Question about 1990 Buick LeSabre

1 Answer

My cruse control just cuts out, if I creep back to the speed it was set, sometimes it rein-gauges.There is nothing consistent with when it cut out.

Posted by on

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

My cruise stopped working when my TPS went bad. I replaced it now works great

Posted on May 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need back speakers to go plugs been cut on radio


Car stereo speakers usually consist of 4 sets of colors one solid and one with a stripe in each set. The solid would be positive while the stripe would be negative. Easy way to figure out what wires goes where is connect one set and use the balance/fade control on stereo to determine the speakers position. Hopefully this helps . Good Luck

May 04, 2017 | Cars & Trucks

1 Answer

Cruse control don't working. Change on off control and checked cruse control cut off switch which is good. Not sure what else to test.


Check that the brake light is functioning correctly. If the speed control is receiving that the brake pedal is depressed it will not engage.


Hope this helps?

Oct 31, 2016 | Cars & Trucks

1 Answer

Cruse drops out


does ur speedometer read when it goes out? if so replace speed sensor

May 16, 2014 | 1998 Buick Century

2 Answers

1991 legacy overheating, temp gauge creeps up close to red zone but not all the way, but not losing any fluid, and nothing is broken. Temp gauge drops to near normal when I run heater on high while...


If the temp is high at freeway speeds then the thermostat would be suspect. If the temp is high in slow traffic then suspect the cooling fans or its controls

Aug 17, 2011 | 1991 Subaru Legacy

1 Answer

VW jetta 2003


speed sensor may be faulty! & interfeering with the cruise control

Aug 15, 2009 | 1999 Volkswagen Jetta

1 Answer

Speedometer not working


Does it hang out at 18-20MPH, regardless of your speed?
Mine did the same thing. The problem was an open circuit inside the gauge itself, and there's no repair for the parts. You'll need to get a replacement speedometer gauge, or simply buy a replacement instrument cluster.


If it's not doing the "20mph" thing, then it's possible that you just need a new engine speed sensor. This is located on the rear of the engine block, and is hard but not impossible to reach and replace.

One way to test is to set the car on cruise control when the speedometer is working. If the speedometer cuts out ,but the cruise is still able to maintain your speed, then the sensor is OK and the problem is the gauge. If the cruise control also cuts out, then the sensor is bad.



May 03, 2009 | 1996 Honda Accord

1 Answer

Cannot find cruise control


hi there
you will find a switch some where near the dash light dimmer switch that will say off and on
what you need to do
  1. have the car going in a forward moton and doing 40kph or more
  2. when you have reached the desired speed that you wish to set you need to turn the cruse control on then at the strearing wheel you will see a button saying "set"
  3. once the light on the dash bord has come on then you can take your foot off and it should remain at the speed you set it at.
now some tips and did you know
  1. when you have set a speed you can increase it by pressing the plus or minus button to either increase or decreas your speed and it will automatically remember it
  2. when you want to over take and you have your cruse set at a speen you can use the exelaretor to go faster and once you have passed you can press resume to go back to the speed you where doing before you applyed more power
  3. did you know cruse control is more economical then usng the exelarator it can save you fuel.
  4. do not use cruse control in wet weather as it can cause a skid if you hit a p[uddle of water laying on the road
  5. to stop the cruse form working just put your foot on the break

hope this helps
ricko

Dec 29, 2008 | 2001 Jaguar S-Type

1 Answer

2001 Oldsmobile Silhouette surging


Seems like an idle speed control to me.

Dec 19, 2008 | 2001 Oldsmobile Silhouette

Not finding what you are looking for?
1990 Buick LeSabre Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...