Question about 2000 Isuzu Rodeo

1 Answer

I need to change the fuel filter on my 2000 isuzu rodeo. How?

I need to change the fuel filter on my 2000 isuzu rodeo. How do I do it?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 18 Answers

It's located just under the driver side door, and then behind the outermost frame bar. The new one will denote which direction to install it. I recommend grabbing some rubber sheathed hose clamps from the store while you're there.

First locate the bleeder valve on the fuel rail.

It's just underneath the plastic cover on the engine, follow the silver rail that runs across the front and goes back on both sides, it's on the right side, just under the left-side blue refrigerant valve cover. Open the cover (black) and be sure to have a rag under and on top of it as you use a screwdriver to release the pressure on it - just push the pin in the valve. Air will come out, then a little gas, so be ready. Replace the cover.

Open your gas cap. Now the pressure is off of both sides.

Use the clamps to close the lines going into it, in and out. Clamp them about 3 or 4 inches from the filter, to leave yourself room to work.

Remove the bolt on the mounting bracket, it will take a socket to get it, as salt and other road juices will have rusted it pretty well since the last time it was changed. Please don't try to use an adjustable wrench, unless you really want to punch the underside of your car.

Factory hose clamps, self explanatory. Vice grips are good for this.

Use the vice grips to gently wrench the hose from the filter. This will take some work, it's on there very tight from the existing pressure in the lines. just don't clamp them so tight that it might tear them. Just hand tight and wiggle back and forth.

When it comes off, gas is going to spill out, be ready. Quickly replace the filter and replace the factory hose clamps, remove yours, and remount it in the bracket.

Close your gas cap!

Start your car a few times to get the pressure back in the lines, and you're all set.

Posted on Aug 15, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Access to fuel pump on 2000 Isuzu rodeo


The attached videos are for a 2001 but the 2000 will be the same.


2001 Isuzu Rodeo Fuel Pump Replacement Part 1

2001 Isuzu Rodeo Fuel Pump Replacement Part 2


BE CAREFUL!
Semper Fi,
Z

May 01, 2017 | Isuzu Cars & Trucks

1 Answer

How much oil do I need for the oil change in my 2000 isuzu rodeo 3.2l


hello dgulihur: My name is Roger and i will help you. Your Isuzu holds 5 qt.s oil when filter is changed at the same time. If you have further questions please just ask. Please rate the answer. This way I know it was helpful. Thank You for using Fix Ya. Roger

Jul 06, 2010 | 2000 Isuzu Rodeo

1 Answer

2000 Isuzu Rodeo ls V6 4 wheel dr.


Check the fuel pressure it could be the fuel pump or pressure regulator.

Apr 28, 2010 | 2002 Isuzu Rodeo Sport

1 Answer

I have a 2000 Isuzu Rodeo, V6. The car stalls at


it's the EGR valve and can be fixed by anyone. It involves disconnecting the battery, remove electrical connection, and removing 2 screws and cleaning the surface area well and replacing it as well as the gasket. A new EGR valve runs around $120 and trust me you can fix this and save hundreds!

Feb 02, 2010 | 2000 Isuzu Rodeo

2 Answers

What parts are replaced when doin a tuneup for a 2000 isuzu rodeo


Apart oils and filters, everything that's worn out or past it's lifetime: coolant, steering and brake fluid - 2 years; timing belt - 50000 miles or 5 years; brake lines - recommended replacement every 5 years.

Dec 02, 2009 | 2000 Isuzu Rodeo

2 Answers

2000 Isuzu Rodeo Stalls without warning or other "symptoms"


hello, more than likely it is a fuel filter or a loose battery cable, the filter is maintanance and should be changed regardless, good luck...marty

Jun 04, 2009 | 1999 Isuzu Rodeo

2 Answers

Isuzu Tune up


Spark plugs every 100,000 miles, air and fuel filter 30,000 miles, inspect ignition system components when plugs are changed, replace as necessary.

Mar 19, 2009 | 2000 Isuzu Rodeo

1 Answer

NEED INSTRUCTION ON REPLACING FUEL FILTER ON 2000 ISUZU RODEO


try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Mar 19, 2009 | 2000 Isuzu Rodeo

Not finding what you are looking for?
2000 Isuzu Rodeo Logo

565 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...