Question about 1990 Nissan 300ZX

2 Answers

Why am i getting fuel in the oil in my 1990 nissan 4 cyl?

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 117 Answers

Leaking intake manifold gasket.

Posted on May 07, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

1990 nissan 300zx twin turbo was running fine,left town for about 8 mos.while i was gone i had it parked at my girlfriends house and i asked her to start it and spin it around every now and then.she let it sit for about 2 mos.and then the battery was dead.she jumped it and ran it for a little bit.the following week she tried to start it again and dead again.jumps it again,runs it but then disconnects the battery.she runs it a couple more times and says that it need a tune up.well wen i got home i connected the battery and it fired up on the first shot.i drove it and it ran like ****.went to the shop,pulled the plugs,cleaned them,then put them back in.on the way home,it still was driving like it was fouled and i made a stop at the store.when i came out,then car was dead.now i'm pretty sure that my alternator needs to be tested,but then tow it to the house,charge the battery all night,try agin inth emorning and no nada.still won't turn over.i can hear the pump, i have checked the fuel control module,i just replaced it,got a new pressure regulator and dampner when i got the module.also battery.i also looked at the crank angle sensor and it seems to be fine.do you think it might have jumped time?i can not hear a difference in the engine sound when i crank it.thanks for your time.

Posted on Mar 14, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4 cyl. has water in oil has been running good, wouldn't heat thought thermostat, pulled dipstick,milky, pulled plugs normal, do not smell antifreeze in exhaust ??


You will need to remove the cyl head and check for corrosion and/or cyl head gasket. Best is to take the cyl head to a reputable machine shop for testing and service.

Jan 11, 2016 | 1990 Nissan Hardbody King Cab

1 Answer

What different years of computers will work in my truck 1990 nissan hardbody


Well it depends.
Engine size, transmission type, and 2 or 4 wheel drive makes a difference.
So a 4 cyl will not work on a V6 and so on.
Some will work on 1990 and 1991, others have to be the same year as your truck.

Feb 11, 2013 | Cars & Trucks

1 Answer

I have a 1991 Nissan King Cab with a faulty starter. I also have a 1990 Nissan D21 starter that does work. Is there any way that I can use the 1990 starter in the 1991? I know that they obviously look


The 4 cyl starter for manual trans and automatic trans are different so I doubt you could interchange them.
You would have to measure the travel distance for the bendix gear and the mounting holes, plus the diameter of the nose to be sure.

Aug 12, 2012 | Nissan King Cab Cars & Trucks

2 Answers

TRYING TO FIND ENGINE SIZE ON 1990 NISSAN PATHFINDER SE 6 CLY 4 WHEEL DRIVE


either VG30E 3.0 litre 153 HP V6 or KA24E 2.4 litre 140 HP 4cyl

Jun 14, 2010 | 1990 Nissan Pathfinder

1 Answer

I have a 1990 4 cyl jeep wrangler i just filled tank with gas drove 1 block and jeep stalled. Jeep starts right back up but will not stay running seems as though its not getting enough gas. Is this a fuel...


if you just filled up i might be dirty fuel go get some fuel injector cleaner stp is good, lucas is better dump in your tank and cross your fingers you might have to start up a couple times.

May 15, 2010 | 1990 Jeep Wrangler

2 Answers

Gas gauge in the dash malfunctioning - 1990 Nissan Hardbody truck


It sounds like the float on the sending unit is sinking. Don't know what the float is made of, but over time, it will soak up gas and start to get heavy. This would cause your problem. I don't think it's the gauge, but if you want to test it, disconnect the wires at the tank. The gauge will either go to full or empty. If you ground the sending wire, the gauge should respond the opposite way it was. good luck

Feb 12, 2010 | 1991 Nissan Pickup

1 Answer

I have a 1.8 n13 sohc pulsar that will not start. It has spark and fuel but compression seems low. Cyl 1 - 100psi, cyl 2 - 80psi, cyl 3 - 100psi and cyl 4 - 70psi. I would like to know what acceptable...


It might have a damaged valves caused by slipped timing belt making the piston and valves banged each other. That is why the compressions are low. Big job.

Jun 16, 2009 | 1990 Nissan Pulsar

1 Answer

On the 1990 ford tempo wont come out of first gear while driving, had work done on outboard drive after it busted up.


problem one adust the safety netural switch to allow itto start without having to push up, Problem 1990 ford the shat bentthe shift linkage, Problem three this is the Nissan section not ford and chevy.

Jun 03, 2009 | 1995 Nissan Pickup

1 Answer

Car off rd for 1yr. when i picked car up drove it ran rough on like 6 out of 8 cyl 1990 cad deville, mech. checked every thing said posibly fuel injectors at cyl 2and 4, car runs rough, miss or stalls new...


did you use the gas that was in the tank? when gas sits for that long the oil and water separate. this is the most common reason that cars run like **** after sitting for so long. you may want to siphon the old gas out and put new in.

Apr 24, 2009 | 1990 Cadillac Deville

Not finding what you are looking for?
1990 Nissan 300ZX Logo

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...