Question about 2000 Chrysler Concorde

1 Answer

Vibration at low speed

'95 Chrysler Concord with vibration at low speed about 35 mph, and when decellerating. Vibration goes away at higher speed. Had front wheels rebalanced to no avail.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 79 Answers

ARE ONE OF YOUR WHEELS BENT? OR YOUR TIRES MIGHT BE THE PROBLEM ,YOUR DRIVE SHAFT MAY NEED TO BE BALANCED

Posted on May 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 EQUINOX AWD HAS A BAD SHAKE VIBRATION WOBLE IN IT WHEN ACCELERATING BETWEEN 35 AND 55 MPH GOES AWAY WHEN YOU LET OFF GAS, TOOK REAR DRIVE SHAFT OUT AND DROVE IT, STILL HAD SHAKE/WOBLE/VIBRATION


COULD HAVE LOW AND HIGH SPOTS IN THE BRAKE ROTORS.CHECK TIRES FOR DEFECTS.COULD NEED FRONT END ALIGNMENT OR BAD WHEEL BEARINGS CAUSE WHEELS VIBRATION.

Jun 09, 2011 | 2005 Chevrolet Equinox

2 Answers

I have a 2005 Honda CRV and get an intermittent vibration in the front end when going anywhere from 35-49 mph. Usually on straight road. Lasts for say 10 seconds then stops. New tires. Alignment if...


best guess is to have the CV joints checked, make sure that the boots are good in the outside joints. but it could also be the inside joint just has to much wear. you are at the right mileage for either to be the problem, the next time you get the vibration put a little pressure on the steering wheel in one direction then the other and see if the vibration goes away if it does suspect the CV joints. and don't just replace the outside joint replace both half shafts. if the vibration does not change or go away when you put pressure on the steering wheel then suspect lower ball joints.

Feb 03, 2011 | 2001 Honda CR-V

1 Answer

My 2003 Mazda Protege has 111,700 miles and makes a roaring noise with some vibration at around 20 mph but goes away when I accelerate to higher speeds. I have 17 inch custom rims with low profile tires on...


Bring in the car to a PROFESSIONAL shop. Mention your problem & ask about a wheel balance, alignment & make your problem clear before any work is done. Mention bearings etc. Ive dealt w millions of csrs at my own private shop & that would be your best approach. NO JIFFY LUBE TYPE SHOP

Mar 16, 2017 | 2003 Mazda Protege

1 Answer

Front wheels and steering wheel shake while driving


If you get a bad vibration in your steering wheel at low speeds without braking it is either a bad tire or a bad rim. If you get a vibration at speeds around 45-50+ and goes away you probably have a balance issue. If the vibration only occurs while braking then your rotors are warped. If low speeds it shakes i'd take it to a shop to check your tires.

Nov 20, 2009 | 2002 Nissan Sentra

2 Answers

I have a vibration in the front drivetrain on my Sorento. the vibration starts at about 30-35 mph and gets loudest at about 65-70 mph. The weird thing is that teh Vibration and associated noise completely...


ball joints or bent rim. Does it click or thunk when turning? It may be tie rod as well. You can lift it up and try turning wheel by hand and shake it to see how much play there is.
Check the there is a weight on the rim. Every one is supposed to have one.!!!!

Oct 27, 2009 | 2003 Kia Sorento

1 Answer

2003 envoy, low speed harmonic vibration in front end


hello have u rotated the tires front to rear then drive and see if u still have the noise and vibration if drive yes while driving slowely turn the steering wheel left to right just a small amount if the noise changes its probably a front wheel bearing if that doesn.t help drive the truck till you get the vibration then let up on the gas pedal does the noise go away if so you might have a bad u_joint but do the tires first how many miles???????

Jan 24, 2009 | 2003 Chevrolet TrailBlazer

2 Answers

Vibration in a 91 Jeep Cherokee Laredo


is there any play in the transfer case output shaft

Jan 06, 2009 | 1991 Jeep Cherokee Limited

2 Answers

2006 F 150 4x4 vibration in the front at low speed


drive shaft U joint is sloppy in the rear at the differential.

Dec 08, 2008 | 2005 Ford F-150

1 Answer

Front end vibration


It sounds as though your car has two seperate problems. The first problem with the vibration that goes away when you let off the gas pedal is caused by a bad INNER CV joint. It only vibrates when you are accelerating because that is when the joint is under stress. Your vehicle has two axles, each with an inner and an outer joint. My suggestion is to have a competent shop determine which is the bad side and replace the entire axle. The second vibration which occurs at any speed is most likely cause by either a bad tire, or a bent rim.

Jun 03, 2008 | 1998 Honda Civic

Not finding what you are looking for?
2000 Chrysler Concorde Logo

Related Topics:

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...