Question about 1995 Ford Bronco

Open Question

1995 Bronco: ABS light on 95 Ford Bronco 4x4 5.8L stays on. All...

Abs light on 95 Ford Bronco 4x4 5.8L stays on. All sensors and module have been changed but light remains on

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chiquititas
  • 1010 Answers

SOURCE: abs light on

I'm a Ford service adviser. There are many reasons for the
abs warning indicator to come on. The usual cause is from a
faulty speed sensor. Either a wheel speed sensor or the
differential speed sensor. I don't think the light is related to your vandalism. You might want to take the truck to an auto parts store and have them read the codes for you. Most auto parts stores will do this for free.
Good Luck

Posted on Jun 23, 2008

  • 1214 Answers

SOURCE: 2002 Dodge Ram 2500 4x4 Brake & ABS lights stay on

I would still be suspect of the ABS module. Had the same thing happen on an 01 Tahoe.

Search the web for an ABS repair facility located in Russia, IA. They repair the module for $150.00 and give a 5 year warranty, which you can't get from the factory.
And, their website has troubleshooting guides to help you determine if for certain the module is bad or has a probelm.

You can remove the module and continue to drive the vehicle. Their turn around is as they state, and once I had them make the repiars, my Tahoe has been up and running great!

Posted on Jan 25, 2009

chrischronic
  • 235 Answers

SOURCE: ABS Light / Sensor on 1996 Ford Explorer

the rear one is a single sensor and is located in the top of the rear differential , unplug it and take the retaining bolt out and it pops straight up out of the differential. the front has 1 for each wheel,and is located on the backside of the wheel hub. take the tire off and look on back side of hub it should be the only sensor thare and is anchored with one bolt then just fallow the wire to its disconnect point. this vehicle is known to have problems with the rear sensor so i would replace it first and see if this fixes the problem

Posted on Feb 02, 2009

warlock61
  • 659 Answers

SOURCE: abs warning light on 02 ford escape

check the abs rings on the axles they have a tendency to crack and will set a light. does the vehicle have remote start? Is it an aftermarket system?

Posted on Mar 01, 2009

  • 239 Answers

SOURCE: where exactly is the abs sensor located on my 99 dodge 1500 4x4?

there is a abs sensor in each wheel well on the end of the axle by the brakes.

hope this helped.
please remember to rate me.

Posted on Mar 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 saab 9000 abs light stays on


could be bad sensors replace,there are in hub bearings.

Mar 02, 2013 | Cars & Trucks

1 Answer

2005 ford explorer ABS and AdvanceTrac warning light stay on


There could be many issues with this light on, only a professional scan tool or the FORD dealer has an OBD scanner that can talk to the ABS module. From a look at some common problems, people have changed the front wheel speed sensors to fix this problem.

Jan 16, 2013 | Ford Cars & Trucks

1 Answer

I have a 1992 ford bronco, which is equipped with ARB air lockers. However I think air lockers are to blame for rear ABS sensor getting chewed up. Is there anything out there to buy that can bypass abs...


I don't know if you have a wiring diagram

I had a 1992 dakota & just unplugged the
abs module under the dash,as in those days,
a 4x4 only had rear abs function

I doubt the abs on a 1992 has anything to do with the
trans
If you also have big tires,that could be the reason your
shift strategy if off.

Need to see a wiring diagram & figure out what you have
Sorry,not familiar with the 92 Bronco,I did have a nice 79
big one

Jun 02, 2012 | 1992 Ford Bronco

1 Answer

Abs sensor


Whenever the ABS light remains on it means that the control module of the system has detected a problem in one of the systems components and it has turned off the ABS brake control, what you must do now is have the system system scanned for fault codes with a special tool.

Jan 27, 2012 | 1991 Honda Accord

1 Answer

95 ford bronco check engine light was bliking and autozone told me to change gas cap now the light stays on


Try using an OBD tool to erase d malfunction light if the gas cap was the problem the light should go off, if it doesn't u need to scan the vehicle to know what is really wrong

Sep 07, 2011 | 1995 Ford Bronco

1 Answer

95 ford bronco 5,8 abs light on code 3 can any one tell me what it is, thanks


CODE 3 IS G SWITCH NOT PROCESSABLE.THIS IS REFERRING TO ACCELERATION G SWITCH.THE G ACELERATION SWITCH IS MALFUNCTION ITS NOT MONITORING VECHICLE WHEEL DECELERATION RATES.

Jul 10, 2010 | 1995 Ford Bronco

1 Answer

Abs light is on and the speedomter jumps


Check the vehicle speed sensor at the transmission.

Jun 18, 2010 | 1995 Ford Bronco

1 Answer

I CAN'T FIND WHERE THE 93 FORD BRONCO SENSOR MODULE FOR THE SPEED OMITOR IS LOCATED AT CAN YOU HELP ME


there are two sensor's you need to look for. one goes in to the transfer case, other is in the rear diff on top. it also sends back information to the abs system and have been told if it is not working correctly that the speed omitor one may not work as well.

May 15, 2010 | 1993 Ford Bronco

1 Answer

I changed the vss and the 4wabs sensers and the wires are good but my speedometer is still jumpy and my abs does not work on my 95 ford bronco but i dont have any codes that i am aware of is it possiable a...


on my 94 i didnt have codes either,but the electric motor failed on the abs due to moisture.the speedometer on mine jumps too,but mine with 220,000 miles it was the gauge cluster,couldnt tell if i was driving 5 miles per hour too slow or too fast.the cruise may be the clock spring behind the steering wheel,but most of the time the horn wouldnt work or the air bag light would be on and beeping

Jan 22, 2010 | 1995 Ford Bronco

1 Answer

Abs on ford explorer


Firstly, I would suggest you to clean Your ABS Wheel Sensor
Here is a link for instructions on how to do that:

http://autorepair.about.com/od/regularmaintenance/ss/abs_sens_cln.htm

If this doesn't correct your problem, it may be a fault in the ABS control module. Or a bad sensor.

Also
Check the ABS sensors at the wheels. Make sure that the plastic
harness isn't cracked or broken thus making the ABS idiot light come on

Jan 20, 2009 | 1991 Ford F150

Not finding what you are looking for?
1995 Ford Bronco Logo

Related Topics:

778 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5481 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...