Question about 2004 Kia Sorento

1 Answer

Antifreeze squirting out and getting flung all over engine compartment by fan. Overflow tank was dry ,filled it up, drove 10 miles home and was dry again

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 957 Answers

You will probably need to take it to a shop if you can not identify the leak yourself. They will pressure test the cooling system and identify where the antifreeze is leaking from. I could guess that it is the radiator or the water-pump but you will need to find out. Good luck.

Posted on May 12, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The heater wont heat up no more


My first thought is that your radiator is low on antifreeze. there may not be enough in there to circulate properly. sometimes the heater will warm up if that is the condition, and you race the engine a couple times and feel warm air coming out for a few seconds. other problems may be (in probable order) you have a plugged heater hose. this can happen any time after 80,000 miles or so. another may be your water pump. that should last 100K miles or more. and finally a vacuum problem where the dampers in your dashboard will not move leaving one setting on for example you have defrosters but nothing else. that is of course if your fan blower is operating. warning. if you want to check the radiator. first check the plastic overflow tank under the hood to see if there is antifreeze in that. if not WHEN THE ENGINE IS COLD remove the cap on the radiator and fill it first, then fill the overflow tank to the line. recap the radiator then run till warm, and check heat. after that keep an eye on the ground when you park to be sure you don't have a coolant leak

Nov 16, 2015 | Cars & Trucks

1 Answer

2004 Audi A4, 1.8 T Continued Cooling System Issues


The best test for this is a cooling system pressure test. You need to have that done. The other thing to check are the freeze plugs.

Feb 20, 2014 | Cars & Trucks

1 Answer

Leaking coolant after radiator replacement


If you are talking about the reservoir that hose is the overflow hose.
Its possible the shop did not release all of the air pockets from the system and some coolant came out with the air bubbles.
The tank should be about half full hot and cold.

Jul 18, 2013 | 1998 Chrysler Concorde

1 Answer

AC Problems & Melted Overflow Tank


Trust you mech on this one.

Jul 09, 2012 | 1999 Acura TL

1 Answer

Just filled the gas tank in my 2006 f-350 turbo diesel super duty (6.0), started the truck and the guage showed a full tank. Drove down the road about 1/10 of a mile and the guage dropped to dead empty...


A loose connection on the sending unit could cause the problem but also moisture in the tank in cold weather could also be a factor in which i would add fuel line antifreeze to a full tank of fuel..........Hope this helps you out.

Dec 17, 2010 | Ford F-350 Super Duty Cars & Trucks

1 Answer

1999 Olds Alero 4 cyl running hotter than normal. One mechanic says it's Heat sensor that opens and closes. The other mechanic who ran car says it was thermostat that turns on dual fans. Ok well one was...


REPLACE THERMOSTAT.ITS STICKING CLOSE TO KEEP COOLANT FROM CIRCULATING THROUGH ENGINE AND RADIATOR. THE FANS SHOULD COME ON WHEN VECHICLE SETTING AT A LONG IDLE.THE COOLANT TEMPERATURE SENSOR GET TO CERTAIN TEMPERATURE WHICH WILL COMPLETE CIRCUIT PCM SEND POWER TO COOLANT SENSOR THEN TO COOLANT FANS RELAYS AND FANS.IF VECHICLE OVER HEATING WHILE MOVING THERMOSTAT FAULTY.IF YOU TURN AC AND COOLANT FANS DONT RUN CHECK COOLANT FANS FUSE AND RELAY.IF COOLING FANS DONT TURN ON WITH AIR CONDITIONER ON EITHER COOLANT TEMPERATURE SENSOR FAULTY OR PCM FAULTY.IF ALL LOOKS GOOD.IF ENGINE OIL LOOKS LIKE MILK SHAKE.YOU HAVE BLOWN HEAD GASKET.

Nov 11, 2010 | 1999 Oldsmobile Alero

2 Answers

Where is the thermostat sensor


Both the 4.0L and 4.7L engines use 195� thermostats for all model years from 1999-2004. When replacing a thermostat it is very important to install one with the same temperature rating (the only exception might be with certain performance modifications or chips that recommend or require a different temperature thermostat).

4.0L engine - Draining the cooling system WARNING: DO NOT REMOVE THE CYLINDER BLOCK DRAIN PLUGS OR LOOSEN THE RADIATOR DRAINCOCK WITH SYSTEM HOT AND UNDER PRESSURE. SERIOUS BURNS FROM COOLANT CAN OCCUR.

1. DO NOT remove radiator cap first. With engine cold, locate radiator draincock on the right lower side of radiator facing to rear of vehicle.
2. Attach one end of a hose to the draincock. Put the other end into a clean container. Open draincock and drain coolant from radiator. This will empty the coolant reserve/overflow tank. The coolant does not have to be removed from the tank unless the system is being refilled with a fresh mixture. When tank is empty, remove radiator cap and continue draining cooling system. To drain the engine block of coolant, remove the cylinder block drain plug, located on the side of cylinder block below the exhaust manifold.

4.0L engine - refilling the cooling system Coolant recommendations and cautions: The recommended mixture is 50/50 ethylene-glycol and low mineral content water. Never use pure antifreeze. Only Mopar Antifreeze Coolant, 5 Year/100,000 Mile Formula (glycol base coolant with corrosion inhibitors called HOAT) is recommended. This coolant offers the best engine cooling without corrosion when mixed with 50% distilled water. Antifreeze mixture must always be at least 44%, all climates year round. Maximum protection (-90d) is provided with a 68% mixture protection. If the percentage is lower than 44 percent, engine parts may be eroded by cavitation, and cooling system components may be severely damaged by corrosion. CAUTION: Mopar Antifreeze/Coolant, 5 Year/100,000 Mile Formula (MS-9769) may not be mixed with any other type of antifreeze. Mixing of coolants other than specified (non-HOAT or other HOAT), may result in engine damage that may not be covered under the new vehicle warranty, and decreased corrosion protection.

CAUTION: Do not use coolant additives that are claimed to improve engine cooling. 4.0L coolant capacity: 1999-2000: 13.0 qts. (including 2.3 qts. for resevoir) 2001-2004: 15.0 qts. (including 1 qt. for resevoir)

1. Tighten the radiator draincock and the cylinder block drain plug(s) (if removed).
2. Fill system using a 50/50 mixture of ethyleneglycol antifreeze and low mineral content water. Fill radiator to top and install radiator cap. Add sufficient coolant to the reserve/overflow tank to raise level to FULL mark.
3. With heater control unit in the HEAT position, operate engine with radiator cap in place.
4. After engine has reached normal operating temperature, shut engine off and allow it to cool. When engine is cooling down, coolant will be drawn into the radiator from the reserve/overflow tank.
5. Add coolant to reserve/overflow tank as necessary. Only add coolant to the reserve/overflow tank when the engine is cold. Coolant level in a warm engine will be higher due to thermal expansion. To purge the cooling system of all air, this heat up/cool down cycle (adding coolant to cold engine) must be performed three times. Add necessary coolant to raise tank level to the FULL mark after each cool down period.

For more details, you can refer to the Jeep WJ Service Manual Section-07-Cooling-System-Ewj7

Hope helped.

Nov 02, 2009 | 1999 Jeep Grand Cherokee

2 Answers

460 overheats


Sounds as if the head gasket is leaking compression pressures into the cooling system. It seems that this problem has just occurred recently. This can be checked at your rad shop. They have a tool that uses a chemical solution that changes color if there is any engine gases present in the coolant.

Jun 10, 2009 | 1989 Ford F 250

1 Answer

Antifreeze comes out overflow and the van gets hot idling


THERMOSTAT FAULTY...OR ELECTIC COOLING FAN FOR THE RADIATOR...HOPE I WAS OF SOME HELP TO YOU.....

Feb 05, 2009 | 2001 BMW 5 Series

Not finding what you are looking for?
2004 Kia Sorento Logo

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76673 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...