Question about 1991 Honda Prelude

1 Answer

How do you find tdc for a 1991 honda prelude 2.1

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 775 Answers

Remove the #1 spark plug. rotate the engine in the direction it rotates when operating. use a socket and ratchet on the crankshaft bolt. while cranking, place your finger over the spark plug hole. when you feel pressure building. insert a wooden dowel into the hole and contact the piston. while holding the dowel against the piston, continue cranking while observing the dowel. when the piston reaches the top, the dowel will stop and begin reversing direction. when it starts reversing direction, stop and crank it back to the top. go slowly when performing all steps. obviously this procedure works best with 2 people.

the #1 plug should be the first one at the front of the engine. if you remove all plugs it will be easier to turn.

Posted on May 12, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tbc dash light meaning for honda


Hello,
I don't know of a TBC light for Honda but there is a TDC... If that's what you meant to type. Its the "Top Dead Center" sensor

The TDC (top dead center) positioning sensor is another name for your crankshaft position sensor. This sensor measures the position of your crankshaft and helps with the proper firing of your spark plugs when you start your engine. The TDC sensor on the '97 Honda Accord is located on the underside of the engine block. Replacement TDC sensors can be purchased at your Honda dealership. This is not a difficult repair and can be done in about 15 minutes.

Read more : http://www.ehow.com/how_7918547_replace-sensor-1997-honda-accord.html

I hope that helps.... Have a great weekend

Sep 27, 2015 | 1994 Honda Prelude

1 Answer

How to set crankshaft timing on 1992 honda prelude 2.3 liter?


here is a u-tube video with a good tip for making sure the timing marks dont get move once set may help
How to replace timing belt on Honda Prelude 92 96 2 3 lt H23a1

Jul 28, 2014 | 1992 Honda Prelude

1 Answer

My 1991 Honda prelude has lost a headlight ground. Where is it?


There are fuses for the headlights, right and left. G201 is the ground connection number. I have no picture but its located RH Center of eng compartment. Usually on the radiator support.

Dec 16, 2009 | 1991 Honda Prelude

2 Answers

1991 honda prelude speedometer not working,what is


Probably the Vehicle Speed Sensor (VSS). Cheap and easy to change (see ebay), once found! Probably on top of gearbox, to rear.

Aug 06, 2009 | 1991 Honda Prelude

1 Answer

Where is the thermostat located on a 1991 honda prelude


its located on the upper radiator hose. You could see a joint in which the hose is attach. remove the 2 bolts and make sure after replacing it to seal it properly before bolting it back.

Jul 10, 2009 | 1991 Honda Prelude

1 Answer

My onlu transprotation


look at your timing belt if its not that check your rotor make sure its tight

Feb 19, 2009 | 1991 Honda Prelude

1 Answer

91 prelude 2 door coop


the pump is located in the gas tank.

Dec 16, 2008 | 1991 Honda Prelude

1 Answer

I have a 84 honda prelude cannot find TDC on the crankshaft gear need help


You line up the crankshaft at TDC byaligning the marks on the flywheel/flex plate with the pointer on the bellhousing. On the radiator side of the engine block where it bolts to the trans mission about half way up there is a rubber plug witch you can remove to gane access to the pointer on the trans bellhousing to line up the timing marks

Nov 30, 2008 | 1984 Honda Prelude

2 Answers

Spark plug gaping


Go to your nearest Autozone or other parts house and buy an inexpensive plug gapper. I gap the Honda plugs at .045 .

Jun 16, 2008 | 1991 Honda Prelude

Not finding what you are looking for?
1991 Honda Prelude Logo

Related Topics:

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...