Question about 1996 Geo Tracker 2 Door

1 Answer

Getting diagnostic code P1408 on 1996 geo tracker .How to fix it.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 145 Answers


Posted on Aug 17, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Geo tracker wont start will ignition module help

still bad?
ask for help ,
we have all data on GEOs.

did you check for spark first on all 4 cylinders>?

the ignitor model never fails, 1 in a million
on the 91 ( i have one)
INSERT the diagnostic jumper
crank the engine or 5 second,the flash code will tell you
bad CMP or bad spark if the ignitor is dead, the ECU sees that
and reports that.

the jumper is here. full docs

Suzuki (it really one)
move the jumper every few years, to keep us intertwined.
all jumpers are here.
yours is next to front battery.

Jun 30, 2014 | 1991 Geo Tracker

1 Answer

Code 21 tps high voltage on a '95 geo tracker, how 2 fix?

Usually the problem is a faulty TPS, the sensor is out of adjustment, or there is a problem with the wiring harness. The sensor should read less than one volt with the throttle plate closed.

Jul 14, 2013 | 1995 Geo Tracker

1 Answer

Engine light on and I do not know how to bring up the engine codes on my 1995 geo tracker how do you bring up the engine codes?

You would need to have a scanning tool connected to the diagnostic port of the car. Some shops would let your borrow theirs. The tools should then bring up the error codes.

Aug 04, 2011 | 1995 Geo Tracker

1 Answer

I have a 1994 Geo tracker its a soft top and the zipper for the rear window is broken need to get it fixed its going to rain

use safty pin's till you can get fixed. May have to take to upolstery shop. good luck and seed some rain to arkansas,

Mar 23, 2011 | 1991 Geo Tracker

1 Answer

How do I obtain and read the error codes on a 1991 Geo Tracker?

You must use a short jumper wire to ground the white diagnostic connector. This terminal is part of the Assembly Line Diagnostic Link (ALDL), located under the dash near the ECM. This is under the passenger side glove box behind the kick panel.

To activate the diagnostic codes, jump terminals 1 and 3 (the two outer terminals of the white connector). Then turn the ignition switch to on (engine not running). The check engine light will flash a code of 12 three times and then display the stored trouble codes.

To clear the codes, remove the ECM fuse for at least 10 seconds.

Mar 07, 2011 | 1991 Geo Tracker

1 Answer

95 geo tracker, radio locked

get cpy of your title, remove radio, call dealer, and they give u unlock code for free

May 14, 2010 | 1995 Geo Tracker

2 Answers

1995 Geo tracker Stereo Unlock Code

You must bring the the car to a geo/chevy dealer so they can reset the radio to factory unlock. It might be cheeper to have a new cd radio installed best by is a good place for around $200 a radio can be purched and installed .

May 23, 2009 | 1995 Geo Tracker

1 Answer

96 Geo Tracker Belt Removal Problem

it has more than one bolt.
loosen them all.

May 08, 2009 | 1996 Geo Tracker 2 Door

1 Answer

Timming is off

its on my page


how to time cam, distributor , and fix it.

Apr 01, 2009 | 1995 Geo Tracker

3 Answers

Geo TRacker aut trans doesn't shift from 1st

100 parts in a tranny.
bad governor unit in tail shaft.
low oil pressure.

see my tranny page.

Feb 02, 2009 | 1993 Nissan Sentra 4 Door

Not finding what you are looking for?
1996 Geo Tracker 2 Door Logo

Related Topics:

335 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides