Question about 1986 Nissan Pickup 4WD 1986

1 Answer

1986 Nissan Pickup

It is stuck in gear but gear shift seems to be in the neutral position. HELP...

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 438 Answers

Shift fork may also be one of the reason! watch the shift fork while moving the clutch in and out.
1)The shift fork is near the clutch master cylinder on the tranmission housing. you should now move the fork left and right while the clutch is moved in and out. 2)From your query, it sounds to me that your clutch is not engaging and disengaging completely. 3) This is due to the air block. Make a bleeding process to blow the air out! 4)A broken shift fork will also prohibit the clutch from engaging/disengaging.

Posted on May 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gear shifter cable


sounds like a stretched gear shift cable or the linkage on the tranny may need some adjusting i would start with the linkage first jack vehicle up and do a visual while some one goes through the gears make sure to use jack stands so that the power wheels are off the ground.....good luck

Nov 09, 2013 | Nissan 200SX Cars & Trucks

1 Answer

1997 nissan pickup won't shift. It is stuck in fourth gear


Usually I find one of three problems that cause a manual transmission to be stuck in a single gear. If the gear oil level is low then the shift forks and rails can get dry and bind enough that the rail sticks and won't move. The same low fluid problem can cause the sliding gear to become stuck hard enough on the splined shaft it slides on that it won't move or the shift interlock parts between the shift rails [which prevent two gears from being engaged at once] can break or bind which will also prevent the shift lever from moving. The shift lever and tower [the part the lever is fastened to on top of the transmission] may have to be removed to see if the problem can be fixed from the top or if the problem is internal and the transmission has to be taken apart and repaired. There are other problems that cans cause this such as bad internal bearings, broken or worn shift forks but they are fairly rare if the oil level is maintained and changed occasionally.

Jun 25, 2010 | 1997 Nissan Pickup

1 Answer

How does the 4wd work


if the car has 4wd and considering the age it should have a lever sort of like the one for your transmission gears. you would have 2 low on top, then 2 high. then N for neutral, then 4 low and 4 high at the bottom. but you must turn your hubs which i believe are manual in that truck so you must get out of the truck and manually turn them to the "lock" position. you cannot throw in your 4wd while driving even if your hubs are turned. it will damage your transmission. park it change it then go and idt it will let you go but so fast. i think below 60mph

Feb 21, 2010 | 1986 Nissan Pickup 4WD 1986

1 Answer

I have a 1993 Nissan Pickup Se king cab 4x4. I


hi
if you think the four wheel drive it not being use it very likely that the link that engages the four wheel it rusty or the gear shift inside the gear box will not slide by some wearing abstraction caused by wear and tear

Dec 21, 2017 | 1993 Nissan Pickup

1 Answer

STUCK IN ITS SECOND GEAR.JUMP OUT OF ITS THIRD GEAR.4 SPEED .1400


Usually when a manual shift transmission starts jumping out of gear it's because the synchronizers are worn. The transmission will more than likely have to be repaired and or rebulit by a reputable transmission shop.

Aug 20, 2009 | 1986 Nissan Pickup 4WD 1986

1 Answer

1986.5 NISSAN 4X4 TRANNY HUNG IN REVERSE


Most likely an internal gearbox problem, but I would first check the shift linkage at the gearbox end, see if you can disconnect it and change out of reverse from there.

Jun 17, 2009 | 1986 Nissan Pickup 4WD 1986

1 Answer

Transfer gear case shift jammed


There are four probable causes when the gear is stuck in one position, and they are precisely explained in this handy diagnostic article that I know will help narrow down the culprit of your difficulty:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Transmission_System_Stuck_In_One_Gear.htm

Good luck!
Brad

May 26, 2009 | 1986 Suzuki Samurai

2 Answers

My 2003 Mercury Mountaineer Gear Shift is stuck.


THERE IS A SENSOR ON THE BRAKE PEDAL THAT RELEASES THE THE SHIFTER.THERE A 3 COMPONENTS INVOLVED.U CAN PUT IT IN NEUTRAL BEFORE U START THE CAR.THEN WIL SHIFT.

May 01, 2009 | 2004 Mercury Mountaineer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

342 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...