Question about 1994 Oldsmobile 88

1 Answer

Vehicle cranks and starts and it will run but then it will die and start back again

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Oldsmobile Master
  • 3,854 Answers

Start with the simple and replace your fuel filter. A dirty fuel filter will restrict your fuel flow and will give you what you have described.
Here is a link for you to retrieve any DTC codes that may causing your engine's issues, but a dirty fuel filter will not show up as any codes.
http://www.troublecodes.net/GM/
Thank you for using fixya and keep me posted.

Posted on May 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 Buick lesaber runs good all sudden dies wont run Windows won't go up or down?


When it suddenly dies an wont run , is this a permanent situation or will it start an run again at a later time ? Do the windows not working only happen when it dies or is this all the time regardless of vehicle suddenly dying ? When it dies you have to find out what is missing Fuel , spark etc.. Find this out an test the appropriate system ! Check all wiring harnesses underhood for proper routing an no bare wires touching ground ! An do a wiggle test on the wiring harness with it running or with someone cranking over the engine to see if it acts up or starts ! How long does it run before dying ?

Jun 01, 2015 | Buick Cars & Trucks

1 Answer

1998 oldsmobile bravada no start battery light on


The Battery light will be on since the engine is not running. The Light goes out when the Alternator is turning to produce the power required to run the electrical components for the vehicle.
I would start with making sure you have a Good Ground for the Vehicle. It sounds like you have either a Fuel Delivery Issue or Ignition System Issue.
Fire = Oxygen, Fuel, Spark. Take away any of these 3 and it will not run.

Mar 01, 2014 | 1998 Oldsmobile Bravada

1 Answer

Won t start


run the fault codes and look for faulty cam/ crank position sensor as this is indicated by the backfire/hard start and lower idle RPM. Check that battery terminals are clean and tight..

Sep 22, 2013 | Pontiac Montana Cars & Trucks

1 Answer

It will not start will crank but will not start no fuses are blown.


Hi Jeremiah take the vehicle and have a diagnostic scan and fuel pump pressure test carried out. At the same time replace the fuel filter. I believe the problem will become evident after the tests and very likely be the fuel delivery. Regards John

Jun 24, 2012 | 1998 Kia Sportage

2 Answers

1990 Ford Ranger Stalling


if it were me I would start with the idle air controll sensor, this is a real humdinger on fords. also clean out your throtle body really good.

let me know

tepfy

Apr 22, 2009 | 1990 Ford Ranger SuperCab

1 Answer

1991 Mazda 626 DX dies suddenly after running for 10 minutes.


Hello, It sounds like an engine ignition control module gone out or a coil. They get hot and quit working after a short period of time, cool off then work again till they get hot.
Is the ignition system pointless electronic or does it have points? Are you getting any fire at all now to the cylinders? Does the tach in the vehicle show any RPM's during cranking? Do you have voltage at the positive side of the ignition coil? Does the coil meet the ohm ratings for that years vehicle ignition? Does the vehicle have oil in it so the oil pressure sensor allows the engine to run, this may not be an option on your particular vehicle? You can check most of this out with a volt/ohm meter. Check your voltages before starting the vehicle, during running and after it quits to see where the loss is. Just don't get near the center tap of the coil or you will get a rude awakening and/or serious injury. Good luck, RAC

Apr 05, 2009 | 2000 Mazda 626

1 Answer

Starts and immediately dies


i seen in gm manual when you exchange crank sensor .it have to be reset or relearn again. using a tech 2 scanner.

Mar 29, 2009 | 2000 Chevrolet S-10

5 Answers

CAR CUT OFF WHEN DRIVING


Have u checked for spark? U can pull a plug wire off, install a plug in the wire (saves u from taking a plug out), place plug on metal surface, crank engine while someone watches for a spark. If no spark check coil and ignitor (inside distributor). If u have spark check to see if u have gas making it to plugs. Crank engine over (no more than 10 seconds, give it a 10 second rest, try again for 10 sec. etc, ) After doing this for several minutes, pull a plug and check it--it should be wet from gas. If the plug is dry, u aren't getting gas (change fuel filter, check fuel pump). countrycurt0

Sep 27, 2008 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...