Question about 2004 Chevrolet Cavalier

1 Answer

All my gages go wack like my gas gage don't work or water temp always high

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

Its

Posted on May 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My engine overheating problem is in my 2000 land rover. The fan is running and the electric fan comes on at correct engine temperature. After start up the engine runs normal the temp gage rises slowly to...


the usual suspects are:
stuck shut thermostat
clogged raiator
dead water pump
low coolant level
it's sunday, rovers don't work on sunday.
Then again, maybe its wednesday, rovers take half a day then. 25322555-21syibu3fgwpdxocjnkpw0ib-5-0.jpg

Dec 15, 2014 | Cars & Trucks

1 Answer

2002 Buick Rendezvous over heating randomly


Don't worry about the fan. I think you have a bad temp sender unit. Replace that and see if it helps the stalling also. If not, go for an engine analysis. They will check for trouble codes and check engine sensor functions.

Oct 17, 2012 | 2002 Buick Rendezvous

1 Answer

'92 Nissan hardbody temp gas gage don't work any


Check for the the temp unit on cylinder head. put the wire on cylinder head and check if the gauge is working

May 17, 2012 | 1992 Nissan Pickup

1 Answer

Cluster problem,transmation temp gage ,engine temp gage not working but in info message center flashing other problem like battery voltage flashing but working gage no high beem indecater only sometimes...


This sounds like a few problems, the first thing i would is to have the computer scanned for any storeed codes, have the engine computer and body computer checked then scan the cluster for any problems, these trcks had a few problems with the cluster and the throtlebody just to name a few things, start with the scanning then maybe replace the cluster, on most of these newwer trucks the replacement cluster must be program to truck inorder for the truck to run correctly and cluster to operate correctly. hope this is helpful also check with your dealer for any recalls on this cluster problem you may be able to get free repairs.

Jan 10, 2011 | 2002 GMC Sierra 1500

1 Answer

Water temp gage sometimes it works and sometimes it doesn't


Likely the temp sending unit has failed. They aren't very expensive. One on 4.0 engine is on the thermostat housing but don't know which engine you have.
Blower problem could be the resistor pack but not sure exactly where it is on yours, it is always on the heater box and generally looks like a flat fiber plate with four wires going to it.

Dec 02, 2009 | 2002 Jeep Liberty

1 Answer

What is the check gauges light


CHECK GAGES light (1) indicates a potential engine failure(low oil pressure, low coolant, coolant overheating) has occurred.
· Check gages and shut down engine. Gages should read as follows: Oil pressure 5 to 10 psi (34 to 69 kPa) at idle; Water Temp gage below 230 degrees (110 C).
· Check engine oil level (Para 2-11) if OIL PRESS gage indicates low reading. Check coolant level (Para 2-11) if Water Temp gage indicates high reading. Notify Unit Maintenance if levels are low.

If CHECK ENGINE light (2) is on, check engine oil pressure gage (3) and water temperature gage (4). If both indicate normal, proceed with mission and then notify Unit Maintenance. If either one does not indicate normal, stop engine immediately and notify Unit Maintenance


Oct 16, 2009 | 1999 GMC Jimmy

2 Answers

Water temp gauge stay on 160 degree


should be fine as long as the gage goes up and down and you get heat it should be fine make sure you consider the outside temp. as the engine starts it will heat up get really hot the the thermostate opens and the gage will fall and should but not always stay low it could just be the ip gage.

Dec 28, 2008 | 2005 Chevrolet Silverado 1500 2WD

1 Answer

2002 OLDS SILHOUETTE


The problem is usually one or the other.  Both get 5 volts from the engine computer.  If the problem is the gas gauge, you'll have to change the sender in the tank.  Generally, an aftermarket pump/sender unit is $150-175.  Get one and drop the tank to install.  The temp gauge is another matter and it could be dirty coolant.  If both are going nuts together, you'll need a new computer.  Junk units are fine.

Jun 14, 2008 | 2002 Oldsmobile Silhouette

Not finding what you are looking for?
2004 Chevrolet Cavalier Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...