Question about 2003 Chevrolet Impala

1 Answer

How do I change front blinker bulb on 2003 chev impala

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 652 Answers

First,

  1. Turn the engine off and open the hood. Pry up the two fasteners from the radiator air baffle with a flat head screwdriver. Move the baffle to the side to access the top of the headlight case.
  2. Step 2 Pull up the two metal rods behind the headlight case. These secure the case to the car. You may need your pliers to pull them up.
  3. Step 3 Gently pull the headlight case out to access its rear. On the rear, you will find several black dust covers. Twist off the dust cover closest to the fender (the outward dust cover) to access the turn signal bulb.
  4. Step 4 Turn the bulb module counterclockwise to release it. Unplug the electrical connector from the bulb module. Connect the new bulb to the electrical connector (don't touch the glass with your hands; hold it by the plastic piece). Insert the bulb module in the turn signal housing, turn it clockwise and screw the dust cover back on.
  5. Step 5 Insert the headlight case in the mount. Push the pins back down to secure it. Position the radiator baffle in its place and insert the fasteners.
  6. Rear Turn Signal Bulbs
  7. Step 1 Open the trunk. Remove the net from the side mounted wing nut (on the side with the faulty turn signal). Twist the wing nuts (there are two per side) counterclockwise to remove them.
  8. Step 2 Peel the carpet layer back to access the rear signal lamp wing nuts. Twist these wing nuts (two per side) counterclockwise to remove them and release the rear signal.
  9. Step 3 Carefully pull the rear signal assembly away from the Impala. The rear turn signal is the inner bulb (closest to the trunk). Press the tab on the bulb module and turn it counterclockwise to release it from the rear signal assembly.
  10. Step 4 Pull the old bulb straight off the module (don't twist). Insert the new bulb in the module. Depress the tab on the connection and insert the module back in the assembly. Twist it clockwise.
  11. Step 5 Insert the rear signal assembly. Re-attach the assembly's wing nuts and push the carpet layer back in place. Tighten the other two wing nuts to secure the carpet layer and reconnect the cargo net

Posted on May 09, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Right blinker double time,side bulb out, Back right blinker burns but doesn't blink..replaced both front bulbs, still blinking double on front and not at all on back...suggestions?


Hey, just a thought, but a friend of mine had similar prob. She drives a ram pickup, and the front turn signals have two turn signal bulbs and they are front bulbs not side. Go out and look at the side that works and then look again at the other side.

Apr 02, 2016 | 2010 Chevrolet Chevrolet Impala LS

1 Answer

Dash and radio lights don't work at night. They are on during the day. 2003 Chev Impala. Have checked all the fuses.


The same thing happens on my 2003 Impala. I found that my dimmer switch has an intermittent failure where sometimes the dash lights go out even with the headlights on.
If I wiggle the dimmer just right, the dash, radio, steering wheel, door locks, and every other light comes on (when the headlights are on). My fix was to mount my Garmin on the steering column in front of the speedometer so when the lights go out I know how fast I'm going. A replacement dimmer (or bypassing the current one and adding a resistor) should take care of it.

Jan 11, 2013 | 2003 Chevrolet Impala

1 Answer

Passenger side front blinker dim and blinks fast


I would change out the dim bulb. usually blinkers blink when you have a bulb out either in the back or front blinker.if both are good then I would replace the flasher.

Jan 09, 2012 | 2003 Chevrolet TrailBlazer

1 Answer

How to install front turn signal 2004 Chevy Impala


Once you open your hood look on the back of the headlight assembly. Twist the connector on the back of the turn signal and the bulb will come out. Then just replace with the correct bulb twist it back in and then test the blinker.

Apr 27, 2010 | 2002 Chevrolet Impala

1 Answer

Need to replace turn signal switch,2003 chev impala


You only need to disconnect negative battery cable to make it safe to work on.

Mar 16, 2010 | 2003 Chevrolet Impala

3 Answers

1999 Chev 2500HD - Blinkers only blink when brake applied


the cause of this is the turn signal switch, there are numerous posts about this problem.

Jul 05, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

2003 chev. impala have a gas filter


Yes, this vehicle has a fuel filter and, its located Under vehicle, passenger side, mounted on frame, just in front of the fuel tank.

Please rate and have a great day:)

Apr 24, 2009 | 2003 Chevrolet Impala

1 Answer

Rear blinker bulb


at the very rear ... it would be changed from within the trunk... the side bulb would be changed from inside the trunk or underneath behind the sheet metal

Robert

Jan 22, 2009 | 2003 Ford Mustang

2 Answers

When lights are on. Right blinker stays on sollid.


you need to change the bulb in either the front or back on the side thats not working

Jan 11, 2009 | 2002 Chevrolet Impala

Not finding what you are looking for?
2003 Chevrolet Impala Logo

316 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...