Question about 2001 Nissan Sentra

Open Question

Nissan Sentra 2001 - Swirl Control valve issue?

On occasion (more and more frequent) nothing happens when I press on the gas pedal while driving (RPM doesn’t increase, it actually starts going down when this occurs). Usually happens in 3rd gear (I think always), lasts a couple of seconds, pressing on the gas pedal a couple of times and things are back to normal; acceleration is very slow after this occurs. Im getting error codes P1130 and P1156.

I thought it was the gas pump, changed that, no go.
Took it to the dealer, they said it was the ECU...bought 2 used ones with the exact PART# (23710-5M105) so I know they were the good ones...no go


I thought it was the gas pump, changed that, no go.
Took it to the dealer, they said it was the ECU...bought 2 used ones with the exact PART# (23710-5M105) so I know they were the good ones...no go.

PLease help!

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2002 Nissan Altima 2.5S wierd problem starting it up.

try putting the car in neutral then starting...a bad park switch on the altimas.

Posted on Dec 16, 2008

co7196
  • 3433 Answers

SOURCE: im putting in a new ecu my old 1 has these numbers

May be totally off in settings..

Posted on Jun 11, 2009

  • 149 Answers

SOURCE: Nissan Sentra random stalls and wont start hot

Check out the catalytic converter, might be plugged up. I have seen some cars that will run fine, and like someone threw a switch the car acted like yours, no power, would not rev and died. Later when cold they would be OK for a while then just get worse and worse.

Posted on Jul 03, 2009

  • 312 Answers

SOURCE: Pls where is Swirl Control Solenoid Valve located in Infiniti QX4

This link shows the location of the SCV, If your motor is different the location should be similiar. http://img510.imageshack.us/img510/5687/vacuumdiagramuh3.jpg

There's a vaccuum line that runs off the SCV to the SCV check switch.

P0442: Have you inspected the lines, charcoal cannister etc? Make sure the fuel cap is tight. The easiest way to check the system is to have someone perform a smoke test. I had a DTC on my car which indicated a EVAP problem, it turned out to be the Fuel tank evaporator Control Solenoid.

Posted on Sep 22, 2009

  • 1 Answer

SOURCE: My 1996 nissan truck has a p1130 code where and

The part is actually power acuator valve and its mounts onto the intake maniflold part number is 14517-86G01.

Posted on Feb 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do i get a swirl valve on 2004 nissan sentra 1.8 litter i cant find a swirl valve online or dealer?????????????


the 2004 sentra
correct not listed as
Swirl control valve position sensor online
none on ebay etc
if no other nissan vehicle part listing
to suit the sentra

possibly discontinued part
might need to source a used one from a wrecker

P1137 2004 Nissan Sentra Description Swirl control valve position sensor is installed on the intake manifold.
The sensor is connected to the front end of the valve shaft of the swirl control valve.
The sensor responds to the valve shaft movement. This sensor is a kind of potentiometer which transforms the swirl control valve position into output voltage, and emits the voltage signal to the Engine Control Module (ECM).

Read more: http://www.autocodes.com/p1137_2004_nissan_sentra.html4bf6e106-b12c-4708-a0aa-a43a76b546c2.png26336927-ejqivawmtgcmwob5fqfu0osj-1-2.jpg

Nov 01, 2016 | Nissan Cars & Trucks

1 Answer

My 94 nissan sentra doesn't run smooth over 3000 rpm or if you mash the gas pedal


I have a 2000 Chevy Tahoe that did the same thing. I changed the oil pump, new oil, and head gasket. It now has power and doesn't fall on its face when I step into the throttle hard. Hope this helps.

Apr 21, 2014 | 1994 Nissan Sentra 4-Door

1 Answer

I HAVE A QX4 2000 MODEL.WHAT IS THE MEANING OF P1130 SWIRL CONT SOL/V ;AND P0443?


According to Nissan, each cylinder has a valve in the intake manifold to control the air volume in the intake. The code is for one of the swirl control valve solenoids.
Code 443 is for the EVAP canister purge volume control solenoid which is a part the computer uses to vent the gas tank.
I would recommend a shop for both codes.

Jul 05, 2012 | Cars & Trucks

2 Answers

What is a p1138 code for a nissan sentra 2005? i searched on the net it says switch control valve? what is this?


COMPONENT DESCRIPTION
Swirl Control Valve
Swirl control valve consists of actuator and valve. The valve is
installed in the intake manifold, and the actuator is connected to the
rear end of the valve shaft.
The swirl control valve uses a step motor which has four winding
phases. It operates according to the output pulse signal of the ECM.
Two windings are turned ON and OFF in sequence. Each time an
ON pulse is issued, the valve opens or closes. When no change in
the control position is needed, the ECM does not issue the pulse signal.
A certain voltage signal is issued so that the valve remains at
that particular opening.

Dec 01, 2009 | 2005 Nissan Sentra

1 Answer

2006 Nissan Sentra Special Edition Start Up Problem


Odd that the owner manual mentions the issue - seems that they are aware of it. Given that car is most likely fuel injected it's generally bad to pump the gas pedal as this floods a fuel injected vehicle (works for older carburated vehicles) I'm assuming you are just barely putting pressure on the pedal. This may be as simple as an idle adjust at the throttle body or it may require programming by the dealer. I'd search and see if there is a recall for this. This may be an issue the dealer is obligated to fix at no cost since it's listed in the manual...

Aug 06, 2009 | 2006 Nissan Sentra

1 Answer

Nissan Sentra random stalls and wont start hot


Check out the catalytic converter, might be plugged up. I have seen some cars that will run fine, and like someone threw a switch the car acted like yours, no power, would not rev and died. Later when cold they would be OK for a while then just get worse and worse.

Jul 03, 2009 | 2001 Nissan Sentra

1 Answer

MY CAR..


That is a swirl control valve code. The swirl control valve is on the intake manifold and unfortunately the only way to get the valve is to replace the entire intake assembly, it is not available seperately @ this time. You will have to purchase this and the gasket from you Nissan dealer. Hope this helps.

Aug 08, 2008 | 2004 Nissan Sentra

1 Answer

Service engine soon light


Thisi s a problem my daughter had on her 2003 nissan and it was under a voluntary recall so if you bring it to dealer and tell them they have to replace swirl Valve free. It regulates the fuel. I have a 2005 nissan that had other engine codes and I have asked them to check swirl valve but I am getting run around from my dealer. Get it done at dealer asap or it can cause other problems with fuel system.

Jun 11, 2008 | 2005 Nissan Sentra

Not finding what you are looking for?
2001 Nissan Sentra Logo

Related Topics:

444 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...