Question about 2002 Isuzu Rodeo Sport

1 Answer

2002 Isuzu Wizard V6 Petrol engine. Went to start it and it turned over and went to fire up but then just cut out. Tried it again and it started fine?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 19,396 Answers

Hi.

A failed start can happen for a number of reasons. If this happened just once, it should not be reason for concern.

If the problem happens again, the first test you can do to locate the problem is an OBDII code scanning.

The scan can be done at any local garage. If you purchase a scanner like the ones linked below you can read the codes by yourself.

OBD-II-Scan/dp/B001LHVOVK

OBD2-Trouble-Code-Reader-Scanner

The connector is located under the dash.

Once you have the codes you can get back to us for an explanation. Here you can also find basic info on OBD codes.

If the problem happens regularly, then other test that must be done is checking fuel and vacuum pressure using a Vacuum and Fuel Pump Tester. This is a gauge that must be placed in between the lines to read pressure.
By reading fuel pressure it is possible to spot problems caused by blockage, fuel pump malfunction and problems with fuel pump aeration.
By reading pressure on vacuum lines whilst heating the lines with an hand torch (this must be done by a mechanic), you can find vacuum leaks.

Engine shut down can be caused by a number of reasons. Among possible causes misfire, rich or lean mixture, air intake blockage, MAF or AIT sensor problem, fuel circulation problem, vacuum problem, fuel tank cap not allowing air in, electronic injection problems.

If you get the problem again, read codes and replace spark plugs, air filter and fuel filter.

Regards.

Posted on May 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Isuzu Wizard V6 Petrol


Could be crankshaft sensor,What year mileage,could be bad sensor which is in hub bearing.

Jun 18, 2013 | Cars & Trucks

1 Answer

My isuzu is 1998 bighorn.the problem is check engine light come on aand engine stops.i have to start it again


i had a similar problem with my pt cruiser, check the battery terminals sometimes its just a bad connection, you may need to buy new terminals, only ten dollars maybe

Jun 15, 2012 | 1998 Isuzu Trooper

1 Answer

Engine will not start after changing battery in 2004 Isuzu Rodeo


Get yourself a can of starting fluid spray, and spray NO MORE than a two second burst into the air intake after removing the filter. Then crank it. If it fires (very briefly), your problem is low or no fuel delivery to the engine.

May 16, 2017 | 2004 Isuzu Rodeo

1 Answer

Intermittent starting problem landrover freelander 01 v6 2.5 mode


Hi,
Judging by the problem you have a 1.8 petrol engine?,if it is they used to over fuel on start up ,you can try changing the engine coolant temp sensor as this is the usual cause ,if not then some more info on the vehicle would be usefull.

Jul 12, 2009 | 2002 Land Rover Freelander

2 Answers

Engine runs wild with white smoke


If its a 4JX engine then its injectors and seals at fault dont run it any more cos it may blow up - like rods through the side !
The diesel is going straight into the engine without being injected and as the fuel lift pump is mechanical it wont stop on the key .
Should be under isuzu warranty though they are doin that repair on 1998 Troopers over here for free .

Apr 04, 2009 | 2002 Isuzu Trooper

2 Answers

I have a 1990 holden(isuzu)rodeo 2.8 pertol.Ihave just put some fuel in the thing and about 1 minute down the road experinced some missfiring.this went on for about another 30 seconds and the engine just...


I have a 1996 holden rodeo 2.6 petrol, it misses badly on accelleration, I have replaced plugs, leads, distributor cap, and run injector cleaner through... it idles ok,,,,

Sep 06, 2008 | 1994 Isuzu Rodeo

1 Answer

Check Engine light


It sound like you are having a electrical problem.You need to check your electrical/ignition system,not all electrical problem the diagnostic machine can read.

Aug 22, 2008 | 1999 Saab 9-5

Not finding what you are looking for?
2002 Isuzu Rodeo Sport Logo

564 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...