Question about 2003 Ford Escort

Open Question

Clutch master cylinder leaking on citreon xsara picasso

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1596 Answers

SOURCE: How do I bleed the clutch master cylinder

Same as You Bleed Any other System Being carefull not to get air IN and IT sometimes TAKES FOREVER ________ STICK WITH IT ------ Took Me 2 hours One time

Posted on Jan 19, 2009

Ad
  • 10 Answers

SOURCE: ford focus st170 clutch master cylinder

To replace the clutch master, you must remove the under hood fuse box and air filter housing assm, then remove the hydraulic line that goes into the inlet port of the clutch master, then inside the car, remove the hush panel/knee bolster panel from under the steering column, and loosen the boilts that retain the brake pedal to the firewall, then remove the two 10mm bolts that secure the clutch master to the brake pedal assm. Reverse procedure ti install, then fill the brake master cylinder with clean fluid, loosen the bleeder screw at the top of the trans, and bleed the clutch as you would the regular brake system, but never pump the pedal, tighten screw, with foot off of clutch pedal open screw and press pedal to floor, then tighten screw before you release pedal, then release pedal loosen screw, etc. until no more air comes out, it may take quite a few times to fully bleed the system.

Posted on Feb 07, 2009

redbeard00
  • 957 Answers

SOURCE: clutch master cylinder

The master cylinder is mounted directly behind the clutch pedal in the fire wall. A push and twist design. If you are intending to remove it don't forget to unplug the sensor(mounted on the rod) first.

Posted on Apr 26, 2009

  • 12 Answers

SOURCE: Air con clutch not cutting in.

get the pressure checked, chances are it needs topping up

Posted on Aug 13, 2009

  • 279 Answers

SOURCE: citreon picasso hearter blower not working

has your picasso got climate control? if so you probably have a faulty ignition switch
the contacts in the switch which supplies the live to the heater wear and cut the supply

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need the torque setting for my citreon 1.8 16v cylinder head petrol


If you buy head gasket the setting will be included. I believe you will torque to a given torque then tighten a further angle (probably 120degrees.)

Jan 26, 2015 | 2004 Citroen Xsara Picasso

1 Answer

How much does it cost 2 have a clutch replaced on a citreon xsara


Before you race out and replace the clutch which will not be cheap for your car have a good look at the slave cylinder for leaks . Check and bleed the clutch system and have the clutch m/cyl checked. Crunching gears means the clutch system is not disengaging properly

Apr 08, 2013 | Cars & Trucks

1 Answer

Where is the HEATER BLOWER MOTOR FAN CONTROL UNIT on the citreon Xsara picasso 2005


Resistor pack is located in the lower heater fan housing and is accessable from foot well either drivers or passangers (could be either side) plate held on by some Torque screws

Jan 04, 2013 | 2005 Citroen Xsara Picasso

1 Answer

Citreon picasso 2.0 hdi alternator belt diagram


need a fan belt rout for a xsara picasso 1.6 2001

Aug 08, 2012 | Citroen Xsara Cars & Trucks

1 Answer

Can you put a vin code into a non citreon cd player


no.
if its an after market product. there is no need for code

Jul 01, 2012 | Citroen Xsara Cars & Trucks

1 Answer

Air con clutch not cutting in.


get the pressure checked, chances are it needs topping up

Apr 23, 2009 | 2006 Peugeot 504

Not finding what you are looking for?
2003 Ford Escort Logo

Related Topics:

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...