Question about 1985 Chevrolet Camaro

1 Answer

Dash tempature gauge not working

Trying to find the wire under the hood for the dashboard tempature gauge on a 1985 camaro

Posted by on

  • cantafio2010 May 12, 2010

    thanks,i know that the wire is dark green but someone played with the wiring & i'm trying to find out on where it is coming out of the firewall,


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Engine size? maybe Dark Green, usually goes to the left cylinder head, near the exhaust manifold.

Posted on May 12, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the electric fuel pump relay located on a 1985 Chevy camaro 6 cylinder

If you have an electric fuel pump, it should be in the gas tank.

Nov 15, 2016 | Cars & Trucks

2 Answers

Location of fuel pump relay on 1985 chevy camaro

Fuel pump relay (if it has one) should be inside the fuse panel under the hood, and they are usually labelled.

Dec 29, 2014 | 1985 Chevrolet Camaro

1 Answer

92 Camaro gauges quit working after a spark under the dash while I was driving down the road. Checked fuses and none are blown. Lights on dash still work.


If all voltages checked ok, then most probably its faulty instrument cluster board on which gauges are connected. Yes if cluster circuit board looks ok, then also it can be faulty. Somewhere there is minute short or burn on board then such problem arises.

Also check the fuse box. One under hood and other under dash.

Inspect each and every fuse and see if all are fine or not.

Click the link below for complete step by step troubleshooting:----



Dec 14, 2012 | 1992 Chevrolet Camaro

1 Answer

Location of fuse for gas gauge and tempature gauge

somtime the fuse panel is on the driver side kick board under the dash. There is also a fuse box under the hood usually covered with a plastic cover. easily removed

Jul 30, 2012 | 1991 Nissan Sentra 2 Door

1 Answer

None of the dashboard lighton my or gauges work on my 1997 truck work .solution?

Try your fuse. Check for connection to harness. Check fuses under hood and inside under dash.

Dec 28, 2010 | 1997 Nissan King Cab

1 Answer

Tempature gauge does not work and the

In 1992 the sending unit should be fairly easy to find it should on the intake manifold near the thermostat housing. If you disconnect the wire going to the sender, it should be just one wire and it just pushes on the sender. Once you have it disconnected take a small jumper wire and connect the temperature gauge wire to ground (or the negative terminal of the battery). Now turn the key on, the gauge should go all the way to hot, if so the sender is bad. If the gauge doesn't move you have dash problems. Good Luck!

Dec 22, 2009 | 1992 Lincoln Mark VII

2 Answers

I need to know where the fuse box is located in a 1985 Oldsmobile Cutlass Ciera. Speciafically for the Power windows.

Under the drivers side dashboard, some were behind the glove box, and there may be one under the hood of the car in the engine compartment. Any GM dealer can direct you to the exact location on your car.

Aug 27, 2009 | 1985 Oldsmobile Ciera

1 Answer

Temp gauge in dashboard not working, truck not running hot, antifreeze not leaking

Try testing the heat sending unit, to do this pull the wire from the tempature sensor and ground the senor wire to a good ground, next turn key on and watch gauge, if it moves over to hot replace the sending unit, if it does not you have one of four problems, one a bad gauge and that I can give you instructions on how to replace it also if other gauges are not working it could be the voltage regulater in the dash,and that you would need instructions on how to fix it.

Jul 14, 2009 | 2001 Ford Explorer

1 Answer

Speedomerter and odometer are not working

may be some loose contact in wire,,try to take it a good car electrition,,and redo ur wiring for ur dash board

May 31, 2009 | 1998 GMC Jimmy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides