Question about 2000 Jeep Grand Cherokee

1 Answer

Blinkers stopped working and the emergency flashers don't work - is this a fuse problem??

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 775 Answers

Do the bulbs illuminate? If so, it's the flasher unit. If not, then it may be a fuse. Although most vehicles have fuses for left and right. It's also remotely possible all 4 bulbs burnt out at the same time. There are fuses in the passenger compartment as well as under the hood.

Posted on May 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a diagram for how to find the flasher in a 1999 dodge stratus..it's not in the fuse boxes


Simple method without mystery:
  1. Turn blinker flashers on;
  2. Listen for clicking;
  3. Find source of clicking. It is the flasher. :)
NOTE: Emergency flashers and blinkers usually use a separate flasher unit, but one is close to the other. If your blinkers do not work but your emergency flashers do, find the emergency flasher unit by finding the source of clicking, then locate the blinker flasher nearby. They will ALWAYS be underneath the dashboard on the driver side.

May 11, 2015 | 1999 Dodge Stratus

1 Answer

1998 dodge durango, when I turn the key on, or to the lock position, the flasher fuse relay on the driver side makes a loud buzzing sound. I replaced the fuse relay and checked all the fuses. Any ideas on...


IM NOT SURE.
BUT fix the emergency flasher failure
first using the logic, gee you see its busted,why on fix that and pray.
military doctrine does that too, and then says if 2 things wrong fix the simple one first. (getting lucky save time and dead solders)
10x that if related, and is. ! IMO
noise here,and bad emerg.. kind if same area.
the issue with the emerg. flasher is the contacts can mangle inside
and confuse related circuits. flashers, and warning modules.

Jan 19, 2015 | 1998 Dodge Durango

1 Answer

1970 beetle how to fix flashers


1. Do your emergency flashers work?
Check all your fuses, make sure they are getting a good contact.
If your emergency flashers work, it may be a faulty turn signal switch.
If your emergency flashers work that will eliminate the flasher. The one flasher works both turn and emergency signals.

Jul 05, 2014 | Volkswagen Beetle Cars & Trucks

2 Answers

Blinker lights not working on my dodge ram 1500 1996. Emergency lights work fine and fuse isn't the problem. No arrows turn on when turning the blinkers on but the emergency lights are working fine. Can...


I bet your blinker flasher is not working. Most likely it uses two flashers, my Intrepid did. Somewhere (probably near the fuse box) and likely under the dash you will see a board with relays and stuff plugged in. You will also see two round things, those are most likely the flashers. Swap them if they are the same, then your hazard lights won't but your blinkers will, at least until you get to the store to get a replacement.

Oct 21, 2013 | Cars & Trucks

1 Answer

Blinker, cruise issues...electrical?


The problem is caused by the emergency flasher unit. This is a common problem and you can find a few youtube demos on replacing it. I did it in about 30 mins. I don't remember the cost but it was stocked at my local chevy dealership.
good luck.

Feb 10, 2012 | 2002 Chevrolet Impala

2 Answers

Turning signals not working all the time


Sounds like the blinker relay. Is the emergency flasher switch on the dash above the radio ? If it is the blinkers relay is the same as the emergency relay. If the blinkers stop working pound on the emergency lights switch and if they start working then replace the emergency lights relay switch cause the blinkers is on the same relay as the emergency lights. My 2001 Grand Am does the same and I just hit the emergency lights switch and they start working again.

May 27, 2010 | 2001 Pontiac Sunfire

1 Answer

Blinker dont work flasher and other lights work


The turn signals don't work, but the emergency flashers do? If that's the case, replace the flasher, you have 2 flashers, one for emergency (hazard) flasher, and one for the turn signals. It should be on the fuse block under the dash.

Oct 23, 2008 | 1995 Jeep Cherokee

3 Answers

Blinkers stopped working


Your F--150 has 2 flashers, emergency and turn signal. Both are mounted on the fuse block under the dash. The turn signal flasher is mounted on the front of the fuse panel, the emergency flasher is mounted on the rear of the fuse panel. so replace the turn signal flasher should solve the problem. Let me know how it goes.

Oct 20, 2008 | 1996 Ford F150 Regular Cab

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...