Question about 2005 Peugeot 405

1 Answer

Could you please advise me on the following. The windscreen washer liquid run out on a peugeot 407 HDI when I topped it up, it is struggling to spray. It is only trickling out without being a clear spray. What can I do to make it spray properly?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Peugeot Master
  • 2,100 Answers

Your jets are clogged up, if you have an air line or access to one, blow out the lines from the nozzle near the wipers, it should clear it up. Pop the hood up and pull a hose off the Y fitting so that the junk doesn't get back in the jets. Then put the hose back on and give it a try, hope this helps.

Posted on May 13, 2010

  • Hugh Venables Mar 04, 2012

    Over a period of months the flow from the washers on our 2003 307 gradually reduced until there was nothing although the bottle was full and the pump could be heard. After removing the right front wheel and the inner mudguard liner the bottle can be removed. The pump unclips from the bottle. The pump has two outlet ports. Clipped into the ports is a small cylinder with spouts for the front and rear washer hoses. The pump runs forwards or backwards for either the front or rear wash. Inside the small cylinder is a rubber cylinder in a plastic tube which is a shuttle valve to isolate the two circuits. Over time the rubber cylinder had expanded in length and blocked both circuits. I shaved 1 m.m. from each end and now it works like new. You need to be a bit handy and be careful not to break or bruise any plastic surfaces. A Haynes manual is some very basic help.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My peugeot 407 auto HDI has recently started running at higher temperatures for eng oil and gearbox. what is causing this?


low oil level in the sump and low coolant level in the radiator
could be excessive oil i the transmission
run the fault codes to determine other failures

Jun 26, 2017 | Peugeot Cars & Trucks

1 Answer

Can you please tell me why my peugeot 407 hdi p.t.filter soots up a few miles after cleaning fully? thank you


get it removed completly they run fine without them and no problems for emissions ive done several all ffine

Dec 15, 2016 | Peugeot Cars & Trucks

1 Answer

How to set ignition timing on a 407 peugeot


i have a peugeot 407 hdi 2.0 turbo 16 valve engine and i wont to now more about timing markes where is

Jan 22, 2013 | Peugeot Cars & Trucks

2 Answers

Where is the fuse box in the peugeot 407


my dad has a peugeot 407 sw hdi 2.2 estate and his boot light and 12v accessories socket does not work any ideas where the fuse box is or how to fix this problem ??

Mar 06, 2012 | Peugeot 407 Cars & Trucks

1 Answer

Wipers are not working suddenly???


Check your fuse compartment under hood. Fuse 3 & 12 for windshield wipers and washers. More than likely you've overloaded the wiper motor causing a blown fuse.

Check this site for additional fuse information: Peugeot 407 2006 fuse box diagram Auto Genius

Jan 10, 2018 | 2006 Peugeot 407 1.6

1 Answer

Peugeot 407 SE HDI Automatic Gearbox


Peugeot 407 Automatic Gearbox: oil low pressure?

Aug 07, 2010 | Peugeot 405 Cars & Trucks

1 Answer

Peugeot 407, 2.0 litre diesel, 05,loss of power/air surge heard


I am not familiar with the 407 but I would think it is a HDi, if so what you describe is an air leak from a pipe from the pressure side of the turbo, I have had this on a Saab, in that case there was an over pressure switch under the dash and the pipe fell off. Look at the top of the engine, on the inlet side there will be a pipe from the inlet trunking or manifold, it should (maybe with a tee piece in there) go through the bulkhead

May 18, 2010 | 2005 Peugeot 405

1 Answer

Peugeot 407 not 405 blocked windscreen washer


its in the pump it self mate ya have to take the pummp out of the bottle

Jan 17, 2010 | 2005 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

364 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...