Question about 2005 Chrysler Sebring Conv

1 Answer

I have a 2005 Sebring touring. On my way home yesterday on the Hwy, my battery light came on. As i was nearing my house i pulled up at a light and my speedo was a 30MPH at a stop, the idle was up and down, when i pulled away from the light i was stuck in 1st gear, wouldn't shift. When i got into the driveway, i turn it off then tried restarting it again and nothing...about 20mins later i tried it again and it turned over, ran for about 5 mins and then died. I took my battery out and went and had it tested, it came up as bad. I bought a new one, and re-installed it. Car started fine and i test drove it around the block a few time and then the battery light came on again. This morning car started up fine, about 2-3 miles into the drive the battery light came back on again, for the rest of the drive the gear shifting was fine, at stop lights, idle and speedo were fine. ANY idea whats going on??? Thank you

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Alternator

Posted on Jun 02, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I change the starter for my 2006 Chrysler Sebring touring


You'll need a set of metric sockets and end wrenches. Then disconnect the positive battery cable. Wrap the terminal you removed from the battery in a rag and secure it away from the battery. Follow the positive battery cable down to the engine block. It will most certainly be connected to the starter. Remove the cable and any other small wires. Make a diagram showing where to reconnect them. Remove 2 14 mm bolts from the starter to bell housing. Remove starter. Reverse the procedure to install new one.

Jan 26, 2015 | 2006 Chrysler Sebring

1 Answer

2006 Chrysler sebring. It won't start but the battery checks ok. Does not even try to turn over. Most of instrument cluster does not light up, only odometer, brake and oil worning lights. power window


Check your relays,fuses,and especially your ground cable on the battery side and the block,try jumping a ground from the battery to the frame or body and see if it makes a difference

Apr 13, 2017 | 2006 Chrysler Sebring Touring

2 Answers

How do i get to my low beams on my chrysler 2005 sebring sedan i got to the high beams perfect but the low beams right next to it has a metal barrier surrounding it which makes it impossible


Unfortunately, the answer I have is not a happy one =(. My wife has a 2005. In order to replace the bulb you will have to pull the Crutons (plastic push pins) that hold the front bumber cover on, remove the Headlight housing & replace the bulb that way. Shame on Chrysler for making it so difficult, in my opinion. But I hope this helps you to change the bulb =)

Aug 26, 2011 | 2004 Chrysler Sebring

1 Answer

Well i have a chrysler 2005 chrysler sebring touring and my battery came on and I change my battery and alternator and the light stills come on if i have a/c on


DID YOU REPLACE THE BELT COULD BE A LITTLE WORN WHEN AC COMES ON IT PUTS TOO MUCH STRAIN ON BELT THEN IT SLIPS. OR YOU GOT A BUM ALTERNATOR OR BATTERY.TAKE IT TO AUTOZONE THEY WILL PUT ON THE MACHINE FOR FREE .

Aug 05, 2011 | 2004 Chrysler Sebring

1 Answer

Where is the battery on the 2005 Chrysler Sebring Touring Convertible?


Remove the drivers side front tire, in the wheel well liner there's a access plate to get to the battery.

Aug 23, 2010 | 2005 Chrysler Sebring Conv

2 Answers

2005 chry sebring crankshaft sensor location


The crank sensor is located behind the harmonic balancer or also known as the main drive pulley for your belts. You need to remove your belt and then remove this pulley to locate the crankshaft sensor

Jun 20, 2010 | 2005 Chrysler Sebring Conv

1 Answer

How to change head lamp to Chrysler Sebring Convertible Touring


Remove 2 screws holding the headlamp and pull forward.

Jun 04, 2010 | 2005 Chrysler Sebring Conv

1 Answer

How to find and remove the battery?


well its either on the passanger side under some stuff near fender well. take a flash light and look. if not then pull your LF wheel off and youll see a door in the fender well for the battery.

Apr 12, 2009 | 2005 Chrysler Sebring Conv

1 Answer

Trouble code (MIL) reset


just 10 flashes means that the OBD readiness monitors have not all been set.. when the battery was disconnected it reset the monitor status to not ready..

Jan 28, 2009 | 2005 Chrysler Sebring Conv

Not finding what you are looking for?
Cars & Trucks Logo

267 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...