Question about 2006 Nissan Altima

1 Answer

When i try to start the car up it wont turn over and i just put a new battery on it and i got the starter tested and it was good

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 107 Answers

If its an automatic trans try starting in nutural WITH YOUR FOOT ON THE BRAKES or if its a 5 speed make shure you are pressing the clutch to the floor if that dosn't work shange the starter silinoid elect. is a real hastle to figure out These are the steps I would take before throwing money at it good luck CJ

Posted on May 12, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: wont start, new battery, relay good, starter good.

Check the Starter Solenoid mounted near the battery.Check it out in the dark...have someone try to start it and see if it sparks at the solenoid.connections may be loose.Also check/wiggle wiring harness to starter.

Posted on Apr 19, 2009

  • 6982 Answers

SOURCE: 02 chevy trailblazer 4.2l car wont start installed

You need to establish that you have 12v in the battery and that all connections are clean and secure. Lights horn etc do not give you voltage verification...your starter uses more amperage than anything else in the car. Once you are certain that everything is OK, check for 12v at the small wire on the starter with the key turned to start. If no volts, check the neutral safety switch or clutch switch Then check ignition switch for power in/out.

Posted on Jun 09, 2009

  • 18 Answers

SOURCE: 1999 Ford Taurus Wont Start

replace starter solenoid

Posted on Nov 23, 2009

SOURCE: Car wont start: 1. Had it tested technician sad

Either you have poor connections at the battery or starter, bad battery cables or a bad starter. I wouldn't be the first time a remanufactured starter didn't work right out of the box.

Posted on Jul 14, 2010

  • 474 Answers

SOURCE: put in new alternator 98 ford taurus dohc car will start thn stop

Check ground wire from engine to frame and battery to body

Posted on Jul 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New Battery/starter and still wont crank.


car wont crank or car wont start? I would say your battery cables are bad,, acid gets in from battery and erodes internal cable parts... need a Meter to check it out.. put the meter on battery while someone tries to start it, if the voltage drops from 13.5 to 10 then it is trying to turn over, I always have the new starters tester before I leave a store, they are remanufactured in Malaysa and they use old parts in most of them..

May 06, 2015 | 2001 Pontiac Grand Prix

2 Answers

99 tahoe wont crank wont start with new battery


Does starter click? Try turning on headlamps and get someone to watch as you try to start car. If headlamps dim, likely bad starter or battery cable(s). If they don't dim, bad solenoid, starter switch, neutral safety switch. Try starting in neutral and jiggle shifter while trying. If it starts, replace neutral safety switch.

Dec 01, 2014 | 1999 Chevrolet Tahoe

2 Answers

1999 ford explorer wont start. battery is new.wont start when jumped. it tries to turn over but barely. then only hear a click. when you turn the key the dash lights and radio lights flicker on an


Sounds like starter motor given your slow to no turnover, I assume your new battery has full charge, if not, check with meter, it may be a defective battery, or another issue with connections, did you clean cable connections when you put in new battery? I assume your engine was running properly before battery change and is not partially seized due to overheating or low oil.

Good luck,
Asthma-Free-Home.com

Nov 16, 2014 | Cars & Trucks

2 Answers

I put a new starter in my 99 buick lesabre an a new battery and it wont turn over it just clicks can u help me out.


First thing put socket on crankshaft bolt ,it in center of bottom pulley which crank pulley. And turn motor, to see motor is locked up. Next be your battery cables and posts on battery good clean and tight.

Feb 17, 2012 | 1999 Buick LeSabre

2 Answers

06 pontiac grand prix wont start no clicking when you turn the key over even jump starting the battery, has dash lights & radio & parking lights. battery tested good. put a used starter & altinator on


Used parts such as starters and altinators don't last. It might **** but it sounds like you need to buy a new starter,altinator, and battery. Or just start with buying one at a time.

Dec 06, 2011 | 2006 Pontiac Grand Prix

1 Answer

Truck will start for two weeks then wont. put a new starter in it ran for two weeks then wont start again. old starter tested bad so replaced it. put a new one in and coil pack ran for few weeks then won't...


check alternator output at the alt and at battery also put a test light on the starter solenoid at the little wire on solenoid see if it lights up when turn key ? possible positive or negative cables have good ohm checks but not carrying enough current ?

Jun 01, 2010 | 1998 Chevrolet S-10 Pickup

2 Answers

Truck wont start, new battery, good fuses, bench tested starter they say its good, cables look ok.Turn ignition and dash lights come on can hear fan motor running.


test starter solinoid wire from harness, with a helper put test light on wire get friend to turn key to start, light should light up, wires at the bottom of engine may (look) fine

Apr 25, 2009 | 1989 Chevrolet C1500

2 Answers

Wont start, new battery, relay good, starter good.


Check the Starter Solenoid mounted near the battery.Check it out in the dark...have someone try to start it and see if it sparks at the solenoid.connections may be loose.Also check/wiggle wiring harness to starter.

Apr 18, 2009 | 1995 Jeep Wrangler

1 Answer

Starter tested good but still wont start


test you battery at parts store they can load test it for you headlites int lights are nominal draw. wipers blowers pull a little more current. but have it tested under load which duplicate the significant draw of a starter.

shack

Apr 16, 2009 | Hyundai Motor 1996 Elantra

Not finding what you are looking for?
2006 Nissan Altima Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...