Question about 2002 Dodge Durango

1 Answer

0441 code dodge durago

I have a code 0441 i already changed the gas cap what else

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

P0441 has nothing to do with the gas cap. You may have a problem with the Leak Detection Pump, Purge valve or hoses connecting all of it together. Have a repair shop check it out. Guessing gets expensive.

Posted on May 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trouble codesp0441


0441 is incorrect purge flow ( insufficient or excessive vapor flow detected during evaporative emission system operation.

Aug 11, 2014 | 2005 Jeep Liberty

1 Answer

2003 DODGE DURANGO CHECK ENGINE LIGHT ON, CODES P0456, P0562 & P0700, ALREADY REPLACED GAS CAP, HOW CAN I FIX?


Is not a gas cap,could be clog cannister,low voltage [562],700 transmission control system.

Mar 30, 2013 | 2003 Dodge Durango

1 Answer

Put a K&N Performance Cold Air intake into my 2005 Dodge Neon SXT, 0441 code comes up?


Hi there:
DTC P0441 - Evap. Emission System Incorrect Purge Flow
Possible causes: poor/loose connection, faulty purge control solenoid valve (PCSV), faulty PCM.

Check for loose electrical connector and for loose or broke vacuum hose to it. If ok, you will need a voltmeter and vacuum gauge to test it. If fails test, replace it, if ok, then likely a faulty pcm. Most of the time it is either a bad vacuum hose to it or faulty PCSV.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 21, 2012 | 2005 Dodge Neon SXT

1 Answer

Dodge caliber code p0440 , what is the problem? I already changed gas cap.


Besides the fuel cap these are the things that can cause that code Punctured Evap. Hose , Damged Fuel Tank Sending Unit Seal or Gasket , Damaged Carbon Canister , Defective Vent Valve or Evap. Purege Valve

Jun 21, 2011 | Dodge Caliber Cars & Trucks

1 Answer

I got a 2000 dodge durago and i smell raditor when i am at the light i just got a new one installed is there a problem with my truck


open the hood and inspect for leaks. if you smell it, theres a leak. check radiator hoses,caps on radiator and plastic overflow resevor . a flash light may help find a small leak as the hoses run into dark places. the place that installed the radiator may not have done a good job. the caps should be checked with cold engine and the hoses with hot engine. donot remove caps when HOT. good luck

Apr 18, 2011 | 2000 Dodge Durango

2 Answers

2002 dodge intrepid error code p0344


po344 is camshaft position sensor, try changing the sensor and the problem may go away.

Feb 27, 2010 | 2003 Dodge Intrepid

1 Answer

My 2003 dodge sx2.0 rt car has an engion light on and the code that is comming on in the dash display is p 0441


first inspect all the small vacuum lines connected to the intake manifold. The plastic lines are often the cause for this code, as well as the covered vacuum lines. Also look at the gas cap.is it tightened properly and check the inside seal of the cap is it cracked.if so replace it.

Oct 04, 2009 | 2003 Dodge Neon

4 Answers

Check engine light on dash. replaced gas cap with new one, several trips still light is on. Neighbor use dianostic tool code is P 0441


have a 2003 dakota v6 and was informed by a friend that works at a dealer of issue concernig this . reciently my check engine light came on and was told when codes where checked to look under drivers side of truck along frame to the charcoal box . the center hose that goes into the box has a tendancy to crack at the end going into the box cut about an inch off of the hose if able to do so heat the hose up with a head gun or other means reconect the hose and disconnect the battery for about 10 min for computer to reset and wait if after a week light dosent come on your fixed if it dose your screwed

Sep 02, 2008 | 2003 Dodge Dakota Club Cab

Not finding what you are looking for?
2002 Dodge Durango Logo

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...