Question about 1991 Plymouth Voyager

1 Answer

My tranny shifts 1-2-3 tnen back down to 1. now it only stays in first. park, neu, rev, are ok

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Plymouth Master
  • 1,619 Answers

Do a fluid flush and a filter change. if that doesnt work have service done, which may lead to a replacement depending on internal damage.

Posted on May 09, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

98 fi50 4r70w when hot and shift from park to drive-no engagement-if shift from park to drive and back to rev will engage ok


Sounds as though pump inside of tranny is going bad. When hot, fluid loses viscosity and pump may not be able to move it without the shifting dance you've been going through. A Chiltons/Haynes repair manual has an excellent troubleshooting section that covers these kinds of issues.

May 02, 2017 | Cars & Trucks

1 Answer

01 sunfire GT, 2.4L, AT, tranny can shift into reverse, but only from Park works, when i shift into reverse from neutral, the engine would rev up, but the car is in still. Changed tranny fluid, same p


check fuses.
connect any scan tool see if there ARE DTCs (errors) set for a/t
then get the cable adjusted. to spec.

if there are DTC, see how to diagnose each in the FSM. book.
each error is covered.

what works and does not post all./
P
R
N
D
L.
all fails some work ?

Jun 25, 2014 | 2001 Pontiac Sunfire

1 Answer

When driving the truck tends to rev way higher than normal, when you are at a stop and then try to go depending on how hard you hit the gas it will bog down almost dying, or die. also when you are driving...


sounds like your torque converter going bad. change the tranny fluid, and look for metal shavings (have a pro do this), sometimes you can squeeze enough life out of a bad tranny/torque converter by changing the fluid, or it might just be a clogged tranny filter. change the fluid, and if theres metal shavings in it, sell it while it still runs.

Mar 26, 2011 | 1993 Chevrolet K1500

1 Answer

I have a 1989 325ix - automatic. When parking the


sounds like loose linkages in the shift lever .try this first. much cheaper than new tranny.....

Feb 11, 2010 | BMW 325 Cars & Trucks

1 Answer

Trans makes rattleing noise when its in any gear rev. and drive ,it quits whe put back in park or neu


It sounds like the trany is on it's way out. It might be the torque converter. At any rate the trany will probably have to come out. Does the trany seem to work good, shifts good, no slipping? There is another posibility it could be a loose heat shield on the exhaust pipe rattling. Have some one you can trust check it out.

Dec 15, 2009 | 2004 Dodge Stratus

4 Answers

98 Plymouth Voyager Transmission won't go or stay in drive


I got the exact same problem as mike d ready.
i have replaced the 2 tranny sensors over the years. yjey can cause the same symptoms. but the sensor problems came on all at once.
bad shops tell many dodge van owners irs te tranny and its really just the sensers.

Jan 06, 2009 | 1998 Plymouth Voyager

1 Answer

Transmission pops out of gear


Sounds like your tranny guy just did a bad job, the tranny needs to come out and be inspected internally. I bet the guy has a lock pin in wrong, or not at all.

Nov 28, 2008 | 1998 Chevrolet Cavalier

1 Answer

1991 Honda Accord tranny not shifting..


the first thing that needs to be checked is the fluid level. it may have a leak and has now gotten too low to move car. check the trans oil dipstick with vehicle running in park on flat ground. if it is low, top it off with dex lll trans oil and see if it moves better. if restored to normal shifting, ck for leakage. dont fix the leak first without checking for normal shifting down the road, you could be wasting time and money if any damage has occurred.

Nov 15, 2008 | 1991 Honda Accord

Not finding what you are looking for?
1991 Plymouth Voyager Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...