Question about 1998 Chevrolet S-10 Pickup

1 Answer

96 S-10 Pickup when engine is started it sounds like it is running at full throttle?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,297 Answers

It might be try the following...
1.) disconnect the IAC (idle air control motor) and start the vehicle

you might set a code and turn on the check engine light, but if the engine doesn't start and run at a high idle then you know you are on the right track

the computer could be commanding the high idle on start up for a few different reasons or the IAC could just need replacement

without a professional scan tool you will have to guess

however, the IAC should be less than $40 at any parts store

Posted on May 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fix a 91 isuzu truck manual trans. 2.5L that u start and is all good to start as soon as engine runs its running at high rpms.


old car, very old
this is easy, to find, but can be many things, my tests cut this to 2 reasons. mostly. (leaks and isc failure tests)
1: ISC system is dead, (stuck idle speed contr. valve)
2: throttle cable stuck or set wrong, (must have slack)
3: vacuum leaks, on all cars with map sensors, vacuum leaks make the ISC loose control and RACES fast with full engine power. all MAP based EFI SYSTEMS, "speed density systems:

Sep 08, 2015 | 1991 Isuzu Pickup

1 Answer

Have '89 toyota celica ST, 3S FE engine, the primary coil inside the distributor cap exploded, releasing its oil and fried the pickup coil. Replaced with new distributor and throttle position senser....


It sounds like the airflow switch is not closing. Do you have the airflow meter connected? Is the intake pipe fully installed? I just fixed a 91 pickup that had the same problem.

Sep 24, 2017 | Cars & Trucks

1 Answer

1990 isuzu pickup started to run full blast


Not the pedal, but the accelerator cable can sometimes get jammed inside it's protective sheath or cover. This happened to me. Look at your threottle control on the throttle body. Is the throttle in its normal idle position?

May 20, 2012 | 1990 Isuzu Pickup

1 Answer

1995 nissan pickup throttle position sensor


ok on a 2.4l on the black/green and white wires use ohm meter and there is no specific spec for that engine just make sure the the resistance changes and there is no dead spots. for the 3.0l black and white wires specs are 1.0-9.0k ohms im guessing the specs are the same either engine. close to full open


Jul 13, 2010 | 1995 Nissan Pickup

1 Answer

1992 Cadilla Seville will not restart after it has run for about an hour. Must leave for several hours before it will restart


sounds like a temparature sensor problem - mixture is too rich to start hot. try starting it with full throttle - if it will start after 15 seconds of full throttle and cranking the temp sensor is definitely at fault - you wont flood the engine doing this only give more air to the engine.

Jan 24, 2010 | 1992 Cadillac Seville

1 Answer

Starts but won't run


Could be throttle postion sensor Unplug it and start it is one of the sensors hooked to the intake

Apr 07, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1988 nissan pickup engine rotates but does'nt start.


it sounds like the injectors are not opening up man.. replace the injectores and this should fix your problem..good luck keith....

Mar 21, 2009 | 1987 Nissan Pickup

2 Answers

HIGH IDEL


sometimes the gasket under the trottle body goes bad. spray carb cleaner at the base of the trottle (not down into it) body while the engine is running. if the idle changes your on the right track. its an easy gasket to change.

Jan 08, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1999 S10 Pickup miss fire


Your throttle position sensor should be located on the throttle body opposite of where the throttle cable hooks on too. Look for a small black box on the other side with wires leading into a connector. get your codes read and re post them it could be a simple fix.

Oct 22, 2008 | 1999 Chevrolet S-10 Pickup

1 Answer

Starving for fuel


Check the system pressure aginst spec in manual.

Jul 13, 2008 | 1997 Nissan Pickup

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...