs with led's soo there is no extra amp's being drawn. you could bypass the bcm but i could not find any wiring diagrams for it and i dont know if it can take the added amp's

May 31, 2010 | 2005 Chevrolet Suburban

1 Answer

Interior dome/map light replacement - 2008 Honda C-RV


You will have to pry off the lens CAREFULLY using a small screwdriver. There are two (or more) little plastic protrusions on each long side of the lens which fit into the casement. Look for very small slots along the side of the lens to insert the blade of the screwdriver. You can ease the casement away from the lens enough to get it to pop out. Re-inserting it is the same, but probably easier.
Gently, give it a try.
Hope this helps you.

Nov 21, 2009 | 2009 Honda CR-V

1 Answer

Just purchased 2001 Tiburon. Both dome lights do


which door are you using when you try this. It could be the door switch for that door. If the bulb is still good try another door and see if it comes on

Aug 29, 2009 | 2001 Hyundai Tiburon

Not finding what you are looking for?
2008 Toyota Tundra Logo

265 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...