Question about 2005 Hummer H2

3 Answers

How do you replace the module and wiper motor?

How do you replace the module and wiper motor on Hummer H2? where is it located? Is there a HOW TO Video?

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

The wiper motor is located under the hood cowl. Open your hood, pop off to the 2 decorative plastic covers at the corner of the hood/windshield and you should see a phillips head screw to remove on each side. After removing them, slide back the safety latch on the wiper arms and remove them from the gear. At this point, you should be able to pop off the cowl, as there will be 4 total pops holding it in place. Carefully slide it out around the wiper gears and lay in engine area, as if you move too far you will rip out washer pump hose. There are (3) 10mm bolts to remove to take out wiper arms/gears, 2 on the sides, 1 in the middle. After disconnecting the module plug, you can remove the apparatus so that you can access the #35 Torx screws and 13mm nut to remove the defective wiper motor. Install the new motor in the same fashion as removing it, and then follow the entire process in reverse to put everything back together.

Posted on Dec 02, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,489 Answers

The module and wiper motor should be on the firewall, driver's side, under the hood. The module is the very front of the motor and is held on by 3 torx head screws. The module can be purchased seperately through cardone for around $35 - 50. I assuming the wipers just go off without being turned on? Common issue for GM products. Let me know what else you need.

Posted on May 09, 2010

  • barbara_a61 Jan 06, 2011

    So the guy's original question had to do with the motor as well. No mention here how to replace that and where to purchase and how much. This question was half answered.

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Had the same issue, although my washer motor wouldn't stop, removed the module, cleaned the circuit board with contact cleaner, blew dry low heat, made sure there was no corrosion between the items on the board, (there WAS corrosion shorting out the pieces on the board), greased the seal, replaced, works fine.

Posted on Dec 29, 2012

  • GARY BRONNE Dec 29, 2012

    Had the same issue, although my washer motor wouldn't stop, removed the module, cleaned the circuit board with contact cleaner, blew dry low heat, made sure there was no corrosion between the items on the board, (there WAS corrosion shorting out the pieces on the board), greased the seal, replaced, works fine.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 hummer h2 my front wipers starts working by its self when i turn my car on


The window wipers on your 2003forehead H2 is a factory recall for the control module

Aug 06, 2012 | 2003 Hummer H2

1 Answer

2005 h2 wipers run all the time


There was a recall on the suv`s but I`m not sure the h2`s were included.The fix was the replacement of the wiper motor module which is on the motor.All you have to do is remove the cover on the wiper motor and the module is there.Just unplug it and pry it out with a small screw driver.You can get a module from the dealership parts department.Just follow the directions.Hope this helps.Good luck.

Mar 23, 2010 | 2005 Hummer H2

1 Answer

Wippers stay on while driving stop and start and stay on in off position 2003H2


there is a faulty wiper module at the wiper motor itself. go to the dealer and they sell a complete kit to replace the old one. cheers.

Dec 24, 2009 | 2004 Hummer H2

1 Answer

My 2004 hummer h2 windshield wipers activate on their own and cant be stopped.


this is in the wiper control module. the dealer sells replacement kits with new boards and the cover. not too expensive. common problem.

Nov 05, 2009 | 2003 Hummer H2

1 Answer

I have a 2004 h2 hummer and my wipers and sprayer


they have a controll module afixed to the wiper motor itself. these modules have been an issue for gm for some time. they are very simple to replace and "usually" fix the issue.

Oct 25, 2009 | 2005 Hummer H2

2 Answers

Windshield wipers wont shut off


small plastic cam in colum atached to switch . stick a screwdriver in thier and flip it the oly way it will go. or u could just replace the switch. u might just have a short to. do they keep running with the car off

Aug 15, 2009 | 2003 Hummer H2

2 Answers

The power battery light stay on when I turn off the engine off


I had the same problem, Youl need to do one of the following, Change the eginition module or change the driver side control pannael the one for the window/locks (if you can crank the key a bit when its turned off it may help sometimes) sometimes a bit of rain comes in the window and down into the control (locks/window switch) and shorts it out. Trust me I spent time and money to figure out its that or your egnition module. EBAY for the parts it will only cost $100

Mar 31, 2009 | 2004 Hummer H2

1 Answer

My front wipers are not woking on my H2


There are fuses located on thedrivers side when you open the front door. There is a panel that pops off near the door pillar. The fuse diagram is loacted on the panel. Secondly there are fuses located under the hood. There is a black plastic fuse box, with fuses and relays. also there was a recall for the wiper motor on some of the H2. I hope this helps.

Mar 28, 2009 | 2003 Hummer H2

2 Answers

Hummer H2 rear wiper and sprayer came on by itself


It sounds like the wiper control module. The wipers on my 2003 did the same thing. After I pulled the fuse for the rear wiper, the front wipers started acting up as well. I had to pull fuses to stop them too. There is a recall on 2003 H2's for this issue. The cover of the wiper module on 2003s for the allows rain/water to get into the module. The cover will be replaced for free, however, in my case since the module was full of water and my wipers were not working, they replaced the module for free also. Not sure how much it would cost to replace on a 2005.

Dec 21, 2008 | 2005 Hummer H2

1 Answer

2003 HUMMER H2


Had the same problem. i have to re-place my front wiper motor they are all connected.

Dec 08, 2008 | 2003 Hummer H2

Not finding what you are looking for?
2005 Hummer H2 Logo

2,943 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...