Question about 2006 Hummer H3

Open Question

On my 2006 Hummer H3 the light on climate control

On my 2006 Hummer H3, the light on climate control knob does not light.How do I access the bulb for fixing?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 2006 H3 Hummer AC/Heater Fan Motor

I brought my 2006 H3 in to the dealer for the same thing. My blower stopped working all together but it started as an intermittent problem. He said he had to replaced a diode or resistor either behind the switch on the dash that controls the fan or on the fan motor itself. Have not had a problem since but that was only about 4 months ago.

Posted on Apr 09, 2009

Ad
  • 3 Answers

SOURCE: How do i access the bulb behind the climate

There is one bulb (for all three knobs) behind the center knob. Turn the knob to the straight up and down 12 o'clock position and pull the knob straight out. Wrap a soft cloth around the jaws of a pliers, that works the best. Pull the bulb out with a needle nose wrapped with a rubber band. The bulb is a sylvania 2721, available at most auto parts stores. You can also use a small piece of vacuum tubing to pull the bulb out. (pull straight out, don't twist it)

Posted on Mar 08, 2010

  • 1 Answer

SOURCE: 2006 H3 Hummer fan problem

Hi if your internal fan not work in any position well i fixed up myself easy and save your money.
locate the fan motor air just outside right courtesy drawn document in front of passenger. go from down and look up you will see a motor with a big connector white with 2 screw secure inside the motor block. loose the two screws and pull out gently the connector from motor fan block. you will see a green multiresistor connected with this big connector. Usually the first + voltage connector is burnet out. disconnect the connector pull from resistor and check for any burn. in my case the first pin was burned out completely
you can buy another connector or you can clean the burned connector take out form connector weld a small copper cable of 5 mm dia from resistor to the burn cable and reconnect the connector without buy a new one. after replace again the resistor in the hole of motor blow with the 2 screw.
Done all work again without buy another new connector.
Gabriel from Italy Turin
H3 hummer 2007
loveling one and Humvee owner

Posted on Jun 11, 2010

melvi_99
  • 387 Answers

SOURCE: how much will it cost to fix cylinder 2 misfire?

i don't know how match the cost, but it will he you, first change the position of the ignition coil to another coil also the spark plug, read the misfire code is it P032 or replace the code, if on cylinder 2 again appear the misfire check the compression, if ok go to electrical and check wires go and from to cylinder two coil to pcm, check the ground on #2 coil, if all this ok, see the difference reading by multi tester to coil reference if all good, reprogram your pcm, or replace if necessary

Posted on Aug 06, 2010

  • 1 Answer

SOURCE: how to replace h3 hummer climate control light

how do I replace lights in climate controls they went out?

Posted on Oct 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my 2007 h3 the control knob for the defroster face or feet does not light up how do I fix


Try hitting the knob fiirst. If that doesn't work remove the panel in front of the cliamte control knobs (just pops off with some pulling pressure) and then remove the screws that hold the knobs. After that remove the back cover and replace the bulbs. Look at e-bay item number 2**********3 for replecment bulbs. You can replace the unit, but they're pricey at about $175 on e-bay,

Dec 30, 2014 | 2007 Hummer H3

1 Answer

Brake lights do not work.


Are the brake lights the ONLY lights that do not work? Does the third (high mount) brake light work when you apply the brake pedal?
The Hummer H3 is basically a Chevy Trailblazer in Hummer clothing.. so the first place to look is the brake light fuse. If it is good, then check for power at the brake light switch mounted near the top of the brake pedal pivot area. Also be sure that the bulbs themselves are OK.

Jul 11, 2013 | 2006 Hummer H3

1 Answer

Hummer h3 rear brake light does not work


Check that the bulb is not blown and needs replacing

Dec 27, 2012 | 2006 Hummer H3

1 Answer

How do I replace the light in the dash for the heating knob ( vent, defroster, etc)


The tiny incandescent light bulb is behind the knob soldered to the circuit board, you must remove the climate control head unit and take it apart to access the knobs back light bulb on the circuit board. You can buy the replacement bulb at Radio Shack, the part number is 7219 Micro Lamp.

Dec 05, 2011 | 2006 Chevrolet Equinox

2 Answers

2006 hummer h3 climate control fan stopped. Suspect fuse #82 in fuse pannel. Is the Trailer B+ fuse the same fuse in spot 84? If so can I remove fuse from spot 84 and put in spot 82 to test if it is a...


Look at the color and Number on it If both fuses have the same amp rating you can swap them to test. If they are different amps you could just blow the fuse again if its a lower amp rating, or damage your Climate Control system if the fuse has a higher amp rating than the original. By the way, all the GM vehicles I've owned had several spare fuses in side the fuse panel.

Feb 07, 2011 | 2006 Hummer H3

1 Answer

2006 hummer h3 replace burnt out left trun signal bulb


if it's the rear light, open the back door all the way and look where it hinges. There are two phillps screws in there that you remove and then go out side the door and gently pull streight back on the light assy to remove it

Nov 20, 2010 | 2006 Hummer H3

3 Answers

My h3 hummer has some kind of problem with the signal rear lights and the break rear light i check the fuse and that not the problem whatg to do now???


my h3 hummer runing light on trailer do not work i have no power at the plug the turn & stop lights work

Apr 23, 2010 | 2006 Hummer H3

1 Answer

The light is out behind one of the heater control knobs


Happened to me....That is all one assembly called the hvac control modulator i believe....unfortunately it is a part that costs around $400 to replace...Not sure why they didnt make it accessible to just change a bulb

Oct 20, 2009 | 2006 Hummer H3

1 Answer

How to replace h3 hummer climate control light


how do I replace lights in climate controls they went out?

Sep 24, 2009 | 2006 Hummer H3

Not finding what you are looking for?
2006 Hummer H3 Logo

Related Topics:

689 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...