Question about 1994 Honda Civic

1 Answer

My speedometer not working where can i locate the cable?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,317 Answers

The cable should be coming thru the firewall on the driver side, running down into the transmission.

Posted on May 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Speedometer not working


try checking the speedometer cable its located behind the speedometer there should be a cable that connects to speedometer right in the center

Apr 01, 2014 | 2005 Dodge Stratus

1 Answer

22RE TOYOTA 1993 PICKUP BASE MODEL 4WD 4CYI 5 SPEED MANUAL


its located on transfer case rear end near propeller shaft , have 3 wires plug

Jun 27, 2017 | 1993 Toyota Pickup

1 Answer

Speedometer on 82 chevy scottsdale not working


Check the transmission where the speedo cable goes into. It's located at the back of the trans. Removed the small cable retainer bolt and pull the cable out. See if the gear is broken. If it's not broken, have an assistant watch the speedometer in the truck and spin the gear at the end of the cable by hand as quick as you can and see if the assistant see if the speedo moves. If it doesn't move, replace the cable. It's most likely broken inside the housing or where it attaches to the back of the speedometer.

Mar 10, 2013 | Cars & Trucks

1 Answer

Why would speedometer needle bounce


The needle bounce may be related to the cable, it may be broken or just needs lube.
Remove the speedometer cable, locate the connection at the transmission and unscrew it, then locate the connection at the rear of the speedometer, remove the cable from the car, pull cable out of plastic housing and see if it comes out in two parts, if it does then cable needs replacing.
You will see the cable has two ends, is the cable is broke replace it, a broken cable will sometimes spin and not spin causing needle to jump, also a binding cable will do the same, if cable is good then spray wd40 in to cable and spin by hand. note; if cable is binding you will need to work it so it does not break. good day

Apr 29, 2012 | 1984 Toyota Celica Supra

1 Answer

It's a 2002 Mazda Protoge 5 speed manual trans. The speedometer just stopped working, could the cable just have come loose or is it no good? Where is the cable located on the car?


There is no cable. It has an output speed sensor located on back of transmission. It senses rpm & gives info to computer & speedometer.

Apr 04, 2011 | 1992 Mazda Protege

1 Answer

Broken Speedometer on my '84 S-10.


HI. If your speedometer needle doesn't move, or if it flutters, your speedometer cable may be bad.

To determine if it is the cable, disconnect the cable casing from the transmission and from the back of the speedometer on the instrument panel. Draw the cable out from inside of the casing. The cable looks like a twisted piece or wire. If the cable is broken or if it is dry or brittle. It probably needs to be replaced. If the cable is intact and the same length as the cable casing, the problem is likely the speedometer head.

I would also advise to check the speedometer gear as well.

The speedometer gear is located on the output shaft. Inspect it for damage.

This gear rarely suffers damage because the gear from the speedometer that meshes with it is usually made of a softer material. Sometimes, the speedometer gear on the main-shaft is replaceable. A clip can hold it in place or it can be a pressed fit. A special puller is available to pull these gears on the car.

Nov 08, 2009 | 1984 Chevrolet S-10

1 Answer

Changing speedo cable on peaugot 306 m reg


Note: On later models an electronic transducer providers road speed signals to the speedometer and engine management system and speedometer drive cable is not fitted.

1, Working in the engine compartment, pull the cable securing pin from the gearbox/transmission housing. then release the end of the cable from the gearbox.

2, Pull the speedometer cable sharply to release the cable ball from the locating grommet in the bulkhead.

3, Pull the cable through the bulkhead grommet into the engine compartment, and withdraw it from the car.

4, REFITTING, is reversal of the removal, but coat the cable ball with some soapy water( eg washing up liquid) to aid refitting, and ensure that itis correctly located on the bulkhead grommet.

I hope this as helped!!

Jul 22, 2009 | 1995 Ford Aspire

6 Answers

96 honda accord speedometer not working


you need a new speed sensor located on the gearbox with 2 size ten bolts holding it on and a 3 pin connection going into it! heres a pic http://www.hondacivicrepairs.com/views/honda-civic-speed-sensor.JPG

Mar 24, 2009 | 1996 Honda Accord

1 Answer

Speedometer wont work


HI. If your speedometer needle doesn't move, or if it flutters, your speedometer cable may be bad.

To determine if it is the cable, disconnect the cable casing from the transmission and from the back of the speedometer on the instrument panel. Draw the cable out from inside of the casing. The cable looks like a twisted piece or wire. If the cable is broken or if it is dry or brittle. It probably needs to be replaced. If the cable is intact and the same length as the cable casing, the problem is likely the speedometer head.

I would also advise to check the speedometer gear as well.

The speedometer gear is located on the output shaft. Inspect it for damage.

This gear rarely suffers damage because the gear from the speedometer that meshes with it is usually made of a softer material. Sometimes, the speedometer gear on the main-shaft is replaceable. A clip can hold it in place or it can be a pressed fit. A special puller is available to pull these gears on the car/truck.

Mar 12, 2009 | 1989 Chevrolet C3500

1 Answer

Speedometer stopped working


maybe speed sensor switch? usually located and attached to speedometer cable at transmission!??

Dec 28, 2008 | 1995 Nissan Sentra

Not finding what you are looking for?
1994 Honda Civic Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...