Question about 1996 Mitsubishi Galant

1 Answer

The crankshat sensor on this car controls the

I have a 96 mits galan 2.4 liter the car was runing fine but las week it broke down it did'n have spark so i change the distribuitor the *** from the junk yard toll me the maybe the computer . I put the computer and the cae still doesnt star but i also reallize the the injectors dont'n work can someone help me

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,309 Answers

The injectors don't work without spark, keeps from flooding the engine, you have to find out why no spark, so thats fuses, connections, a troubleshooting manual and a volt ohm meter, it could even be the ignition switch, so don't change anymore parts till you know why

Posted on May 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

98 k1500 z71 5.7 liter,idles fine and runes good in neutral but in gear it runes rough and backfires unless gas is pushed to the floor.it also shows a code crankshaft sensor camshaft sensor corilation


Unless you do your own work take to a reputable technician and have them re scan and change required sensor
the forum below may shed some light on your problem
rough idle stalling loss of power

Jan 16, 2016 | Cars & Trucks

1 Answer

I have a 03 mits endevour 3.8litre pwr steering belt broke had both belts replaced tried start the vhicle.cranks but won't start.


Check at the area of where the belt snapped what sensors and plugs and wiring could be affected. Most probably either a broken wire or broken or unplugged any connector.or any sensitive sensor has been damaged.

Mar 03, 2014 | 2002 Kia Sportage

1 Answer

Can a faulty speed sensor in a 96 dodge ram automatic make it only read 1st and 2rd gear


not likely, the speed sensor sends the info to the pcm and will affect gear change, though its highly unlikely that the speed sensor can make the pcm "read" first or second gear, speed sensor sends info to the pcm to help it decide when to shift gears/apply abs/ etc

Mar 30, 2013 | Cars & Trucks

1 Answer

96 dodge caravan went is cold run fine,went get warm tunrn off runing ,start again with problems not run fine


Someone will need to figure out if you are loosing spark to the plugs or fuel to the injectors to proceed.

Sep 02, 2012 | Dodge Caravan Cars & Trucks

1 Answer

I have a 96 ford explorer v6 with a pushrod motor and after we replaced the pushrods, the head gaskets, the valve cover gaskets and the fuses, the car will not idle. what could be the problem?


Have you adjusted the pushrods properly? Pushrods generally need to be adjusted after installation.

Not sure how to do this on this model, although I own a 94 Ford Explorer with the V6 4.0 Liter motor.

Basically, when a gas engine doesn't run, you check 4 things, and narrow it down from there.

1. Gas (Is gas pressure good, is gas flow strong enough?)
2. Spark (are all spark plugs firing properly? Is spark strong enough)
3. Combustion at each cylinder (timing, pushrod adjustment)
4. Air Flow (MAF/MAP sensor working? Air Filter dirty?)

Appliance Repair Utah

Mar 25, 2012 | 1996 Ford Explorer

1 Answer

Have a 2.5 liter and number 2 cylinder exploded. I replaced the entire engine including head, valves, spark plugs and wires. new engine ran a little rough and had a check engine light for a o2 sensor....


check the spark plug wires. go somewhere dark, get a spray bottle with some water in it, then mist the spark plug wire and look for a spark to jump

Sep 06, 2011 | 2000 Jeep Wrangler

1 Answer

Car runs fine for 5 Sec then loses spark thru ASD


The inertia switch is in the rear of the car most times in the trunk area\

Jul 22, 2010 | 1997 Dodge Intrepid

2 Answers

96 Stratus wont restart after it is warmed up, dealership has changed distributor, computer, crank pos sensor, coolant sensor, oxygen sensor


What about the spark control Module? Sometimes when these get hot they either run rough or die and won't restart until it cools down.

Aug 16, 2009 | 1996 Dodge Stratus

Not finding what you are looking for?
1996 Mitsubishi Galant Logo

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...