Question about 2006 Ford Freestyle

Open Question

Rear wiper motor on 2006 ford freestyle intermittently stops mid way & won't start again. How can I check motor before replacing it?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
johnny5846
  • 379 Answers

SOURCE: 2003 Ford Explorer-Rear Wiper Motor-How to Replace?

the plastic panel pops off , if you had a trim removal tool it would be nice but it can be improvised , they are just tension clips , get some kind of lever behind the panel and give it a pop , once the plastic panel is off its pretty much self explanatory from there , a connector and couple small bolts , now the outside has nut under the w/w blade , a piece of the arm cover pops up to access the nut , remove w/w arm , then a grommet and under the grommet is a bigger nut that helps hold the motor onto the door/hatch , when reinstalling before you put the w/w arm back on run the wiper and make sure it shuts off and in the park position . should be a piece of cake .

Posted on Jan 05, 2009

Ad
  • 2 Answers

SOURCE: rear wiper stopped working

my 2004 expedition had same problem, if you take apart the shaft that goes thru the glass it will be full of dirt, clean ,lubricate and reinstall, you may have to replace the O-ring on the shaft. a 20 minute job, very easy fix

Posted on Mar 09, 2009

  • 653 Answers

SOURCE: 2006 Ford Escape rear window wiper has only a 10'' wiper blade

Check the clearance of the wiper blade from the edge of the glass at the top of it's sweep. If you have over an extra inch of glass, you can go with a 2 inch longer blade (one inch above the pivot point and one inch below). If you have over 2 inches, go with a 4 inch longer, etc...

Posted on Apr 04, 2009

  • 4369 Answers

SOURCE: Front Windsheild Wipers

I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield s7w~us~en~file=adobe.gif~gen~ref.gif Printable View (104 KB) Removal

  1. Remove the windshield wiper arms.
  1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
    Remove the pushpin-type retainers and the cowl panel grille.
  1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.
  1. If equipped, remove the A/C air inlet filter.
  1. Remove the 9 cowl panel bolts and position aside the cowl panel.
  1. Disconnect the windshield wiper motor electrical connector.
  1. Remove the cowl panel from the vehicle.
  1. Remove the 4 bolts and the windshield wiper motor.
    s7w~us~en~file=n0001518.gif~gen~ref.gif
Installation
  1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
    • Tighten to 15 Nm (11 lb-ft).
  1. Install the 3 windshield wiper-to-cowl panel bolts.
    • Tighten to 15 Nm (11 lb-ft).
  1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.
  1. Install the washer hose and grommet in the cowl panel.
  1. Install the 9 cowl panel bolts.
    • Tighten to 6 Nm (53 lb-in).
  1. If equipped, install the A/C air inlet filter.
  1. Position the cowl panel grille in the vehicle and connect the washer hose.
  1. Install the pushpins.
  1. Install the windshield arms and nuts.
    • Tighten to 27 Nm (20 lb-ft).
  1. Cycle and park the windshield wipers to check for correct alignment.
3c6f4d5.gif
b8a2ebf.gif

Posted on Apr 10, 2009

  • 4340 Answers

SOURCE: need to replace rear wiper blade on a 2006 ford

These days the entire blade and holder assembly is replaced, not just the blade. The holder separates from the arm.

Posted on Nov 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hav n trouble with my intermittent wipers on 1977 ford pu.Work ok first 5 min then they wont go off.Can you help?


No intermittent wipers- wipers will not park after using washer ...

www.ford-trucks.com > ... > 1987 - 1996 F150 & Larger F-Series Trucks
Oct 22, 2006 - I have been having trouble with my intermittent wiper feature and the windshield washer feature and parking of the wipers. For the last two ... Wipers won't turn off......sometimes!
Feb 3, 2014
Intermittent wipers?? (question)
Oct 5, 2011
Intermittent wiper switch
Feb 16, 2010
Intermittent wiper governor bad, need help
Oct 11, 2008
More results from www.ford-trucks.com

Ford Truck Intermittent Wiper Failure

www.misterfixit.com/nowiper.htm
It was a dark and stormy night . . . . actually it was. I had been experiencing someproblems with the intermittent wipers on my '88 F 150 the past week and that ...

Ford Wiper Switch ' eBay


Dec 08, 2015 | Ford Cars & Trucks

2 Answers

Ihave a 2003 Ford Explorer & the windshield wipers won't stop working, with the switch turned off or even removed. The only way to stop them is to remove the battery cable.


Sounds like the park switch in the wiper motor is bad.Some manufacturers allwo you to change the circuit board seperately from the motor,sometimes they have to be changed as a unit

Dec 06, 2012 | Ford Explorer Cars & Trucks

1 Answer

During a recent snowstorm, the weight of the snow was apparently too much for the rear wiper. It stopped mid-stream and is stuck. Simultaneously, the intermittent function of the front wipers also quit. ...


Check fuse no. 11 (10A) in the driver's under dash fuse/relay box. I suspect it is blown. It provides power for the rear wiper, both washers, and the intermittent wiper function for front and rear. It probably blew when your rear wiper got stuck.

Jan 31, 2011 | 2003 Honda Odyssey

1 Answer

I have a 2006 Ford Freestyle & the driver side blows cold air but the passenger side & rear does not. When the car is idling it starts to blow warm air. I have the a/c set on 60 degrees but it is...


Have the orphis tube filter checked, Its inline and requires a shop to do it, But if its clogged this means the compressor is failing and will contaminate the whole system if not repaired

Jun 12, 2010 | 2006 Ford Freestyle

1 Answer

1997 expedition, rear wiper motor does not run...trying to find wiring diagram of wiring to rear motor, specifically if there is a connector somewhere up under the headliner toward the back of the car that...


There could be a number of issues to look at. Does the motor work or is it a broken wireor is the fuse blown or bad ground to wiper motor. Check fuses first if O.K. go to the rear door panel & access the motor. Once there check the ground connection & make sure motor is well grounded. Turn motor switch on & using a probe tester check to see if power is getting to motor. If it is not, go to the wiring harness flex point between door & frame & pry back outer covering to reveal the wires. Check for a broken wire.If you have power & ground is good Take motor off & check motor on the bench using A 12 volt power scource. If it does not work replace motor. If this advice helps please fell free to recommend accordingly. Thanks!

Nov 18, 2009 | 1997 Ford Expedition

2 Answers

Hi, I'm having issues with the wiper & washer switch on my truck (C2500), 88,000. miles. Would the column switch be the first item to suspect without performing any electrical tests or would there be...


wiper motor it self going replace the motor [napa $45]you will be asked for the color of your connector at the motor its either gray or black

Oct 01, 2009 | 1998 Chevrolet C2500

1 Answer

Windshield wipers intermittent on 2002 Windstar


2002 Windstar wipers would come on by themselves, or not work set on intermittent, driver door lock would not work sometimes, ABS and brake light would come on sometimes, the problem was in the park switch inside the wiper motor. I replaced with wrecking yard wiper motor $44.95 w/13 month warranty. no more problem. check how many pins on connector plug, mine had 5 on the wiper motor side.Take the wiper assembly off of the metal cowl, 2 nuts, & I bolt, it is easier to snap the actuator pieces off of the wiper motor that way. God Bless JMR

Mar 22, 2009 | 2002 Ford Windstar Cargo

2 Answers

Rear wiper stopped working


my 2004 expedition had same problem, if you take apart the shaft that goes thru the glass it will be full of dirt, clean ,lubricate and reinstall, you may have to replace the O-ring on the shaft. a 20 minute job, very easy fix

Feb 25, 2009 | 2004 Ford Expedition

2 Answers

Wipers don't work


My 2005 Ford FreeStyle (AWD) Front wipers quit working...don't even hear a sound of the motor attempting to operate...wiper washer/sprayer operates fine. Rear wiper system operates.
What is wrong? Do I need replace the wiper motor? If so,how? Thanx

Jan 21, 2009 | 2005 Ford Freestyle

Not finding what you are looking for?
2006 Ford Freestyle Logo

Related Topics:

779 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...