Question about 2002 Audi A4

Open Question

Rear wiper working non stop

El . suply to the rear wiper motor is on when the swich is off ? what else could be the problem? audi a4 2002 TDi ,130

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: audi a4 wipers havejust stopped working

I have the same problem. Check this out.
http://www.audiworld.com/tech/misc44.shtml
I am working o it

Posted on Aug 12, 2008

bunnydawg
  • 5158 Answers

SOURCE: audi a4 1998 wiper realy

do you mean how... or where is it located.... look under the hood for the fuse panel located there. basically you find the correct relay ... pull it out and replace it. there are more relays under the dash and i've heard the audi's also have them in the trunk.

Robert

Posted on Jan 10, 2009

TLRogue
  • 99 Answers

SOURCE: temperature sensor audi a4

Possibly located at the back of the engine behind cylinder head, usually located in a small plastic hose block.

TL

Posted on Jan 23, 2009

1chris1
  • 72 Answers

SOURCE: audi a3 on a 53 plate rear wiper and washer does

Are all the fuses still ok

Posted on Aug 06, 2009

  • 75 Answers

SOURCE: How can I program key fob for audi a4 quattro 3.0

If you have a owners manual, it should tell you how in it. If you're battery's went dead in the remotes you should be able to program them according to the instructions in your owners manual. I have a 2001 jetta and in order to get a new remote programed I had to go to the dealer.

Posted on Jan 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HELLLPPPP !!!! Audi A4 2003 Wipers don't work because an electrical fault !!! Hello everybody !!!! I have a problem with my wife's car: audi a4 (b6) 2003 1.9 tdi 130 hp, RHD Last week after a...


-You mean There is 12 V at motor terminal when you turn on the switch.
-Okay now disconnect power at motor and hook up voltmeter to motor terminal in Ohm. Any reading...?
-No. motor is bad.
-Yes. The motor is Okay.
-Next check ground terminal from motor to any metal part of the car in Ohm. Any reading?
-No. >>Need to redone ground from motor.

Mai

Aug 09, 2013 | Audi A4 Cars & Trucks

1 Answer

Rear wiper not working no diagram fuse box has only 24 - 30 fuses tried the 15 a but it still didn't work a3 tdi 2ltr sline


contact audi with model number of car check for power at rear motor there might be a wiper relay does rear washer work should be two fuse panel one under the hood as well as one inside

Jun 30, 2012 | 2008 Audi A3 S Line Hatchback

1 Answer

How do I replace the windscreen wiper motor on an audi a4 2.5 tdi


How to change a wiper motor & repair wiper mechanism on 2004 Audi A4 2.5 TDI

First time you must diagnose why windscreen wipers going slow and/or stopping.
In order to find out the cause of wipers stopping you can try follows:

1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!!
2. Disassemble the plastic covers from the bottom of the windscreen.
3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables.
4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi.
5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters.
6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation!
7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works.
Heed of the windscreen !!!
Refit all in reverse order.

Mar 30, 2011 | 2004 Audi A4

2 Answers

I've got an Audi A3, 2004 model..The rear wiper jet is not working. The blade operates and the front wash wipe works, but there's not jet of water from the rear wiper blade, no matter how long you operate...


Hey there

This happened to myself. I have a an Audi A3 2.0 TDI sport (3 door). The problem is a build up of deposits in the nossel jet. This is due to the type of washer fluid you get.

The easiest way to sort it out is to remove the plastic cover surrounding the washer jet (easy to pull off by lifting the sides of it and comes off) and remove the washer jet by simply pulling it off. You can then give it a good clean and use a sewing needle to loosen the dirt. If to dirty and still doesn't work when you put it back on then they only cost £4 from audi.

When its sorted try to buy Audi washer fluid £3.85 for 500ml). This is because its manufactured finer than say if you get it from halfords and this will stop further build ups.

Hope this helps

Martin

Mar 08, 2010 | Audi A3 Cars & Trucks

2 Answers

Rear wiper of Audi A4 avant has stopped working


On Wiper systems the spindle mechanism can sieze up due to water ingress and corrosion.
This deteriates as you describe to the point it will not work, eventualy you may blow the fuse. A good thing as it protects your wiper motor.
New spindle may be reqiured although you may be able to dissmantle it and work some oil into it.

Oct 03, 2009 | 2004 Audi A4

1 Answer

Audi avant estate 1.9 tdi 1996 windscreen wiper control, only fast setting working


First you must diagnose this problem. In order to find out the cause of wipers stopping you can try follows: 1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!! 2. Disassemble the plastic covers from the bottom of the windscreen. 3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables. 4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi. 5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters. 6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation! 7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works. Heed of the windscreen !!! Refit in reverse order. Please Rate my Response! Thanks!

Sep 24, 2009 | 2004 Audi A4

1 Answer

Over heating a4 tdi 130


good chance a stuck closed thermostat not letting the cooling system to work properly

Sep 16, 2009 | 2002 Audi A4

2 Answers

I have an audi a4 2.5 tdi 52 plate 03 reg, the wiper motor has started moving very slowly sometimes stopping {impossible to drive in the rain} is this just the motor needing replaced?


its not the moto!!!its the part were the wiper arms bolt on through the scuttle panel.you have to take it all out and put it in a bench vice and drill a very small hole in the aloy part so you can get some spray in to it!!once it is freed up fill the hole with grease to stop water getting in it.i did the same thing to an audi a6 a few weeks ago.

Feb 02, 2009 | 2002 Audi A4

Not finding what you are looking for?
2002 Audi A4 Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14228 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...