Question about 1999 Nissan Quest

1 Answer

Missfire cyclinder 3 , I have replaced plugs, plug wire,rotary button, distributer cap, still has slight miss and same code missfire cyl. 3 1999 quest van ? 73,000 miles

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 14,036 Answers

COULD BE DIRTY FUEL INJECTOR OR INTAKE MANIFOLD VACUUM LEAK AT NUMBER 3 CYLINDER.

Posted on May 09, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Circuit codes p0300


that pertains to random secondary ignition missfire.possibbly another code to help pinpoint which cyl. is missfireing po304 #4 cyl. spark plug,boot/wire coil/or individual coil pack,ignition module.check in that order.need more info year,vin,etc.

Aug 25, 2014 | Cars & Trucks

2 Answers

Check engine light flashing runs rough not firing on all cylinder2000 lincoln navigator with large triton engine Hooked up diagnnostic and it said 1. system too lean bank #2 2. Unable to bleed up fuel tank...


you may try your rotor button and distributor cap. and spark plug wires. try your map sensor also they tend to cause a lot of misfiring if they go bad.hope this helps.

Apr 20, 2010 | Lincoln Navigator Cars & Trucks

2 Answers

Misfires #2, replaced plug, wire but still


4 or 6 cyl. ? Check compression, prolly and injector issue. Is the plug wet or dry when you take it out?

Apr 17, 2010 | 2002 Chevrolet S-10

2 Answers

I have 1999 318 4x4 dakota with fault coads


These are misfire codes.This means that your vehicle is missing.The 300 is a random misfire and the 305 is for cylinder 5,and the 306 is for cylinder number 6.Check the plugs if they are good then you could have bad coils.They are top of the plugs.Hope this helps.Good luck.

Feb 25, 2010 | 1999 Dodge Dakota

1 Answer

2007 toyota camry multiple cylinder missfire


maybe several things the timing is off or plugs fowled out needs distribuitor cap rotary cap rotary button plug wires stock tune up stuff or computer

Feb 10, 2010 | 2007 Toyota Camry

1 Answer

Hi all, my 99 sub.350,300k,missfire #2


Have you checked the distr cap for cracks??

If plug is oily looking on brand new plug I would suspect worn rings, which would also explain the high PSI. (Motor job in the wind) Especially for 300K.



Dec 03, 2009 | 1999 GMC Suburban

1 Answer

Have fault code P0302 on 2001 VW Beetle. No it is Cylinder 2 misfire. What is likely cause, bad spark plug, wire, or Electronic ignition box?


this car has what is called coil over ignition which means no plug wires or cap so if it is missing swap coil from cyl 2 and any other cyl then clear code and rerun car till light comes back on then check code if it is still cyl 2 missfire then replace that plug if code changes to the cylinder that 2's coil was on then replace that coil <that car does have a recall for coils> if car is not missing and you have that code most likely isnt an ignition problem but will have a small vaccume leak so check the small hoses for leaks. very common for fuel preasure regulater vaccume hose to brake from age

Mar 21, 2009 | 2001 Volkswagen Beetle

1 Answer

Cylinder 5 missfire 1999 tahoe


How is the pressure in the fuel rail? a low pressure will cause erratic firing of the injectors - the further down the rail u get usually the worse the problem. If the fuel filter was not changed regularly or if the vehicle stood for a while, dirty fuel/standing fuel at some time in the recent past, this **** will accumulate in tyhe injectors. To avoid spending a loada cash, swap a few injectors around and see if the problem moves with the injector.

Jan 07, 2009 | 2004 Chevrolet Tahoe

Not finding what you are looking for?
1999 Nissan Quest Logo

Related Topics:

238 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...