Question about 1994 Ford Bronco

1 Answer

1994 BRONCO WONT START - REPLACED DIST, CAP, AND COIL. RUN GOOD IN THE MORNING. ONCE HOT WILL NOT START

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,033 Answers

Sounds like the timing is off

Posted on May 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would be the cause of my low crank no start problem?


If your dist cap get to be like the first on 4 days after you could have a bad ignition coil

Mar 22, 2015 | Cars & Trucks

3 Answers

1994 mustang gt auto trans keeps stalling while


replace fuel filter and if it continues have pump pressure checked

Sep 09, 2014 | 1994 Ford Mustang

1 Answer

1994 mustang gt auto trans keeps stalling while driving sometimes just when warming it up. Check engine light does not stay on when running. Replaced dist, rotor, cap, coil and had ignition module tested....


check for a fuel flow problem( pump pressure-filter blockage-injector/s) run fault codes ( check for HO2S and O2S sensor operation.. Check cat converter is serviceable Blocking exhaust system

Sep 09, 2014 | 1994 Ford Mustang

1 Answer

We have 94 bronco with a straight six! What can cause a carborated motor to run fine then just shut down while driving? We thought it was vapor locking and replaced the line with a rubber one. Then it did...


more than likely it a a cngine control module issue. in 1994 i beliee it is on the side of the distributo..about 10 wires going to it..once hot you would lose spark, once cool would start again

Jun 16, 2011 | 1994 Ford Bronco

2 Answers

Will turn over but not start have replaced plugs wires dist.cap rotor ignition module


Do you have spark??? if so, check fuel pressure, these trucks must have 60 psi to run, 50 psi will not work,.

Feb 06, 2010 | 1999 GMC Sierra

2 Answers

1994 volvo 850 has no spark, was running and died. Have checked everything back to the computer. Is it possible to check Computers?


Yes,it is possible with diagnostic equipment.In your case you heed to check ignition amplifier and coil.They are together.

Dec 02, 2009 | 1994 Volvo 850

1 Answer

1994 Nissan Altima Stalls intermittedly at startup


tell your mechanic to look up Service Bulletin #96-032 this could fix your problems

Oct 05, 2009 | 1994 Nissan Altima

1 Answer

1994 chevy suburban, no fuel coming from fuel


Put an injector noid light at the injector plug terminals to see if your getting a signal from the PCM(computer).If not try to find a computer from the same vehicle that works and swap it into yours to check.A PCM swap will take about 15minutes.

Sep 23, 2009 | Chevrolet Suburban 1500 Cars & Trucks

2 Answers

Weak spark from dist cap to plugs. spark from coil primary is as it should be. Plugs were carbon fouled from rich condition. this is a 92 bronco 5.8 windsor motor.changed out plugs,cap,rotor,and remote tfi...


The engine is definitely in an over rich fuel condition if you are blowing black smoke. I would suspect a bad 02 sensor, but the flooding condition you describe at starting could be other things. I would check the codes and proceed from there.

Jul 13, 2009 | 1992 Ford Bronco

2 Answers

Weak spark + 1988 ford bronco


check the voltage of the b+ terminal of the ignition coil (primary side) with a cheap multimeter while cranking. low voltage to the primary will cause low voltage on the secondary. also recheck all ground paths from the ignition module. ensure good connection from coil to module. note: new parts are not "known good parts" until it runs.--> IG.MOD.

Dec 17, 2008 | 1994 Ford Bronco

Not finding what you are looking for?
1994 Ford Bronco Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...