Question about 1999 Ford F150 Regular Cab

Open Question

Wont start batt good need to replace starter?

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: 88 mustang wont start, was running, replaced

did you try the ignition coil or try the fuel cut off switch in the trunk on the left side if the red button poped push it back in

Posted on Oct 11, 2009

  • 159 Answers

SOURCE: coil pacl replaced, new batt, new spark plugs. no fuel pressure, compression is good. wont start, ether does not start truck

No fuel pressure? could be a bad fuel pump, or clogged filter!

Posted on Mar 26, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1994 Nissan pickup 2400 2.4L manual trans I can push start but wont start by key replaced starter and starter relay get clicking sound out of starter relay but will not turn over


Check all connections and cables for corrosion. Make sure there is a good engine to chassis ground. You are loosing connection somewhere.

Dec 20, 2016 | Nissan Cars & Trucks

1 Answer

Starter wont turn engine over


Why did you change the starter in the first place? The battery need a full charge for the starter to operate properly, Need year make and model for more help. If the starter is grinding now and wasn't prior to replacement, it may have to be shimmed or the starter could be defective.

Jun 20, 2015 | Cars & Trucks

1 Answer

BATTERY SHOWS 12.84 VOLTS BUT WONT START UNLESS JUMPED METER SHOWS 14.2VOLT WITH ENGINE RUNNING


Hi,
First thing to do is clean both battery connections.Fords are really bad for the battery connections corroding. When this happens you can get a good volt reading but not be getting enough amps. Next is to disconnect clean and reattach the electrical connections at the starter. Also check along the wires going from the battery to the starter to make sure the insulation has not been damaged. It is unlikely but possible that a critter or road debris damaged the insulation and caused one of the wires to corrode. The starter is the heaviest draw on the battery so physical damage to the electrical system will show up here first. If everything else checks out you will want to have the starter checked. If you are capable of removing it most major auto parts stores can bench test them.
Hope this is helpful to you. Good Luck!

Jun 02, 2014 | 2004 Mercury Grand Marquis

2 Answers

06 pontiac grand prix wont start no clicking when you turn the key over even jump starting the battery, has dash lights & radio & parking lights. battery tested good. put a used starter & altinator on


Used parts such as starters and altinators don't last. It might **** but it sounds like you need to buy a new starter,altinator, and battery. Or just start with buying one at a time.

Dec 06, 2011 | 2006 Pontiac Grand Prix

2 Answers

98 chevy g3500, where is the ignition modual, how do i test it?


your first mistake was buying a reman starter from autozone ....go to napa, oreilly, or anywhere but autozone to buy reman starters
alternators etc ....autozone parts are junk ...
get a new starter motor and replace the autozone one ....

Aug 08, 2009 | 1998 Chevrolet Express

1 Answer

Car wont turn over,tested the starter,replaced the starter relay,new batt cables and batt,still wont turn over


Try the ignition switch (the actual part with the keys). You can actually try starting the car without using the keys. You can do this by hot wiring.

Jul 19, 2009 | 2000 Dodge Neon

1 Answer

New starter good batt. only clicks wont turn over 1995 montero


The Batt does not have a full charge or it is the wrong cranking AMP's for the car... find out if it is the right Batt and also that it is put on a "slow charge" over night or at least 6 hr's

Jan 20, 2009 | 1995 Mitsubishi Montero

Not finding what you are looking for?
1999 Ford F150 Regular Cab Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...