Question about 2000 BMW 3 Series
P1624- Pedal Position Sensor Potentiometer Supply Channel 1 Electrical.
The Siemens MSE43.0 Engine mamagement module is used on more than one model. The different meanings of the P1624 are based on your model.
The P1624 referenced here is for the MS43.0 engine management module with a note for M52 engines (323 / 328) that it is a coolant temperature below thermostat regulating temperature. You should have a M52 engine.
The MS42.0 engine mangement does not list a P1624 code in the Bentley manual.
The fault above cold be set due to the following:· Break/open in the wiring from the DME to the throttle motor(MDK).· The actuator or potentiometers inside the MDK could be contaminated.SOLUTION:
(If any of the faults listed are set) · Using a breakout box check for an open or short to ground in the wiring from the DME to the MDK.· If the wiring is intact then replace the MDK, then the adaptation values in the DME must be
cleared. Failure to do this will result in reoccurring faults.· Switch the ignition off for 30 seconds.· Turn on the ignition and delete the DME adaptations and the fault code
memory · Press the accelerator pedal to wide open throttle(WOT)4 times
MDK- motor driven throttle valve.
Posted on May 12, 2010
I have the code p16234 what exactly do i buy new thermostate or check wiring
Posted on Mar 29, 2011
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you can buy a cheap scanner that will put this light out,i have a mechanic working for me that stands on the roof ,tweeks the radio and has one foot on the brake whilst turning on the lights and he puts out nearly every service light you can think of but he wont show anyone least of all me,but if it its a 99 model iam sure you can put the light out by using a 12v electrical screwdriver with the light inside and a cable comes out the end with a clip .then going across the pins on the special BMW connector block it will go out with the resistance of the bulb across it ,but ??big but ?does it have an OBDII connector or the round BMW type because we dont have OBDII on pre 2005 cars here in spain .Now we do and guess what ??its all encrypted software used ...makes me a dinasaur
Posted on Aug 14, 2009
Tips for a great answer:
Dec 12, 2012 | 1999 BMW 323 Series
Sep 30, 2012 | 2000 BMW 3 Series
Feb 13, 2012 | Cars & Trucks
Jun 24, 2017 | Cars & Trucks
Jul 11, 2010 | 2000 BMW 3 Series
Dec 24, 2009 | 2000 BMW 3 Series
Dec 18, 2009 | 1999 BMW 323 Series
Sep 12, 2009 | 1994 BMW 3 Series
1,215 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: