Question about 1994 Toyota Land Cruiser

2 Answers

Break lights not working replaced fueses bulbs and break switch on 1997 gxl wagon

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Toyota Master
  • 14,036 Answers

I seen in most cases where the brake light circuit and turn signal or combination switch share the same circuit.if brake lights dont work you have to replace turn signal switch or combination switch.

Posted on May 11, 2010

Testimonial: "thanks heaps"

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.


    An expert who has written 3 tips or uploaded 2 video tips.


    An expert who has written 2 tips or uploaded 1 video tip.

  • Contributor
  • 38 Answers

Go to the trunk
probably the wireing is hurt

Posted on May 12, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Hello, i have a 1997 subaru outback sport wagon and the brake lights do not work. the running tailights work. where do i start if its not the bulbs?

Check fuses and then try the brake light switch on the pedal... it should look like below:

You can unplug the switch and close the circuit of the wiring harness with a little pigtail of scrap wire and if the brake lights then work it's the switch.

best wishes!

Jan 05, 2011 | 1997 Subaru Legacy

2 Answers

Rear brake lights not working

first check your fueses, if thats not it on the slinder part of the arm behind the dash "the break" arm. There is a toggel switch when you push the break the button will release causing the break lights to come on when you let off the breaks it will engage the toggle switch and turn off the break lights....if the toggle switch goes out they wont work also have some one stand behind the car and wiggle the wires of the toggle switch see if it has a bad connection before you replace the switch could be just corresion or the wires may have came loose..

Dec 22, 2010 | 1994 Geo Prizm

1 Answer

How do you replace the bulb on a 1997 Ford club

remove the screws from the lens and pull bulb straight uot towards you, if no screws are present reach behind the light and turn the bulb holder counter clockwise then pull bulb straight out and replace w\ new one

Oct 03, 2009 | 1997 Ford Club Super

1 Answer

Not working

Check the bulbs to see if they're good (rare that both bulbs go at same time). If they're good, check to see if there's power to your sockets.
Under your car on the side of your transmission will be your reverse switch. It will have several wires coming out of it. Most likely the switch has died.

Sep 28, 2009 | 1997 Mercury Sable

2 Answers

I have a 1997 lincoln mark viii lsc has no tail lights no left turn signal, no left brake light. Right turn signal and brake light work fine. New multi-function switch (no fix) bulbs fine. Any ideas would...

inspect all of the sockets that the bulbs plug into. you may have a short in some of them. they can get hot and melt the plastic sockets. causing the bulbs not to work. or try replacing the wiring harness for all the rear lights. i found one in the junkyard for my cougar. and it works fine now, good luck

Mar 09, 2009 | 1997 Lincoln Mark VIII

1 Answer

Break lights not working its not the bulbs or the fuse

If both the bulbs and fuse are good, the most likely problem is the switch mounted at the top of the brake pedal arm.

Jan 02, 2009 | 1997 Lincoln Town Car

Not finding what you are looking for?
1994 Toyota Land Cruiser Logo

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides