Question about 1986 Nissan 300ZX

1 Answer

Starts idles 25sec stalls changed the front fuel filter and battery would like to know where to proceed next, and is there another fuel filter by tank?could this be the catalytic converter? or do Iproceed to test and pull sensors?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 22 Answers

Do self diagnostic test on ecu .make sure gas comes out of line when you crank it an distributor turns when you turn it over.remove cap .check first. my belt broke an got new engine .i check dist.1st allways .if it doesnt belt broke dont turn over.

Posted on May 17, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1985 Nissan 300ZX I want to disable the fuel pump to relieve the pressure before replacing the fuel filter. Is it a relay or a fuse?


No need to remove any relay. Proceed as follows:
- Park the car in shaded and well ventilated area.
- Remove the negative battery terminal.
- Loosen the fuel cap, fuel filter banjo bolt, push on or pipe clip.
- Wrap a piece of cloth around the connecting end of the pipe and remove the pipe.
CAUTION:
Let the engine cool down about half an hour before you proceed.
Keep your eyes away from the gasoline splash.
Keep any flame away.
Dry up the area immediately.
NOTE:
It is always better to get the job done by a qualified personnel.

Feb 23, 2014 | 1985 Nissan 300ZX

1 Answer

Runs rough dies


change the fuel filter and check the fuel pressure

May 25, 2013 | Ford Expedition Cars & Trucks

2 Answers

2001 Toyota Tacoma keeps stalling on start up.


Check the battery cables. I had the same issues with my 96 tacoma, The battery cable connection at the battery can be cranked down but still be loose. Hard to explain, doesn't make sense, but just check it out.

Jun 23, 2012 | 2001 Toyota Tacoma

2 Answers

My niece has a 98 Exploer that stalls out with no warning while sitting in traffic at lights of stop signs. The temp seems fine , idle seems to be ok. Any help ????


Dirty airfilter ?
Clogged fuel filter ?
Dirty throttle-body ?
Corrosion on battery terminal ?
Loose battery cable on starter selenoid ?
These are the things I'd check first then proceed further.

Apr 04, 2011 | 1998 Ford Explorer

1 Answer

My 1994 mazda 626 starts and ldles but stalls when driving


ENGINE STALL WHILE DRIVING COULD BE STOPPED UP FUEL FILTER OR FAULTY FUEL PUMP.IDLE SPEED TOO LOW.OR IGNITION COIL HAS A LOOSE ELECTRICAL CONNECTION.FAULTY IGNITION MODULE.BAD PLUGS AND WIRES. I WOULD DO A LITTLE TUNE UP.CHANGE FUEL FILTER AND AIR FILTER.IF SPARK PLUGS AND WIRES HAS OVER 30000 MILES ON THEM I WOULD CHANGE THEM.ALSO FUEL FILTER IF OVER 30000 MILES.CHANGE IT CLEAN FUEL INJECTORS. TO TROUBLE SHOOT CAR I WILL DO A LITTLE TUNE UP FIRST TO MAKE EVERYTHING TOP NOTCH ON THE ENGINE BEFORE I GO TO NEXT LEVEL.BUYING NEW PARTS DONT NEED.GET VECHICLE SCANNED WITH A SCANNER. THAT WILL ALSO PIN POINT PROBLEM QUICKLY.BUT DO THE LITTLE TUNE UP FIRST IF EVERYTHING PAST 30000 MILES MARK.SCAN VECHICLE FOR FAULTY IDLE SPEED CODES OR FAULTY IGNITION MODULE CODE THEY WILL COST MORE MONEY TO FIX.PARTS HIGH.

Dec 24, 2010 | 1994 Mazda 626

3 Answers

IS THERE AWAY TO BYPASS THE FUEL FILTER SO THE CAR WILL RUN UNTIL WE CAN GET A NEW ONE. THE CAR WILL NOT STAY RUNNING. HAVE TO HAVE YOUR FOOT ON THE GAS TO START ONCE YOU REMOVE YOUR FOOT FROM THE GAS...


Are you sure that bypassing the fuel filter will solve that problem? I would not recommending doing so. If you bypass the filter then any trash coming in through the fuel will clog the injection ports. And then the car will absolutely not run. Cleaning injection ports are mighty expensive. If you suspect trash coming into the fuel, purchase a few fuel filters... about three. They are not expensive and are realitively easy to replace. If a new fuel filter helps the car run, then great! Just replace it again when the car starts stalling. Eventually, all trash from the fuel will be filtered out.

However, I do not think that a simple filter would effect the idling of the car. The idle can be adjusted, though I do not know how on your specific car. Also, you may have a faulty throttle position sensor.

Dec 26, 2009 | 1993 Buick Park Avenue

2 Answers

1994 GMC JImmy 4.3 V6 running very roughly


try idle speed control motor/throttlebody posistion sensor.

Jul 05, 2009 | 1994 GMC Jimmy

2 Answers

Engine runs very sluggish at start up


Change fuel filterS...plural
Don't forget the big canister unit under (next to wheel well)

Dec 17, 2008 | 1995 Buick Park Avenue

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...